Visible light and iodate/iodide mediated degradation of bisphenol A by self-assembly 3D hierarchical BiOIO3/Bi5O7I Z-scheme heterojunction: Intermediates identification, radical mechanism and DFT calculation

Photocatalytic adsorption/degradation of tetracycline by S-scheme BiOI/BiOIO3 p-n heterojunction from dissociation of BiOIO3in-situ solvothermal process

The pollution of tetracycline (TC) had attracted more and more attention due to its unprecedented use and potential hazards. The S-scheme BiOI/BiOIO3 p-n heterojunction was successfully fabricated by in-situ solvothermal treatment of BiOIO3, and was used for the removal of TC from aqueous solutions. The results demonstrated that the construction of S-scheme p-n heterojunction could significantly improve the removal of TC by photocatalytic adsorption/degradation synergism. The removal rate of TC was significantly enhanced after solvothermal modification. The three main reasons for the enhanced removal efficiency were as follows: first, the light absorption range of the BiOIO3 was enhanced by solvothermal treatment; secondly, the construction of the heterojunction was beneficial to the valid separation and migration of the photo-generated carriers; finally, the adsorption of TC enhanced the speed of TC reaching the semiconductor interface and reacting with active species. Trapping tests were conducted to reveal that •O2- and 1O2 are the main reactive species for TC degradation. The nine degradation products were identified by the high performance liquid chromatography-mass spectrometry (HPLC-MS), and the three reaction pathways were deduced. A possible S-scheme p-n heterojunction photocatalytic mechanism was presented on the basis of band structures and active species capturing experiment.

Rational design of Bi2Sn2O7/Bi5O7I S-scheme heterojunction for visible photocatalytic oxidation of emerging pollutants

The construction of an S-scheme heterostructure is considered as a promising strategy for enhancing photocatalytic performance. Herein, a three-dimensional Bi5O7I (BOI) microsphere decorated with Bi2Sn2O7 (BSO) nanoparticles was prepared for the first time via a simple ultrasonic-assisted electrostatic self-assembly strategy and used for the degradation of 2,4-dinitrophenylhydrazine. 3 wt% Bi2Sn2O7/Bi5O7I has the highest degradation activity (93.7 %), with an apparent rate constant of 0.0848 min-1, which is 2.55 times that of the original Bi5O7I (0.0333 min-1). Moreover, the optimal binary heterojunction photocatalyst has good reusability and universal applicability. The results of cyclic voltammetry tests clarify that the optimal photocatalyst can provide more surface reactive sites. The results of radical trapping experiments and electron spin resonance indicate that holes (h+) and superoxide radicals are the main active radicals in the degradation process of 2,4-dinitrophenylhydrazine. Photoelectrochemical and photoluminescence confirm that 3 wt% Bi2Sn2O7/Bi5O7I composites exhibit the highest separation rate of photogenerated carriers. Finally, based on the results of experimental studies and theoretical calculations, the S-scheme charge transfer path on Bi2Sn2O7/Bi5O7I composite is determined. This work provides a new perspective on how to design high-performance S-scheme bismuth oxyhalide-based heterojunction photocatalysts for solar energy conversion.

Photocatalytic activity evaluation of polyvinylpyrrolidone K30 assisted synthesis of 1D oxygen-vacancy-rich Bi5O7BrxI1-x nanorod solid solution

The unique layered structure of bismuth halide oxide has led to an extensive application in the degradation of refractory antibiotics from water environments. With the aid of regulating the energy band structure of photocatalytic materials and equilibrating the response towards visible light and redox ability, a novel oxygen-vacancy-rich Bi5O7BrxI1-x nanorod solid solution was synthesized by polyvinylpyrrolidone K30 assisted solvothermal method, and its photocatalytic behavior was investigated for the degradation of antibiotic levofloxacin under visible light. The degradation rate of the optimal Bi5O7Br0.5I0.5 to levofloxacin can reach 82.7% within 30 min, which is 9.22 and 4.74 times higher than those of the monomers Bi5O7Br and Bi5O7I. The catalyst of Bi5O7Br0.5I0.5 shows 99.88% antibacterial activity against Escherichia coli. The efficient photocatalytic ability of the Bi5O7Br0.5I0.5 is resulted from the alteration of energy band structure and suppression of charge recombination due to benign changes in the electronic and crystal structures. Furthermore, both various characterizations and Density Functional Theory calculations reveal that a multitude of oxygen vacancies exist in the Bi5O7Br0.5I0.5. The photocatalytic degradation pathways were explored and the toxicity of the intermediates was also appraised. The present work provides a mild and feasible construction of solid solutions and introduction of oxygen vacancies to eliminate environmentally refractory organic pollutants with photocatalytic technology.

Ultrathin Layered Structure and Oxygen Vacancies Mediated Efficient Charge Separation toward High Photocatalytic Activity in BiOIO3 Nanosheets

Previous bismuth-based photocatalysts usually employ a strong acid solution (e.g., HNO3 solution) to obtain an ultrathin structure toward high photocatalytic activity. In this work, the ultrathin layered BiOIO3 nanosheets are successfully synthesized using just the glucose hydrothermal solution. The high-concentration glucose solution shows the obvious acidity after the hydrothermal process, which leads to the quick decrease in thickness of BiOIO3 nanosheets from ∼45.58 to ∼5.74 nm. The ultrathin structure can greatly improve charge carriers' separation and transfer efficiency. The generation of reductive iodide ions brings about oxygen vacancies in the ultrathin nanosheets, then the defect energy level is formed, causing the decreased band gap and improving the visible light absorption. Compared to thick BiOIO3 nanosheet with little oxygen vacancies, much higher carrier separation efficiency and visible light absorption are achieved in the ultrathin nanosheets with oxygen vacancies, resulting in an excellent photocatalytic performance (0.1980 min-1 for RhB degradation), which is much higher than most other bismuth-based photocatalysts. The superoxide radicals (•O2-) and holes (h+) are the major active species responsible for high photocatalytic activity. This work affords an environmentally friendly strategy to synthesize ultrathin photocatalysts with superior photocatalytic properties.

Bisphenol A degradation by chlorine dioxide (ClO2) and S(IV)/ClO2 process: Mechanism, degradation pathways and toxicity assessment

Recently, it has been reported that chlorine dioxide (ClO2) and (bi)sulfite/ClO2 showed excellent performance in micropollutant removal from water; however, the degradation mechanisms and application boundaries of the two system have not been identified. In this study, bisphenol A (BPA) was chosen as the target contaminant to give multiple comparisons of ClO2 and S(IV)/ClO2 process regarding the degradation performance of contaminant, generation of reactive species, transformation of products and toxicity variation. Both ClO2 and S(IV)/ClO2 can degrade BPA within 3 min. The BPA degradation mechanism was mainly based on direct oxidation in ClO2 process while it was attributed to radicals (especially SO4·-) generation in S(IV)/ClO2 process. Meanwhile, the effect of pH and coexisting substances (Cl-, Br-, HCO3- and HA) were evaluated. It was found that ClO2 preferred the neutral and alkaline condition and S(IV)/ClO2 preferred the acidic condition for BPA degradation. An unexpected speed-up of BPA degradation was observed in ClO2 process in the presence of Br-, HCO3- and HA. In addition, the intermediate products in BPA degradation were identified. Three exclusive products were found in ClO2 process, in which p-benzoquinone was considered to be the reason of the acute toxicity increase in ClO2 process.

Effective degradation of lindane and its isomers by dielectric barrier discharge (DBD) plasma: Synergistic effects of various reactive species

Lindane is a broad-spectrum organochlorine insecticide which has been included in the persistent organic pollutants (POPs) list together with its two hexachlorocyclohexane (HCH) isomers. Due to its continuous use in the past decades, the environmental impacts of HCHs are still severe now. Therefore, in the present study, dielectric barrier discharge (DBD) plasma was used as an advanced oxidation process for the destruction of HCHs in water. The result indicated that in air-DBD system, over 95.4% of the initial 5 mg L-1 lindane was degraded within 60 min. Moreover, DBD plasma displayed high degradation efficiencies of other HCH isomers including α, β, and δ-HCH. Electron spin resonance spectra, scavenging experiments and theoretical calculations revealed that the synergistic effects of various reactive species were the main reason for the high efficiency of DBD plasma. For instance, both hydroxyl radicals (•OH) and electrons (e-) could initiate the degradation of HCHs, while other reactive species such as 1O2 and ONOOH played important roles in the decomposition of intermediates. Therefore, the present study not only provided an effective approach for the treatment of HCHs, but also revealed the underlying mechanism based on in-depth experimental investigation and theoretical calculation.