Risk of virus transmission through femoral head allografts: A Belgian appraisal

Cyclic Stability of Locking Plate Augmented with Intramedullary Polymethyl Methacrylate (PMMA) Strut Fixation for Osteoporotic Humeral Fractures: A Biomechanical Study

The locking plate may provide improved fixation in osteoporotic bone; however, it has been reported to fail due to varus collapse or screw perforation of the articular surface, especially in osteoporotic bone with medial cortex comminution. Using bone graft as an intramedullary strut together with plate fixation may result in a stronger construct. However, the drawbacks of bone grafts include limited supply, high cost, and infection risk. PMMA (so-called bone cement) has been widely used for implant fixation due to its good mechanical properties, fabricability, and biocompatibility. The risk of donor-site infection and the drawbacks of allografting may be overcome by considering PMMA struts as alternatives to fibular grafts for humeral intramedullary grafting surgeries. However, the potential effects of intramedullary PMMA strut on the dynamic behaviour of osteoporotic humerus fractures remain unclear. This study aimed to investigate the influence of an intramedullary PMMA strut on the stability of unstable proximal humeral fractures in an osteoporotic synthetic model. Two fixation techniques, a locking plate alone (non-strut group) and the same fixation augmented with an intramedullary PMMA strut (with-strut group), were cyclically tested in 20 artificial humeral models. Axially cyclic testing was performed to 450 N for 10,000 cycles, intercyclic motion, cumulated fragment migration, and residual deformation of the constructs were determined at periodic cyclic intervals, and the groups were compared. Results showed that adding an intramedullary PMMA strut could decrease 1.6 times intercyclic motion, 2 times cumulated fracture gap migration, and 1.8 times residual deformation from non-strut fixation. During cycling, neither screw pull-out, cut-through, nor implant failure was observed in the strut-augmented group. We concluded that the plate-strut mechanism could enhance the cyclic stability of the fixation and minimize the residual displacement of the fragment in treating osteoporotic proximal humeral unstable fractures. The PMMA strut has the potential to substitute donor bone and serve as an intramedullary support when used in combination with locking plate fixation. The intramedullary support with bone cement can be considered a solution in the treatment of osteoporotic proximal humeral fractures, especially when there is medial comminution.

The use of allograft tendons in primary ACL reconstruction

PURPOSE

Graft choice in primary anterior cruciate ligament (ACL) reconstruction remains controversial. The use of allograft has risen exponentially in recent years with the attraction of absent donor site morbidity, reduced surgical time and reliable graft size. However, the published evidence examining their clinical effectiveness over autograft tendons has been unclear. The aim of this paper is to provide a current review of the clinical evidence available to help guide surgeons through the decision-making process for the use of allografts in primary ACL reconstruction.

METHODS

The literature in relation to allograft healing, storage, sterilisation, differences in surgical technique and rehabilitation have been reviewed in addition to recent comparative studies and all clinical systematic reviews and meta-analyses.

RESULTS

Early reviews have indicated a higher risk of failure with allografts due to association with irradiation for sterilisation and where rehabilitation programs and post-operative loading may ignore the slower incorporation of allografts. More recent analysis indicates a similar low failure rate for allograft and autograft methods of reconstruction when using non-irradiated allografts that have not undergone chemically processing and where rehabilitation has been slower. However, inferior outcomes with allografts have been reported in young (< 25 years) highly active patients, and also when irradiated or chemically processed grafts are used.

CONCLUSION

When considering use of allografts in primary ACL reconstruction, use of irradiation, chemical processing and rehabilitation programs suited to autograft are important negative factors. Allografts, when used for primary ACL reconstruction, should be fresh frozen and non-irradiated. Quantification of the risk of use of allograft in the young requires further evaluation.

LEVELS OF EVIDENCE

III.

Diagnosis of human immunodeficiency virus following femoral head harvest post-total hip arthroplasty

Elective total hip arthroplasty (THA) is a routine procedure. Intraoperative harvesting of excised femoral heads for the purpose of donation during this procedure has become standard practice, in response to increasing bone allograft demand. Robust patient screening and femoral head analysis typically occurs, to minimize the risk of disease transmission to any potential recipient. Screening for human immunodeficiency virus (HIV), a virus normally first diagnosed through serological testing, makes up part of this process. This case describes a 43-year-old male who underwent elective THA, with subsequent analysis of the excised femoral head at time of screening revealing a diagnosis of HIV, a condition previously never detected in the donor. First diagnosis of HIV from bone is exceedingly rare, with this case illustrating an unusual diagnostic pathway of a well-understood condition, as well as representing an unfamiliar outcome following a common surgical intervention.