Proton conductivity improvement of polymer electrolyte membrane using nano-scale explosion of water in the membrane

Preparation and Characterization of a Novel Sulfonated Titanium Oxide Incorporated Chitosan Nanocomposite Membranes for Fuel Cell Application

In this study, nano-TiO₂ sulfonated with 1,3-propane sultone (STiO₂) was incorporated into the chitosan (CS) matrix for the preparation of CS/STiO₂ nanocomposite membranes for fuel cell applications. The grafting of sulfonic acid (–SO₃H) groups was confirmed by Fourier transform infrared spectroscopy, thermogravimetric analysis and energy-dispersive X-ray spectroscopy. The physicochemical properties of these prepared membranes, such as water uptake, swelling ratio, thermal and mechanical stability, ion exchange capacity and proton conductivity, were determined. The proton conducting groups on the surface of nano-TiO₂ can form continuous proton conducting pathways along the CS/STiO₂ interface and thus improve the proton conductivity of CS/STiO₂ nanocomposite membranes. The CS/STiO₂ nanocomposite membrane with 5 wt% of sulfonated TiO₂ showed a proton conductivity (0.035 S·cm⁻¹) equal to that of commercial Nafion 117 membrane (0.033 S·cm⁻¹). The thermal and mechanical stability of the nanocomposite membranes were improved because the interfacial interaction between the -SO₃H group of TiO₂ and the –NH₂ group of CS can restrict the mobility of CS chains to enhance the thermal and mechanical stability of the nanocomposite membranes. These CS/STiO₂ nanocomposite membranes have promising applications in proton exchange membrane fuel cells.

Nanometer-Scale Water Dynamics in Nafion Polymer Electrolyte Membranes: Influence of Molecular Hydrophobicity and Water Content Revisited

The ionic conductivity of polymer electrolyte membranes (PEMs) is an essential parameter for their device applications. In water-swollen PEMs, protons and other ions are transferred through hydrophilic channels of a few nanometers in diameter at most. Thus, optimizing the chemical and physical properties of the channels can enhance the conductivity of PEMs. However, the factors controlling the conductivity have not been completely clarified. Here, we report that measurements taken near the channel walls by a special nuclear magnetic resonance technique with ≤1 nm spatial resolution showed the largest water diffusivity when ∼80% of hydrophilic sulfonic acid groups were blocked, but the proton conductivity was low. The water diffusivity was much less affected by differences in water content. Our results provide a concept for changing the properties of PEMs and a challenge to implement the improved diffusivity in a way that enhances net ion conductivity.