Paranthropus robustus tooth chipping patterns do not support regular hard food mastication

Enamel chipping and its ecological correlates in African papionins: Implications for hominin feeding behavior

African papionins are classic paleoecological referents for fossil hominins. Enamel chips on the teeth of baboons and hominins are argued to represent responses to similar dietary habits; however, a comprehensive analysis of modern papionin chipping is lacking, leaving open the question of analog suitability. Here, we investigate patterns of antemortem enamel chipping across a diverse set of African papionin species occupying a range of ecological niches. We compare papionin chipping frequencies to estimates for Plio-Pleistocene hominins to address hypotheses of habitat and/or dietary similarities. Antemortem chips in seven African papionin species were scored on intact postcanine teeth (P3-M3) using established protocols. Chip size was scored on a tripartite scale. Papio hamadryas and Papio ursinus-two common paleoecological referents-display higher levels of chipping than Plio-Pleistocene hominin taxa (Australopithecus and Paranthropus) posited to have similar dietary habits. Papio populations occupying dry or highly seasonal habitats accumulate more large chips than Papio taxa occupying more mesic habitats, and terrestrial papionins chip their teeth more often than closely related taxa occupying arboreal niches. Chipping is present on the teeth of all Plio-Pleistocene hominins; however, chipping in baboons (P. ursinus and P. hamadryas) consistently exceeds most hominin taxa. Chipping frequencies on their own do not reliably sort taxa into major dietary groupings. We conclude that the large differences in chipping frequency may instead reflect habitat use and food processing idiosyncrasies. Less chipping in Plio-Pleistocene hominin teeth compared to modern Papio is more likely attributable to differences in dental morphology rather than diet.

Variability in molar crown morphology and cusp wear in two Western chimpanzee populations

OBJECTIVES

Chimpanzees (Pan troglodytes) possess a relatively generalized molar morphology allowing them to access a wide range of foods. Comparisons of crown and cusp morphology among the four subspecies have suggested relatively large intraspecific variability. Here, we compare molar crown traits and cusp wear of two geographically close populations of Western chimpanzees, P. t. verus, to provide further information on intraspecific dental variability.

MATERIALS AND METHODS

Micro-CT reconstructions of high-resolution replicas of first and second molars of two Western chimpanzee populations from Ivory Coast (Taï National Park) and Liberia, respectively were used for this study. First, we analyzed projected tooth and cusp 2D areas as well as the occurrence of cusp six (C6) on lower molars. Second, we quantified the molar cusp wear three-dimensionally to infer how the individual cusps alter with advancing wear.

RESULTS

Both populations are similar in their molar crown morphology, except for a higher appearance rate of a C6 in Taï chimpanzees. In Taï chimpanzees, lingual cusps of upper molars and buccal cusps of lower molars possess an advanced wear pattern compared to the remaining cusps, while in Liberian chimpanzees this wear gradient is less pronounced.

DISCUSSION

The similar crown morphology between both populations fits with previous descriptions for Western chimpanzees and provides additional data on dental variation within this subspecies. The wear pattern of the Taï chimpanzees are in concordance with their observed tool rather than tooth use to open nuts/seeds, while the Liberian chimpanzees may have consumed hard food items crushed between their molars.

Estimates of absolute crown strength and bite force in the lower postcanine dentition of Gigantopithecus blacki

Gigantopithecus blacki is hypothesized to have been capable of processing mechanically challenging foods, which likely required this species to have high dental resistance to fracture and/or large bite force. To test this hypothesis, we used two recently developed approaches to estimate absolute crown strength and bite force of the lower postcanine dentition. Sixteen Gigantopithecus mandibular permanent cheek teeth were scanned by micro-computed tomography. From virtual mesial cross-sections, we measured average enamel thickness and bi-cervical diameter to estimate absolute crown strength, and cuspal enamel thickness and dentine horn angle to estimate bite force. We compared G. blacki with a sample of extant great apes (Pan, Pongo, and Gorilla) and australopiths (Australopithecus anamensis, Australopithecus afarensis, Australopithecus africanus, Paranthropus robustus, and Paranthropus boisei). We also evaluated statistical differences in absolute crown strength and bite force between the premolars and molars for G. blacki. Results reveal that molar crown strength is absolutely greater, and molar bite force absolutely higher, in G. blacki than all other taxa except P. boisei, suggesting that G. blacki molars have exceptionally high resistance to fracture and the ability to generate exceptionally high bite force. In addition, G. blacki premolars have comparable absolute crown strength and larger bite force capabilities compared with its molars, implying possible functional specializations in premolars. The dental specialization of G. blacki could thus represent an adaptation to further facilitate the processing of mechanically challenging foods. While it is currently not possible to determine which types of foods were actually consumed by G. blacki through this study, direct evidence (e.g. dental chipping and microwear) left by the foods eaten by G. blacki could potentially lead to greater insights into its dietary ecology.

Tooth chipping patterns in Archaeolemur provide insight into diet and behavior

OBJECTIVES

Archaeolemur is a recently extinct genus of lemur that is often compared to some Cercopithecidae, especially baboons. This is due in part to their derived dentition, with large anterior teeth and reduced bilophodont molars. Research involving comparative morphology, analysis of coprolites, isotopes, and enamel structure, have suggested Archaeolemur had an omnivorous diet involving mechanically challenging items. Yet, microwear analysis of posterior teeth does not necessarily support this conclusion.

MATERIALS AND METHODS

In this macroscopic study, dental chipping was recorded on permanent teeth of Archaeolemur from different localities (53 individuals; 447 permanent teeth; including both A. edwardsi and A. majori specimens). This study aimed to compare chipping patterns across the dentition of Archaeolemur with chipping in other primates.

RESULTS

The results show enamel chipping was prevalent on the anterior teeth of Archaeolemur (38.9% of anterior teeth showed at least one fracture) yet rare in posterior teeth (9%). There was a decrease in chipping frequency across the dentition, moving distally from incisors (50%; 20/40), through caniniform teeth (30%; 15/50), premolars (9.5%; 16/169), and molars (8.5%; 16/188).

DISCUSSION

The results support previous research suggesting Archaeolemur had a varied omnivorous diet in which the anterior dentition was used for extensive food processing. This likely included mechanically challenging items such as tough/hard large fruits, small vertebrates, and crustaceans. Such a high rate of chipping in the anterior dentition is uncommon in other primates, with exception of hominins.