Selective determination of Sm (III) in lanthanide mixtures by thermal lens microscopy

Accuracy of Measurements of Thermophysical Parameters by Dual-Beam Thermal-Lens Spectrometry

Thermal-lens spectrometry is a sensitive technique for determination of physicochemical properties and thermophysical parameters of various materials including heterogeneous systems and nanoparticles. In this paper, we consider the issues of the correctness (trueness) of measurements of the characteristic time of the thermal-lens effect and, thus, of the thermal diffusivity determined by dual-beam mode-mismatching thermal lensing. As sources of systematic errors, major factors-radiation sources, sample-cell and detector parameters, and general measurement parameters-are considered using several configurations of the thermal-lens setups, and their contributions are quantified or estimated. Furthermore, with aqueous ferroin and Sudan I in ethanol as inert colorants, the effects of the intermolecular distance of the absorbing substance on the correctness of finding the thermophysical parameters are considered. The recommendations for checking the operation of the thermal-lens setup to ensure the maximum accuracy are given. The results obtained help reducing the impact of each investigated factor on the value of systematic error and correctly measure the thermophysical parameters using thermal-lens spectrometry.

An Optical Configuration of Crossed-Beam Photothermal Lens Spectrometer Operating at High Flow Velocities and Its Application for Cysteine Determination in Human Serum and Saliva

Photothermal lens spectrometry (TLS) is a high sensitive technique for trace determination of nonfluorescent materials. Previous photothermal lens spectrometers suffer from operating limitations at high flow velocities, arising from taking the heated element off the probe beam direction, which results in a decrease in the thermal lens (TL) signal. Herein, we describe an optical configuration of the crossed-beam photothermal lens in transversal flow mode in which the propagating direction of the probe beam and liquid sample flow azimuth are concentric (CBTC). The system consists of a microfluidic cell with a volume of lower than 3 μL. In the current optical configuration, using 1-(2-pyridylazo)-2-naphthol (PAN) in ethanol as a test solution, by increasing the sample flow velocity and without increasing chopping frequency, the reduction in sensitivity is less pronounced. Under a 15 Hz chopping frequency, the optimum sample flow velocity is about 2 cm s^-1, which is among the highest reported values achieved to date for photothermal lens spectrometers. Although the system operates at higher flow velocities and lower chopping frequencies compared to the collinear configuration, it provides a comparable analytical limit of detection. This optical configuration has been successfully employed for highly sensitive and selective determination of cysteine in human serum and saliva samples through a competitive complexation reaction with Cu-PAN as a colorimetric probe. The detection limit of this method (9.5 nM) shows a significant enhancement (726-times) in comparison to UV-vis measurements.

Laser induced thermal lens microscopy for highly sensitive determination of captopril

In this work, a combined flow injection-photo thermal lens microscopy (FI-PTLM) system was used for highly sensitive determination of captopril as an angiotensin-converting enzyme inhibitor. Captopril has no absorption in the visible range, but due to its thiol group could interact with gold nanoparticles (GNPs). GNPs, because of their surface plasmon resonance (SPR), have absorption in the visible range, but their interaction with a low concentration of captopril shows no effective change in UV-Vis spectrophotometry because their aggregation is slight. On the contrary, at the same condition, the PTLM with a visible light source enables sensitive measurement of this compound. The thiol group of captopril binds to the surface of GNPs and decreases the SPR. At the optimum condition in the focal volume of 2.68 fL (f=10^-15), the obtained range of linearity was 50-800 nM. The developed method was successfully applied for the determination of captopril in human serum and pharmaceutical samples.