Electrochemical hydrodehalogenation of 2,4-dichlorophenol in paraffin oil and comparison with aqueous systems

Nucleophilic reactivity and electrocatalytic reduction of halogenated organic compounds by nickel o-phenylenedioxamidate complexes

Nickel(ii)-ate complexes supported by o-phenylenebis(N-methyloxamide) reacted with alkyl halides to form new imidate tautomers which were characterized by X-ray crystallography and FT-IR spectroscopy, and used for electroreduction of chloroform.

Dechlorination of pentachlorophenol (PCP) in aqueous solution on novel Pd-loaded electrode modified with PPy-SDBS composite film

Pentachlorophenol (PCP) is a persistent pollutant and a suspected human carcinogen. It can be found in the air, water, and soil and enters the environment through evaporation from treated wood surfaces, industrial spills, and disposal at uncontrolled hazardous waste sites. Ecotoxicity of PCP necessitates the development of rapid and reliable remediation techniques. Electrocatalytic hydrogenolysis (ECH) has been proven as a promising method for detoxification of halogenated wastes, due to its rapid reaction rate, low apparatus cost, mild reaction conditions, and absence of secondary contaminants. Challenge for the application of ECH is to prepare a Pd-coated cathode with high stability, high catalytic activity, and low Pd loading level. In this work, Pd/polypyrrole-sodium dodecyl benzene sulfonate/meshed Ti (Pd/PPy-SDBS/Ti) electrode was prepared and was characterized by cyclic voltammetry, scanning electron microscopy, X-ray diffraction, and inductively coupled plasma-atomic emission spectrometry. Electrochemically reductive dechlorination of PCP on the Pd/PPy-SDBS/Ti electrode in aqueous solution was investigated. Pd microparticles were uniformly dispersed on PPy-SDBS film which was previously electrodeposited on the meshed Ti supporting electrode. The loading of Pd on the electrode was 0.72 mg cm(-2). Electrocatalytic dechlorination of PCP was performed in a two-compartment cell separated by cation-exchange membrane. The PCP removal on the Pd/PPy-SDBS/Ti electrode could reach 100 % within 70 min with dechlorination current 3 mA when PCP initial concentration was 10 mg L(-1) and initial pH was 2.4. Conversion of PCP on the Pd/PPy-SDBS/Ti electrode followed pseudo-first-order kinetics, and the apparent activation energy was 13.0 kJ mol(-1). The removal of PCP still kept 100 % after 70 min dechlorination when the Pd/PPy-SDBS/Ti cathode was reused ten times. The electrode exhibited promising dechlorination potential with high electrocatalytic activity, good stability, and low cost.

Electrochemical dechlorination of chloroform in neutral aqueous solution on palladium/foam-nickel and palladium/polymeric pyrrole film/foam-nickel electrodes

Electrochemical dechlorination of chloroform in neutral aqueous solution was investigated using palladium-loaded electrodes at ambient temperature. Palladium/foam-nickel (Pd/foam-Ni) and palladium/polymeric pyrrole film/foam-nickel (Pd/PPy/foam-Ni) composite electrodes which provided catalytic surface for reductive dechlorination of chloroform in aqueous solution were prepared using an electrodepositing method. Scanning electron microscope (SEM) micrographs showed that polymeric pyrrole film modified the electrode-surface characteristics and resulted in the uniform dispersion of needle-shaped palladium particles on foam-Ni supporting electrode. The experimental results of dechlorination indicated that the removal efficiency of chloroform and current efficiency in neutral aqueous solution on Pd/PPy/foam-Ni electrode could be up to 36.8% and 33.0% at dechlorination current of 0.1 mA and dechlorination time of 180 min, which is much higher than that of Pd/foam-Ni electrode.