Use of activated sludge biomass as an agent for advanced primary separation

Maximizing energy recovery from wastewater via bioflocculation-enhanced primary treatment: a pilot scale study

Anaerobic digestion of municipal sewage sludge is widely used for harvesting energy from wastewater organic content. The more organic carbon we can redirect into the primary sludge, the less energy is needed for aeration in secondary treatment and the more methane is produced in anaerobic digesters. Bioflocculation has been proposed as a promising separation technology to maximize carbon capture in primary sludge. Thus far, only limited data on bioflocculation are available under real conditions, i.e. from pilot-scale reactors treating raw sewage. Moreover, no study has discussed yet the influence of bioflocculation on denitrification potential of sewage. Therefore, we performed bioflocculation of raw sewage in high-rate contact stabilization process in pilot-scale to investigate maximal primary treatment efficiency. During 100 days of operation at sludge retention time of only 2 days, the average removal efficiencies of chemical oxygen demand (COD), suspended solids and total phosphorus were 75%, 87% and 51%, respectively, using no chemicals for precipitation. Up to 76% of incoming COD was captured in primary sludge and 46% for subsequent anaerobic digestion, where energy recovery potential achieved 0.33-0.37 g COD as CH₄ per g COD of influent. This study showed in real conditions that this newly adapted separation process has significant benefits over chemically enhanced primary treatment, enabling sewage treatment process to overcome energy self-sufficiency.

Exploring the Bioelectrochemical Characteristics of Activated Sludge Using Cyclic Voltammetry

Due to the potential interest, bioelectrochemical responses of activated sludge using the three-electrode system are tested. From the cyclic voltammograms, the oxidation current output is increasing due to incubation time increase, whereas 5, 25 and 39.33 μA are obtained after 3, 72 and 96 h, respectively. Changing the working electrode from glassy carbon to carbon paste led to the increase in the electrochemical signal from 0.3 to be 3.72 μA. On the other hand, the use of the lipophilic redox mediator (2,6-dichlorophenolindophenol (DCIP)) amplified the oxidation current to reach 19.9 μA instead of 2.1 μA. Based on these findings, the mixed microbial community of the activated sludge is exploited as a catalyst for the bio-oxidation of the degradable organic substrates, while DCIP is used as a mobile electron carrier from the intracellular matrix of the metabolically active cells to the carbon paste electrode which served as the final electron acceptor. Therefore, the extracellular electron transfer from the formed active biofilm at the electrode surface is assisted by the existence of DCIP.