Extracellular organic matter (EOM) distribution characteristic in algae electro-dewatering process

Advances in Membrane Separation for Biomaterial Dewatering

Biomaterials often contain large quantities of water (50-98%), and with the current transition to a more biobased economy, drying these materials will become increasingly important. Contrary to the standard, thermodynamically inefficient chemical and thermal drying methods, dewatering by membrane separation will provide a sustainable and efficient alternative. However, biomaterials can easily foul membrane surfaces, which is detrimental to the performance of current membrane separations. Improving the antifouling properties of such membranes is a key challenge. Other recent research has been dedicated to enhancing the permeate flux and selectivity. In this review, we present a comprehensive overview of the design requirements for and recent advances in dewatering of biomaterials using membranes. These recent developments offer a viable solution to the challenges of fouling and suboptimal performances. We focus on two emerging development strategies, which are the use of electric-field-assisted dewatering and surface functionalizations, in particular with hydrogels. Our overview concludes with a critical mention of the remaining challenges and possible research directions within these subfields.

Effect of Electrofiltration on the Dewatering Kinetics of Arthrospira platensis and Biocompound Recovery

Arthrospira platensis (A. platensis) is a microalga with a wide range of commercial uses. One of the main concerns that needs to be addressed in microalgae biorefineries is the costs associated with the harvesting and concentration steps. Filtration has been shown to be an effective technique for concentrating microalgae and recent studies have attempted to enhance membrane filtration by applying an external electric field to the filtration cell. This study consisted of assessing the use of electrically assisted filtration (electrofiltration) at 60 A/m2 and 1 bar for the dewatering of A. platensis, as well as the effect of pretreating the microalgae with ultrasounds (US) on the filtration process. Untreated A. platensis exhibited better filtration kinetics than US-treated A. platensis, and electrofiltration was found to increase the cake dryness. More protein and pigments were present in the US-treated microalgae solution compared to the untreated microalgae, which led to the presence of higher concentrations of protein and pigments in the filtrate streams after pressure filtration at 1 bar without the application of an external electric field. Electrofiltration was found to consume less energy compared to traditional drying techniques used for A. platensis. However, electrofiltration degrades the biocompounds present in the filtrate and cake due to pH changes and other electrophoresis phenomena, which shows the need to optimize the process in future work.

Study of the variations in apparent electrical resistivity of activated sludge during the electro-dewatering process

The high energy consumption of high apparent electrical resistivity (AER) in sludge during the later stages of the electro-dewatering (EDW) process is a difficult problem; however, analysis of sludge AER may contribute to a reduction in energy consumption. In this study, the variations in the AER of activated sludge and potential mechanisms related to sludge properties were systematically examined. First, a sludge cake was divided into four horizontal layers, in order to investigate the sludge AER in each layer. Then, the effects of variations in water distribution, oxidation-reduction potential (ORP), pH, metal ions, sludge conductivity, zeta potential, temperature, and sludge microstructure on the AER in each layer were explored. The results showed that the sludge AER began to increase from the bottom layers to the top layers when the moisture content (MC) was decreased to 60%. The formation of nonionic chemical systems and the gas barrier layer could increase the AER in the top layers, and the increase in sludge AER in the bottom layers was due to the decrease in MC and sludge conductivity. In addition, electrolyte release and electromigration had a significant effect on the sludge AER. This work identifies potential causes for the increase in AER, and provides a reference for solving problems related to high AER in sludge during the later stages of the EDW process.