Variability of provitamin A carotenoids in plantain: Influence of cultivar, bunch type, maturation stage, and location

Comparative study of physicochemical, nutritional, phytochemical, and sensory properties of bread with plantain and soy flours partly replacing wheat flour

Plantain flour (PLF) and soy flour (SF) were used to substitute wheat flour (10% and 20% w/w) in composite bread. Physicochemical, phytochemical, and sensory properties were investigated. Partial substitution by PLF significantly increased (p < .05) starch, amylose, ascorbic acid, and potassium content in bread samples. In contrast, a significant improvement (p < .05) in protein, fat, amylopectin, and calcium content was observed with SF substitution. Composite bread with PLF and SF together lowered the hydrolysis index (HI) and glycemic index (GI) as compared with whole wheat flour. The molar phytate to minerals (iron, zinc, and calcium) ratio in all composite loaves was lower than reported critical values, except for phytate to iron. Significant differences (p < .05) were found in color, specific volume, and texture characteristics of loaves made from partial substitution with PLF and SF. Sensory evaluation revealed that bread with 10% PLF exhibited better scores for appearance and willingness to pay than the control. In contrast, SF negatively affected (p < .05) the appearance, texture, color, overall acceptance, and willingness to pay. The trade‐off analysis indicated that PLF can be utilized to produce bread that meets consumers' demands, while incorporating SF as an alternative high‐nutrient density bread will be beneficial to health.

How Does Cultivar, Maturation, and Pre-Treatment Affect Nutritional, Physicochemical, and Pasting Properties of Plantain Flours?

The effect of cultivar, ripening stage, and pre-treatment method were investigated on the nutritional, physicochemical, and pasting properties of plantain flours from two plantains and two plantain hybrids. There were significant variations (p < 0.05) in chemical composition and physical properties influenced by the interaction of cultivars, ripening stages, and pre-treatment methods. The highest levels of amylose, water-holding capacity (WHC), and oil-holding capacity (OHC) were observed in unripe flours and acid-treated flour recorded the highest content of resistant starch (RS). Flour after pre-blanching contained the highest level of total phenolic (TP), carotenoid contents, and browning index (BI) value. In contrast, acid-treated flours had the lowest BI value. As ripening progressed, peak viscosity and breakdown values increased but final viscosity, setback, and pasting temperature values were reduced. Untreated flour samples showed the highest peak viscosity. Higher breakdown values were found in acid-treated samples and higher setback values in pre-blanched samples.