Utilization of a compaction simulator to formulate mini-tablets containing high dose of acyclovir

Using a Material Library to Understand the Change of Tabletability by High Shear Wet Granulation

Understanding the tabletability change of materials after granulation is critical for the formulation and process design in tablet development. In this paper, a material library consisting of 30 pharmaceutical materials was used to summarize the pattern of change of tabletability during high shear wet granulation and tableting (HSWGT). Each powdered material and the corresponding granules were characterized by 19 physical properties and nine compression behavior classification system (CBCS) parameters. Principal component analysis (PCA) was used to compare the physical properties and compression behaviors of ungranulated powders and granules. A new index, namely the relative change of tabletability (CoT_r), was proposed to quantify the tabletability change, and its advantages over the reworking potential were demonstrated. On the basis of CoT_r values, the tabletability change classification system (TCCS) was established. It was found that approximately 40% of materials in the material library presented a loss of tabletability (i.e., Type I), 50% of materials had nearly unchanged tabletability (i.e., Type II), and 10% of materials suffered from increased tabletability (i.e., Type III). With the help of tensile strength (TS) vs. compression pressure curves implemented on both powders and granules, a data fusion method and the PLS2 algorithm were further applied to identify the differences in material properties requirements for direct compression (DC) and HSWGT. Results indicated that increasing the plasticity or porosity of the starting materials was beneficial to acquiring high TS of tablets made by HSWGT. In conclusion, the presented TCCS provided a means for the initial risk assessment of materials in tablet formulation design and the data modeling method helped to predict the impact of formulation ingredients on the strength of compacts.

How Does Long-Term Storage Influence the Physical Stability and Dissolution of Bicalutamide from Solid Dispersions and Minitablets?

The stability of amorphous drugs is among the main challenges in the development of solid dosage forms. This paper examines the effect of storage conditions (25 °C/60% RH and 40 °C/75% RH) and different packaging materials, i.e., polystyrene containers and PVC/Al blisters, on the crystallinity and dissolution characteristics of solid dispersions containing bicalutamide and polyvinylpyrrolidone. The results confirmed drug amorphization upon milling and improved dissolution resulting from the lack of a crystal lattice. These properties varied with time regarding sample composition, storage conditions, and packaging material. The most resistant to storage conditions was the 1:1 solid dispersion packed into blisters. Based on the obtained results, the 1:1 solid dispersion was formulated into minitablets, which were then tested after tableting and then packed into PVC/Al blisters and stored for six months in the same conditions as solid dispersions. We proved that efficient stabilization of amorphous bicalutamide depends on the barrier properties of packaging materials and that a properly chosen material protected the drug substance from the influence of unfavorable storage conditions such as elevated temperature and humidity.