Removal of F- and organic matter from coking wastewater by coupling dosing FeCl3 and AlCl3

Efficient recovery of highly pure CaF2 from fluorine-containing wastewater using an icy lime solution

Developing a feasible and low-cost strategy for the recovery of calcium fluoride efficiently from fluoride-containing wastewater is very essential for the recycle of fluoride resources. Herein, a modified lime precipitation method was employed to recover CaF2 from fluorinated wastewater using a special icy lime solution. Intriguingly, the highest F- removal was greater than 95% under the optimal condition, leaving a fluoride concentration from 200 to 8.64 mg/L, while the lime dosage was much lower than that of industry. Importantly, spherical-shaped CaF2 particles with a 93.47% purity and size smaller than 600 nm were recovered, which has a high potential for the production of hydrofluoric acid. Besides, the precipitation was significantly affected by Ca/F molar ratio, stirring time, temperature, and solution pH. Furthermore, the thermodynamics and kinetics were investigated in detail to reveal the crystallization process. As a result, the defluorination reaction followed the pseudo-second order reaction kinetics model. Also, CO2 in the air adversely influenced the CaF2 purity. Based on this facile method, a high lime utilization efficiency was applied to defluorination, which contributed to protecting the environment and saving costs. This study, therefore, provides a feasible approach for the green recovery of fluorine resources and has significance for related research.

Amendment of Sargassum oligocystum bio-char with MnFe2O4 and lanthanum MOF obtained from PET waste for fluoride removal: A comparative study

The use of biomass and waste to produce adsorbent reduces the cost of water treatment. The bio-char of Sargassum oligocystum (BCSO) was modified with MnFe2O4 magnetic particles and La-metal organic framework (MOF) to generate an efficient adsorbent (BCSO/MnFe2O4@La-MOF) for fluoride ions (F-) removal from aqueous solutions. The performance of BCSO/MnFe2O4@La-MOF was compared with BCSO/MnFe2O4 and BCSO. The characteristics of the adsorbents were investigated using various techniques, which revealed that the magnetic composites were well-synthesized and exhibited superparamagnetic properties. The maximum adsorption efficiencies (BCSO: 97.84%, BCSO/MnFe2O4: 97.85%, and BCSO/MnFe2O4@La-MOF: 99.36%) were achieved under specific conditions of pH 4, F- concentration of 10 mg/L, and adsorbent dosage of 3, 1.5, and 1 g/L for BCSO, BCSO/MnFe2O4, and BCSO/MnFe2O4@La-MOF, respectively. The results demonstrated that the experimental data adheres to a pseudo-second-order kinetic model. The enthalpy, entropy, and Gibbs free energy were determined to be negative; thus, the F- adsorption was exothermic and spontaneous in the range of 25-50 °C. The equilibrium data of the process exhibited conformity with the Langmuir model. The maximum adsorption capacities of F- ions were determined as 10.267 mg/g for BCSO, 14.903 mg/g for the BCSO/MnFe2O4, and 31.948 mg/g for BCSO/MnFe2O4@La-MOF. The KF and AT values for the F- adsorption were obtained at 21.03 mg/g (L/mg)1/n and 100 × 10+9 L/g, indicating the pronounced affinity of the BCSO/MnFe2O4@La-MOF towards F- than other samples. The significant potential of the BCSO/MnFe2O4@La-MOF magnetic composite for F- removal from industrial wastewater, makes it suitable for repeated utilization in the adsorption process.

Dissolved organic material changes during combined treatment of a mixture of landfill leachate and anaerobic digestate using deammonification and chemical coagulation

The current study investigates the combined treatment of wastewater of anaerobic digestate and landfill leachate, using deammonification and coagulation/flocculation processes. The deammonification section studies the performance of a full-scale deammonification plant in nitrogen and chemical oxygen demand (COD) removal, monitored over 2 years. For further COD reduction from the deammonification effluent (DE) to meet the environmental regulatory standards, coagulation/flocculation using three different Al-based coagulants was used to treat the DE. Results revealed that the deammonification plant showed 80% average ammonium removal from the mixed feed over the study period. Additionally, 30% of the feed COD was removed in the deammonification plant. COD analysis after treatment using coagulants revealed that the polyaluminum chloride modified with Fe had the best performance in reducing COD to meet the environmental standards. Excitation-emission matrix-parallel factor analysis (EEM-PARAFAC) of the dissolved organic material (DOM) samples indicated that fluorescents were the compounds mostly affected by the coagulant types. DOM analysis using 2D correlation Fourier-transform infrared spectroscopy revealed that the applied coagulants showed minor differences in removing different functional groups, despite having different COD reduction performance. Wastewater elemental analysis indicated elevated metal concentrations in low pH conditions (<6) due to re-stabilization of the flocs using coagulants.

Fluorine removal from sodium tungstate ion exchange effluent by precipitation with addition of lanthanum chloride

The waste water generated from the sodium tungstate ion exchange process of scheelite hydrometallurgical extraction contains a certain concentration of fluorine ion, which caused environmental pollution and harmed human health. In this study, a new method for removing fluorine from the wastewater by precipitation with addition of lanthanum chloride was proposed. In the process, fluorine was removed by from the solution as insoluble lanthanum fluoride precipitates. To explore the favourable conditions for the formation of lanthanum fluoride, thermodynamic analysis of the La-F-H2O system was conducted. Results show that lanthanum fluoride is stable when the solution pH value is between 1.0 and 10.0, and the lanthanum fluoride is gradually converted into lanthana hydroxide when the pH value is more than 10.0 at 298K. The effects of various parameters on the fluorine removal were studied, and the optimum process parameters were determined. More than 92% of the fluorine can be removed when the concentration of fluorine in the solution ranged from 60 to 400 mg/L, the dosage of lanthanum chloride was 1.3 times of the theoretical amount, the pH value was 8.0 at 60°C for 30 min. After removing fluorine from the solution, the resiual fluorine concentrtion was lower than 10 mg/L, which could meet the requirement of national wastewater discharge.

Optimizing nitrogenous organic wastewater treatment through integration of organic capture, anaerobic digestion, and anammox technologies: sustainability and challenges

With China's recent commitment to reducing carbon emissions and achieving carbon neutrality, anaerobic digestion and anaerobic ammonium oxidation (anammox) have emerged as promising technologies for treating nitrogenous organic wastewater. Anaerobic digestion can convert organic matter into volatile fatty acids (VFAs), methane, and other chemicals, while anammox can efficiently remove nitrogen with minimal energy consumption. This study evaluates the principles and characteristics of enhanced chemical flocculation and bioflocculation, as well as membrane separation, for capturing organic matter. Additionally, the paper evaluates the production of acids and methane from anaerobic digestion, exploring the influence of various factors and the need for control strategies. The features, challenges, and concerns of partial nitrification-anammox (PN/A) and partial denitrification-anammox (PD/A) are also outlined. Finally, an integrated system that combined organic capture, anaerobic digestion, and anammox is proposed as a sustainable and effective solution for treating nitrogenous organic wastewater and recovering energy and resources.

Combing Seeding Crystallization with Flotation for Recovery of Fluorine from Wastewater: Experimental and Molecular Simulation Studies

For effective removal and utilization of fluorine resources from industrial wastewater, stepwise removal and recovery of fluorine were accomplished by seeding crystallization and flotation. The effects of seedings on the growth and morphology of CaF₂ crystals were investigated by comparing the processes of chemical precipitation and seeding crystallization. The morphologies of the precipitates were analyzed by X-ray diffraction (XRD) and scanning electron microscope (SEM) measurements. The seed crystal, fluorite, helps improve the growth of perfect CaF₂ crystals. The solution and interfacial behaviors of the ions were calculated by molecular simulations. The existing perfect surface of fluorite was proven to provide the active sites for ion adhesion and formed a more ordered attachment layer than the precipitation procedure. The precipitates were then floated to recover calcium fluoride. By stepwise seeding crystallization and flotation, the products with a CaF₂ purity of 64.42% can be used to replace parts of metallurgical-grade fluorite. Both removal of fluorine from wastewater and the reutilization of the fluorine resource were realized.

Construction of titanium-aluminum xerogel composite coagulant for removal of tetracycline in water: synergy effects and improvement mechanisms insight

Titanium xerogel coagulant (TXC) is a new type of coagulant that has attracted much attention in recent years. However, the tetracycline removal performance of TXC was not satisfactory because low isoelectric point (pH_iep) inhibited the electrical neutralization efficiency of TXC in an alkaline environment. To overcome this shortcoming, a composite xerogel coagulant (titanium-aluminum xerogel composite coagulant) was prepared. The removal of tetracycline and turbidity was used as evaluation indexes. It was proved that the combination of aluminum (III) and titanium (IV) enhanced the resistance of TXC to pH. The synthesized titanium-aluminum xerogel composite coagulant (TXAC) has an excellent removal ability of tetracycline in a wide pH range (pH = 5-10). At pH 8.8, the dosage required to remove 80% tetracycline from water decreased from 93 (TXC) to 35 mg/L (TXAC). The reason for this improvement could be attributed to (i) aluminum (III) enhanced the electric neutralization of TXC to negatively charged pollutants in an alkaline environment; (ii) the complexing ability of organic matter and aluminum (III) was enhanced. This work provides a feasible scheme for the pretreatment of tetracycline in water to meet the pretreatment requirements of special water.

Effectiveness of the engineered pinecone-derived biochar for the removal of fluoride from water

Drinking fluoride (F^-)-contaminated water (>1.5 mg L^-1) causes severe dental and skeletal disorders. In the central province of Pakistan, ∼20 times higher levels of F^- in the drinking groundwater (compared with the 1.5 mg L^-1 permissible limit of the World Health Organization) are triggering bone abnormalities in teenagers. In this study, we demonstrated the potential of pinecone-derived biochar (pristine) impregnated with Fe- and Al-salts (engineered) to defluoridate water. Batch mode adsorption experiments were carried out under variable conditions of solution pH, F^- initial concentration, adsorbent dose, and contact time. The engineered biochars resulted in greater adsorption than that of pristine biochar. Specifically, the AlCl₃-modified biochar exhibited a maximum adsorption capacity of 14.07 mg g^-1 in spiked water and 13.07 mg g^-1 in in-situ groundwater. The equilibrium isothermal and kinetic models predicted monolayer, cooperative, and chemisorption types of the adsorption process. The chemical interaction and outer-sphere complexation of F^- with Al, Na, and H elements were further confirmed by the post-adsorption analysis of the AlCl₃-modified biochar by FTIR and XRD. The AlCl₃-modified biochar resulted in 87.13% removal of F^- from the in-situ F^--contaminated groundwater, even in the presence of naturally occurring competing ions (such as Cl^-, HCO₃^-, SO₄^2-, and NO₃^-). We conclude that the AlCl₃-modified biochar derived from pinecone could be a promising cost-effective adsorbent for the defluoridation of water.