Ethanol oxidation reaction at Pd-modified nickel foam obtained by PVD method in alkaline solution

Recent Developments for the Application of 3D Structured Material Nickel Foam and Graphene Foam in Direct Liquid Fuel Cells and Electrolyzers

Platinum and platinum-based catalysts are some of the most effective catalysts used in fuel cells. However, electrocatalysts used for direct liquid fuel cells (DLFCs) and electrolyzers are high cost and suffer from several other problems, thus hindering their commercialization as power sources to produce clean energy. Common issues in electrocatalysts are low stability and durability, slow kinetics, catalyst poisoning, high catalyst loading, high cost of the catalytic materials, poisoning of the electrocatalysts, and formation of intermediate products during electrochemical reactions. The use of catalyst supports can enhance the catalytic activity and stability of the power sources. Thus, nickel foam and graphene foam with 3D structures have advantages over other catalyst supports. This paper presents the application of nickel foam and graphene foam as catalyst supports that enhance the activities, selectivity, efficiency, specific surface area, and exposure of the active sites of DLFCs. Selected recent studies on the use of foam in electrolyzers are also presented.

Operando X-ray absorption spectroscopy of a Pd/γ-NiOOH 2 nm cubes hydrogen oxidation catalyst in an alkaline membrane fuel cell

The mechanism of Pd/γ-NiOOH 2 nm cubes hydrogen oxidation catalyst for alkaline fuel cell is investigated by operando X-ray absorption spectroscopy.

CoFe–OH Double Hydroxide Films Electrodeposited on Ni-Foam as Electrocatalyst for the Oxygen Evolution Reaction

Cobalt-iron double hydroxide (CoFe–OH) films were electrochemically deposited on 3D Ni foam electrodes for the oxygen evolution reaction (OER). The dependence of the OER activity on film composition and thickness was evaluated, which revealed an optimal Fe:Co ratio of about 1:2.33. The composition of the catalyst film was observed to vary with film thickness. The electrodeposition parameters were carefully controlled to yield microstructured Ni-foam decorated with CoFe–OH films of controlled thickness and composition. The most active electrode exhibited an overpotential as low as 360 mV OER at an industrial scale current density of 400 mA cm−2 that remained stable for at least 320 h. This work contributes towards the fabrication of practical electrodes with the focus on the development of stable electrodes for electrocatalytic oxygen evolution at high current densities.