Electrocatalytical of chlorophenoxycarboxylic acids at a protoporphyrin IX cobalt(III) chloride modified glassy carbon electrode

ZIF-67-modified magnetic nanoparticles for extraction of phenoxy carboxylic acid herbicides

Phenoxy carboxylic acid (PCA) herbicides are commonly used herbicides that can easily accumulate in soil, groundwater, crops, and vegetable surfaces. Thus, they pose a serious risk to human health. Accurate detection of trace amounts of PCAs in various matrixes is crucial. Herein, ZIF-67-modified magnetic nanoparticles (MNPs, ZIF-67@Fe3O4) were prepared by growing ZIF-67 on the surface of Fe3O4 MNPs. The introduction of ZIF-67 improved the dispersion of Fe3O4 nanoparticles in water and enhanced their extraction performance for PCAs. When an eluent consisting of ammonia water and acetonitrile (5% : 95%; v/v) was employed, 10 mg of ZIF-67@Fe3O4 displayed optimal extraction performance for PCAs in a 20 mL sample solution at a pH of 3. We achieved a limit of detection ranging from 0.014 μg L-1 to 0.056 μg L-1 for four types of PCA herbicides by using the newly developed method. Notably, the values were considerably lower than the maximum concentration levels of PCAs in drinking water set by the Environmental Protection Agency. The relative recovery rate of PCAs using ZIF-67@Fe3O4 ranged from 83.75% to 117.07% when applied to river water and apple samples. These results demonstrate the great potential of ZIF-67@Fe3O4 in determining the residues of organic pesticides in real samples.

In situ voltammetric analysis of 2,4-dichlorophenoxyacetic acid in environmental water using a boron doped diamond electrode and an adapted unmanned air vehicle sampling platform

In the present work a voltammetric method was developed for in situ detection of 2,4-dichlorophenoxyacetic acid (2,4-D) in environmental water samples, using a compact and lightweight electrochemical cell using a fused deposition modeling (FDM) 3D printer with biodegradable polylactic acid filament, and a boron-doped diamond electrode (BDDE). The samples were collected by an adapted unmanned aerial vehicle (UAV) with a micropump and a miniature solenoid valve powered by an open source microcontroller. After optimizing the supporting electrolyte, pH and parameters of the square wave voltammetry (SWV) a linear analytical curve for 2,4-D in 0.5 mol L^-1 Na₂SO₄ (pH = 2.0 regulated using 0.5 mol L^-1 H₂SO₄ solution) in a concentration range from 100 nmol L^-1 to 911 nmol L^-1 with 34 nmol L^-1 as the limit of detection was obtained. The same samples in situ analyzed by SWV were sent to the laboratory for gas chromatography-mass spectrometry (GC-MS) analysis; and there was no statistical difference from the concentration of 2,4-D in any of the samples at a 95% confidence level. Therefore, the method developed for quantification of 2,4-D in water provides an important environmental monitoring tool since it enables access to difficult areas in a fast, practical and safe way. This is the first time that an adapted UAV with these features has been used to collect environmental water for in situ electrochemical analysis as a screening tool to alert the presence of environmental hazard compounds, such as 2,4-D. Thus, this method can be used by environmental and sanitary control agencies to monitor or to supervise environmental water quality with response in real time.

Electroanalytical Methodology for the Direct Determination of 2,4-Dichlorophenoxyacetic Acid in Soil Samples Using a Graphite-Polyurethane Electrode

An electroanalytical methodology was developed for the direct determination of the herbicide 2,4-dichlorophenoxyacetic acid (2,4-D) using a graphite-polyurethane composite electrode and square wave voltammetry (SWV). 2,4-D exhibited one reduction peak with characteristics of an irreversible process at −0.54 V (versus Ag/AgCl), which is controlled by the diffusion of the reagent on the electrode surface. After the experimental parameters optimization (pH 2.0,f=50 s−1,a=0.50 V, andΔEi=0.03 V), analytical curves were constructed in the range of 0.66 mg L−1to 2.62  mg L−1. Detection (LD) and quantification (LQ) limits were 17.6 μg L−1and 58.6 μg L−1, respectively. The methodology was successfully applied to measure the percolation of the herbicide 2,4-D in undisturbed soil columns of different granulometric compositions.