Gastrocnemius fascicle and achilles tendon length at the end of the eccentric phase in a single and multiple countermovement hop

Strength and power capabilities predict weighted parameter ranking of saut de chat leaping performance in dancers

Limited research exists on the relationship between aesthetic saut de chat performance and muscle-tendon unit (MTU) characteristics of dancers. We developed a weighted parameter ranking (WPR) tool to incorporate aesthetic leaping aspects (i.e., height, peak split angle, average trunk angle and trunk angle range) for correlation with MTU properties. The purpose was to identify the relationship of saut de chat WPR and leap height with maximal plantarflexion strength, medial gastrocnemius (MG) stiffness, Achilles tendon (AT) stiffness and relative peak power (PP). Dancers (n = 18) performed maximal plantarflexion, short-range stretches and isometric ramping contractions on a dynamometer equipped with ultrasound to determine strength, MG stiffness and AT stiffness, respectively. Subjects then performed saut de chat leaps atop force platforms surrounded by motion capture cameras. A principal component analysis (PCA) was performed to compare WPR variable weightings with PCA results and rankings. Moderate-strong relationships were identified among WPR, maximal plantarflexion strength, MG stiffness and PP. Strong-very strong relationships were also identified between leap height and maximal plantarflexion strength, MG stiffness, AT stiffness, peak split angle and PP. A very strong correlation existed between PCA rankings and WPRs. Practitioners may consider developing strength and power capabilities in dancers to improve leaping.

Muscle Actuators, Not Springs, Drive Maximal Effort Human Locomotor Performance

The current investigation examined muscle-tendon unit kinematics and kinetics in human participants asked to perform a hopping task for maximal performance with variational preceding milieu. Twenty-four participants were allocated post-data collection into those participants with an average hop height of higher (HH) or lower (LH) than 0.1 m. Participants were placed on a customized sled at a 20º angle while standing on a force plate. Participants used their dominant ankle for all testing and their knee was immobilized and thus all movement involved only the ankle joint and corresponding propulsive unit (triceps surae muscle complex). Participants were asked to perform a maximal effort during a single dynamic countermovement hop (CMH) and drop hops from 10 cm (DH10) and 50 cm (DH50). Three-dimensional motion analysis was performed by utilizing an infrared camera VICON motion analysis system and a corresponding force plate. An ultrasound probe was placed on the triceps surae muscle complex for muscle fascicle imaging. HH hopped significantly higher in all hopping tasks in comparison to LH. In addition, the HH group concentric ankle work was significantly higher in comparison to LH during all of the hopping tasks. Active muscle work was significantly higher in HH in comparison to LH as well. Tendon work was not significantly different between HH and LH. Active muscle work was significantly correlated with hopping height (r = 0.97) across both groups and hopping tasks and contributed more than 50% of the total work. The data indicates that humans primarily use a motor-driven system and thus it is concluded that muscle actuators and not springs maximize performance in hopping locomotor tasks in humans.