Electrochemical study and extraction of Pb metal from Pb oxides and Pb sulfate using hydrophobic Brønsted acidic amide-type ionic liquid: A feasibility demonstration

A Kinetically Superior Rechargeable Zinc-Air Battery Derived from Efficient Electroseparation of Zinc, Lead, and Copper in Concentrated Solutions

Zinc electrodeposition is currently a hot topic because of its widespread use in rechargeable zinc-air batteries. However, Zn deposition has received little attention in organic solvents with much higher ionic conductivity and current efficiency. In this study, a Zn-betaine complex is synthesized by using ZnO and betainium bis[(trifluoromethyl)sulfonyl]imide and its electrochemical behavior for six organic solvents and electrodeposited morphology are studied. Acetonitrile allowed dendrite-free Zn electrodeposition at room temperature with current efficiencies of up to 86 %. From acetonitrile solutions in which Zn, Pb, and Cu complexes are dissolved in high concentrations, Zn and Pb/Cu are efficiently separated electrolytically under potentiostatic control, allowing the purification of solutions prepared directly from natural ores. Additionally, a highly flexible Zn anode with excellent kinetics is obtained by using a carbon fabric substrate. A rechargeable zinc-air battery with these electrodes shows an open-circuit voltage of 1.63 V, is stable for at least 75 cycles at 0.5 mA cm-2 or 33 cycles at 20 mA cm-2 , and allows intermediate cycling at 100 mA cm-2 .

Ionometallurgical Step-Electrodeposition of Zinc and Lead and its Application in a Cycling-Stable High-Voltage Zinc-Graphite Battery

Ionometallurgy is a new development aiming at the sustainable low-temperature conversion of naturally occurring metal ores and minerals to their metals or valuable chemicals in ionic liquids (ILs) or deep eutectic solvents. The IL betainium bis((trifluoromethyl)sulfonyl)imide, [Hbet][NTf₂ ], is especially suited for this process due to its redox-stability and specific-functionalization. The potentiostatic electrodeposition of zinc and lead starting directly from ZnO and PbO, which dissolve in [Hbet][NTf₂ ] in high concentrations is reported. The initial reduction potentials of zinc(II) and lead(II) are about -1.5 and -1.0 V, respectively. The ionic conductivity of the solution of ZnO in [Hbet][NTf₂ ] is measured and the effect of various temperatures and potentials on the morphology of the deposited material is explored. The IL proves to be stable under the chosen conditions. From IL-solutions, where ZnO, PbO, and MgO have been dissolved, metallic Zn and Pb are deposited under potentiostatic control either consecutively by step-electrodeposition or together in a co-electrodeposition. Using the method, Zn is also deposited on 3D copper foam and assembles into high-voltage zinc-graphite battery. It exhibits a working-voltage up to 2.7 V, an output midpoint discharge-voltage of up to 2.16 V, up to 98.6% capacity-retention after 150 cycles, and good rate performance.

Synthesis and Dissolution of Metal Oxides in Ionic liquids and Deep Eutectic Solvents

Ionic liquids (ILs) and deep eutectic solvents (DESs) have proven to be suitable solvents and reactants for low-temperature reactions. To date, several attempts were made to apply this promising class of materials to metal oxide chemistry, which, conventionally, is performed at high temperatures. This review gives an overview about the scientific approaches of the synthesis as well as the dissolution of metal oxides in ILs and DESs. A wide range of metal oxides along with numerous ILs and DESs are covered by this research. With ILs and DESs being involved, many metal oxide phases as well as different particle morphologies were obtained by means of relatively simple reactions paths. By the development of acidic task-specific ILs and DESs, even difficultly soluble metal oxides were dissolved and, hence, made accessible for downstream chemistry. Especially the role of ILs in these reactions is in the focus of discussion.