Iron-complexed adsorptive membrane for As(V) species in water

Preparation and properties of chitosan-metal complex: Some factors influencing the adsorption capacity for dyes in aqueous solution

Chitosan-metal complexes have been widely studied in wastewater treatment, but there are still various factors in complex preparation which are collectively responsible for improving the adsorption capacity need to be further studied. Thus, this study investigates the factors affecting the adsorption ability of chitosan-metal complex adsorbents, including various kinds of metal centers, different metal salts and crosslinking degree. The results show that the chitosan-Fe(III) complex prepared by sulfate salts exhibited the best adsorption efficiency (100%) for various dyes in very short time duration (10min), and its maximum adsorption capacity achieved 349.22mg/g. The anion of the metal salt which was used in preparation played an important role to enhance the adsorption ability of chitosan-metal complex. SO₄^2- ions not only had the effect of crosslinking through electrostatic interaction with amine group of chitosan polymer, but also could facilitate the chelation of metal ions with chitosan polymer during the synthesis process. Additionally, the pH sensitivity and the sensitivity of ionic environment for chitosan-metal complex were analyzed. We hope that these factors affecting the adsorption of the chitosan-metal complex can help not only in optimizing its use but also in designing new chitosan-metal based complexes.

Fabrication of a novel hollow fiber membrane decorated with functionalized Fe2O3 nanoparticles: towards sustainable water treatment and biofouling control

We explored a new strategy using well dispersed functionalized Fe₂O₃ nanoparticles to fabricate a polyetherimide nanocomposite hollow fiber membrane with enhanced surface and anti-biofouling properties.

Temporal and spatial variation of arsenic species in the Dahuofang reservoir in northeast China

Overlying water, pore water, and sediment samples were collected from the Dahuofang reservoir in November 2011 and April 2012, respectively. Total arsenic and arsenic species including arsenite, arsenate, monomethylarsonic, and dimethylarsinic were analyzed by ICP-MS and HPLC-ICP-MS. The results indicated that the environments of the Dahuofang reservoir were in reduced conditions, arsenite was the predominant species in pore water and sediments in the reservoir. Arsenic concentrations in overlying water were very low in all the samples but showed different trend during the different time. In November, arsenic concentrations in the reservoir inlet were higher than that in the other sites, whereas arsenic showed accumulation from the upstream to downstream of the reservoir in samples collected in April. In pore water, arsenic concentrations were about 23 and 37 times higher than those in overlying water in November and April, respectively, and relatively high levels of arsenite were also detected in the pore water. In surface sediments, total arsenic and arsenic species content in the reservoir inlet showed the following decreasing order: R1 > R10 > R4. The results also showed that moderate ecological risks exist in pore water and sediments in the Dahuofang reservoir.

Chitosan-transition metal ions complexes for selective arsenic(V) preconcentration

Chitosan is naturally occurring bio-polymer having strong affinity towards transition metal ions. Chitosan complexed with transition metal ions takes up inorganic arsenic anions from aqueous medium. In present work, As(V) sorption in the chitosan complexed with different metal ions like Cu(II), Fe(III), La(III), Mo(VI) and Zr(IV) were studied. Sorptions of As(V) in CuS embedded chitosan, (3-aminopropyl) triethoxysilane (APTS) embedded chitosan, epichlorohydrin (ECH) crosslinked chitosan and pristine chitosan were also studied. (74)As radiotracer was prepared specifically for As(V) sorption studies by irradiation of natural germanium target with 18 MeV proton beam. The sorption studies indicated that Fe(III) and La(III) complexed with chitosan sorbed 95 ± 2% As(V) from aqueous samples in the pH range of 3-9. However, Fe(III)-chitosan showed better sorption efficiency (91 ± 2%) for As(V) from seawater than La(III)-chitosan (80 ± 2%). Therefore, Fe(III)-chitosan was selected to prepare the self-supported membrane and poly(propylene) fibrous matrix supported sorbent. The experimental As(V) sorption capacities of the fibrous and self-supported Fe(III)-chitosan sorbents were found to be 51 and 109 mg g(-1), respectively. These materials were characterized by XRD, SEM and EDXRF, and used for preconcentration of As(V) in aqueous media like tap water, ground water and seawater. To quantify the As(V) preconcentrated in Fe(III)-chitosan, the samples were subjected to instrumental neutron activation analysis (INAA) using reactor neutrons. As(V) separations were carried out using a two compartments permeation cell for the self-supported membrane and flow cell using the fibrous sorbent. The total preconcentration of arsenic content was also explored by converting As(III) to As(V).