Electrocatalytic activities of engineered carbonaceous cathodes for generation of hydrogen peroxide and oxidation of recalcitrant reactive dye

A review on disinfection technologies for controlling the antibiotic resistance spread

The occurrence of antibiotic-resistant bacteria (ARB) in water bodies poses a sanitary and environmental risk. These ARB and other mobile genetic elements can be easily spread from hospital facilities, the point in which, for sure, they are more concentrated. For this reason, novel clean and efficient technologies are being developed for allowing to remove these ARB and other mobile genetic elements before their uncontrolled spread. In this paper, a review on the recent knowledge about the state of the art of the main disinfection technologies to control the antibiotic resistance spread from natural water, wastewater, and hospital wastewater (including urine matrices) is reported. These technologies involve not only conventional processes, but also the recent advances on advanced oxidation processes (AOPs), including electrochemical advanced oxidation processes (EAOPs). This review summarizes the state of the art on the applicability of these technologies and also focuses on the description of the disinfection mechanisms by each technology, highlighting the promising impact of EAOPs on the remediation of this important environmental and health problem.

Catalytic activity comparison of natural ferrous minerals in photo-Fenton oxidation for tertiary treatment of dyeing wastewater

Natural ferrous minerals are readily available and recyclable catalysts in photo-Fenton-like oxidation for wastewater treatment. In this work, typical ferrous oxide and sulfide minerals including magnetite, chalcopyrite, and pyrrhotite were exploited as catalysts in heterogeneous photo-Fenton oxidation for purification of biological effluent of dyeing wastewater. In a wide initial pH range (3.0~7.5), ferrous mineral-based heterogeneous photo-Fenton-like reactions were proven to be effective on the oxidation of recalcitrant pollutants. COD removals achieved 60.57%, 58.83%, and 57.41% using pyrrhotite, chalcopyrite, and magnetite, respectively, as catalyst under ultraviolet irradiation of 220~275 nm at H₂O₂ concentration of 9.8 mM. The corresponding COD removals were 51.75% and 34.09% with or without ferrous sulfate additions in UV/H₂O₂ systems. Minerals exhibited excellent stability and reusability with photo-catalytic activity reduction of less than 10% in the reuse of 5 cycles. Dissolved iron concentrations were determined to be 1.86 mg L^-1, 4.62 mg L^-1, and 7.53 mg L^-1 for magnetite, chalcopyrite, and pyrrhotite, respectively, at pH 3 and decreased to zero in neutral pH environment, which were much lower than those required for homogenous Fenton reaction. It was deduced that oxidation of recalcitrant pollutants was mainly catalyzed by Fe(II) on the mineral surface. The more reactive oxygen species such as hydroxyl radicals were resulted from the reaction of surface Fe (II) with H₂O₂, H₂O₂ photolysis, and charge separation of minerals under UV irradiation.

Electrochemical removal of RRX-3B in residual dyeing liquid with typical engineered carbonaceous cathodes

Electro-catalytic activities of carbonaceous cathodes including graphite plate, graphite felt, carbon felt, activated carbon felt (ACF) and carbon fiber felt (CFF) for degradation of Reactive Red X-3B (RRX-3B) in residual dyeing liquid were compared. The best electrochemical performance was obtained using dimensional stable anode (DSA) and CFF cathode due to the higher capacity for electro-generation of H₂O₂ by selective two-electron oxygen reduction. The CFF/DSA electrolysis system realized 78.2% COD removal and complete decolorization over a wide pH range. The efficacy of RRX-3B degradation was found to be dependent on the nature of carbonaceous materials. Electrochemical measurements showed that CFF possessed higher electrochemical surface area and hydrogen evolution reaction over-potential. Furthermore, the intrinsic graphitic N in CFF was proved to be catalytic active site by DFT calculations. Reactive Red X-3B degradation intermediates with benzene structures and carboxylic acids via hydroxylation in RRX-3B oxidation were identified by GC-MS. It was found that S/Cl/N-containing groups in RRX-3B molecule were mineralized to SO₄^2-, NO₃^- and Cl^- ions in the electrolysis.

Recent Achievements in Dyes Removal Focused on Advanced Oxidation Processes Integrated with Biological Methods

In the last 3 years alone, over 10,000 publications have appeared on the topic of dye removal, including over 300 reviews. Thus, the topic is very relevant, although there are few articles on the practical applications on an industrial scale of the results obtained in research laboratories. Therefore, in this review, we focus on advanced oxidation methods integrated with biological methods, widely recognized as highly efficient treatments for recalcitrant wastewater, that have the best chance of industrial application. It is extremely important to know all the phenomena and mechanisms that occur during the process of removing dyestuffs and the products of their degradation from wastewater to prevent their penetration into drinking water sources. Therefore, particular attention is paid to understanding the mechanisms of both chemical and biological degradation of dyes, and the kinetics of these processes, which are important from a design point of view, as well as the performance and implementation of these operations on a larger scale.