Effect of embedded chalcogenide quantum dots in PbBr2 film on CsPbBr3 inorganic perovskite solar cells

Nanocrystals as performance-boosting materials for solar cells

Nanocrystals (NCs) have been widely studied owing to their distinctive properties and promising application in new-generation photoelectric devices. In photovoltaic devices, semiconductor NCs can act as efficient light harvesters for high-performance solar cells. Besides light absorption, NCs have shown great significance as functional layers for charge (hole and electron) transport and interface modification to improve the power conversion efficiency and stability of solar cells. NC-based functional layers can boost hole/electron transport ability, adjust energy level alignment between a light absorbing layer and charge transport layer, broaden the absorption range of an active layer, enhance intrinsic stability, and reduce fabrication cost. In this review, recent advances in NCs as a hole transport layer, electron transport layer, and interfacial layer are discussed. Additionally, NC additives to improve the performance of solar cells are demonstrated. Finally, a summary and future prospects of NC-based functional materials in solar cells are presented, addressing their limitations and suggesting potential solutions.

Synthesis and Characterization of High-Efficiency Halide Perovskite Nanomaterials for Light-Absorbing Applications

Inorganic perovskite materials are possible candidates for conversion of solar energy to electrical energy due to their high absorption coefficient. Perovskite solar cells (PSCs) introduced a new type of device structure that has attention due to better efficiencies and interest in PSCs that has been increasing in recent years. Halide perovskite materials such as CsPbIBr₂ show remarkable optical and structural performance with their better physical properties. Perovskite solar cells are a possible candidate to replace conventional silicon solar panels. In the present study, CsPbIBr₂ perovskite materials' thin films were prepared for light-absorbing application. Five thin films were deposited on the glass substrates by subsequent spin-coating of CsI and PbBr₂ solutions, subsequently annealed at different temperature values (as-deposited, 100, 150, 200 and 250 °C) to get CsPbIBr₂ thin films with a better crystal structure. Structural characterizations were made by using X-ray diffraction. CsPbIBr₂ thin films were found to be polycrystalline in nature. With increasing annealing temperature, the crystallinity was improved, and the crystalline size was increased. Optical properties were studied by using transmission data, and by increasing annealing temperature, a small variation in optical band gap energy was observed in the range of 1.70-1.83 eV. The conductivity of CsPbIBr₂ thin films was determined by a hot probe technique and was found to have little fluctuating response toward p-type conductivity, which may be due to intrinsic defects or presence of CsI phase, but a stable intrinsic nature was observed. The obtained physical properties of CsPbIBr₂ thin films suggest them as a suitable candidate as a light-harvesting layer. These thin films could be an especially good partner with Si or other lower band gap energy materials in tandem solar cells (TSC). CsPbIBr₂ material will harvest light having energy of ∼1.7 eV or higher, while a lower energy part of the solar spectrum will be absorbed in the partner part of the TSC.

Fabrication of single phase CsPbBr3 films via in situ metal reaction

We developed an in situ metal reaction strategy to fabricate single phase CsPbBr₃ films by reacting Pb precursors with a mixture of CsBr and HBr. The purity of the CsPbBr₃ film can be controlled by tuning the thickness of sputtered Pb.