Use of continuous horizontal mattress suture techniques in microsurgery: an experimental study in rats

Comparison of total anastomosis time between four different combinations of suturing and knot tying techniques in microsurgical anastomosis

BACKGROUND

Various techniques have been described for performing microsurgical anastomosis with providing high patency rates. Although the total anastomotic time may not be an issue when dealing with a single set of anastomoses, using a faster technique may save significant amount of time in cases of transferring flaps with shorter critical ischemia time or where multiple anastomoses are required. This study compares the total anastomosis time between four different combinations of commonly used suturing and knot tying techniques.

METHODS

Twenty-four rats were divided into 4 groups. Simple interrupted suture with conventional knot tying technique (SIS-CT) was used in group I, continuous suture technique with conventional knot tying (CST) was used in group II, simple interrupted suture with airborne knot tying technique(SIS-AT) was used in group III, and continuous-interrupted suture with airborne knot tying technique(CIS-AT) was used in group IV for microsurgical anastomosis. Total anastomosis time and patency rates with each technique and samples from anastomotic sites were analyzed.

RESULTS

The mean time required for microvascular anastomosis of the femoral artery was 1075 s in group I, 799 s in group II, 844 s in group III, and 973 s in group IV. The difference between four groups was statistically significant. The anastomoses in group II and group III were completed in the shortest period of time. Intergroup comparison revealed that the difference between group II and group III was not statistically significant, however, total anastomosis time for completion of the anastomosis was significantly longer for group I, followed by group IV. Thrombosis rates and histological analysis revealed no significant differences among four groups.

CONCLUSION

CST and SIS-AT techniques can significantly reduce microsurgical anastomosis time and provide high patency rates. Also, the time needed to complete an anastomosis was significantly shorter for CIS-AT when compared to SIS-CT.

Simple Interrupted Microvascular Anastomosis: Review of Four Sutures Placement Sequences

Background Microsurgical anastomosis is a delicate, highly nuanced procedure that can be done in several different ways; the most basic approach to performing microsurgical anastomoses is by using simple interrupted sutures, but even within that approach, there are different sequences by which the sutures can be placed. To date, there is no review of these sequences and the advantages and disadvantages of each.

Methods A PubMed search was performed in October 2019 that sought all published descriptions of simple interrupted microsurgery techniques. Keywords included were “microvascular anastomosis,” “microvascular anastomosis technique,” “simple interrupted,” and “microsurgery.”

Results Four simple interrupted microsurgery techniques were identified: triangulation, 12 o'clock to 6 o'clock, posterior-wall-first, and 3 o'clock to 9 o'clock-side-side. Additionally, there is no uniform nomenclature that describes the techniques for simple interrupted microvascular anastomoses.

Conclusion This study identified four distinct sequences for the placement of simple interrupted sutures for microsurgical anastomosis and the advantages and disadvantages of each, and for the first time described them utilizing standardized nomenclature.

Unfavourable results in free tissue transfer

With recent advances in the instrumentation and with increased expertise the results of microvascular surgery are getting better. Complications though, cannot be completely avoided. This paper gives a brief introduction to the possible complications at various stages of free tissue transfer. With careful planning and execution and vigilant postoperative care the overall success rate can be improved.

Mattress anastomosis in micro vascular reconstruction: technical note

BACKGROUND

Superficial temporal artery-to-middle cerebral artery (STA-MCA) anastomosis is a common procedure for neurosurgeons. The surgery necessarily requires accurate and speedy manipulation of microscope, for which a specific training is needed. Unexpected bypass occlusion sometimes happen during surgery.

OBJECTIVE

Generally, conventional interrupted or continuous suture has been used for vascular anastomosis, despite various ideas have been attempted in the other surgery fields. We propose a horizontal mattress suture technique for intracranial microvascular bypass surgery. This is the first report ever published on intracranial vascular anastomosis.

METHODS

We had four patients of STA-MCA bypass surgery with "mattress anastomosis" from March to May of 2012.

RESULTS

During the procedure, there was no bypass occlusion and good patency was confirmed in all cases.

CONCLUSION

Intimae of the recipient and the donor blood vessel contact each other precisely with this technique. Although a long-term assessment of patency is needed, it is useful for the intracranial bypass surgery.

Use of continuous horizontal mattress suture technique in end-to-side microsurgical anastomosis

PURPOSE

The aim of our study was to improve the new suturing method which increases the success rate of end to side microsurgical anastomosis.

METHODS

Thirty-six Sprague-Dawrey rats were randomly divided into three groups that consist of 12 rats in closed envelope method. The end-to-side microsurgical anastomosis procedures were applied by the same surgeon between left main carotid artey and left external jugular vein. The surgical evaluations were performed with anastomosis duration, leakage evaluation, vessels patency, aneurysm improvement and histological assesment.

RESULTS

End-to-side anastomosis, which was applied with Continuous Horizontal Mattress suture, gave significantly better results in terms of leakage, anastomosis openness, aneurysm and histologic assesment. Also anastomosis duration of Continuous Horizontal suture was significantly faster than Simple Intermittent suture.

DISCUSSION

Our study revealed that the Continuous Horizontal Mattress suture technique had the advantages of providing uninterrupted vessel flow in a shorter time, and minimal intraluminal suture material, which increase thrombosis risk. Also 'sac-mouth' effect of Continuous suture technique was prevented by Horizontal Mattress technique.

From simple interrupted to complex spiral: a systematic review of various suture techniques for microvascular anastomoses

Accomplishing successful microvascular anastomoses is undoubtedly one of the most critical steps in performing free tissue transfer. However, the ideal technique has often been a subject of debate. Therefore, our objective was to review the current literature in an attempt to find objective evidence supporting the superiority of one particular technique. A PubMed and OVID on-line search was performed in November 2007 using the following keywords: microvascular anastomoses, microsurgical anastomosis, continuous suture, interrupted suture, mattress suture, and sleeve anastomosis. Our literature review found no difference in short- and/or long-term patency rates between the six main published techniques, which includes continuous suture, interrupted suture, locking continuous, continuous horizontal, horizontal interrupted with eversion, and sleeve anastomoses. These findings were consistent for each technique as long as the microsurgeon maintained standard microsurgical principles and practice, including suture line eversion, minimized tension, and direct intima-to-intima contact. Current literature supports no overall statistical difference in short- and/or long-term patency rates between any of the various techniques. The choice to perform one suture technique over another ultimately depends on the plastic surgeon's preference and microsurgical experience. To date, there are no human randomized, controlled clinical trials comparing the efficacy and clinical outcomes of each of the various suture techniques, and therefore one's comfort and familiarity should dictate his or her microsurgical technique. However, "exposure to many and mastery of one" simply provides the plastic surgery resident, fellow, or staff the technical flexibility needed for less-complicated surgical planning when performing free tissue transfer.

Clinical and pathological assessment of different suture techniques for microvascular anastomosis in rat femoral artery

This study examined the clinical and pathological features after a microvascular anastomosis of a rat femoral artery using four different suture techniques. Sixty Sprage-Dawely rats were divided randomly into 4 groups. Fifteen bisected arteries (one from each animal) in Group I, II, III and IV were sutured with the simple interrupted suture, continuous suture, sleeve suture and cuff suture, respectively. The anastomosis times in Group I, II, III and IV were 28.67, 14.67, 15.47 and 15.93 min, respectively. Immediate bleeding that stopped without intervention (grade I) was observed in 67%, 73% and 60% of the anastomosed vessels in Groups II, III and IV, respectively, while 60% of the vessels in Group I showed light bleeding that was inhibited by gentile pressure (grade II). All vessels examined appeared to be patent at 5 and 15 min after the anastomosis. On the 7th day postoperatively, the vessels of Group I showed the highest patency rate (93%) compared with Groups II (67%), III (73%) and IV (87%). Moreover, there were more pronounced pathological changes in Group I than in the other groups. These changes included endothelial loss, endothelial proliferation, degeneration and necrosis of the tunica media. Suture materials surrounded by an inflammatory reaction were also observed. In conclusion, the simple interrupted suture is preferable for microvascular anastomosis due to its highest patency rate. The other techniques investigated can be good alternatives because of their short anastomotic time and moderate pathological changes.