Simulation and electrochemical impedance spectroscopy of dye-sensitized solar cells

Electrochemical Impedance Investigation of Dye-Sensitized Solar Cells Based on Electrospun TiO2 Nanofibers Photoanodes

This work investigates an electrochemical impedance analysis based on synthesized TiO₂ nanofibers (NFs) photoanodes, which were fabricated via electrospinning and calcination. The investigated photoanode substrate NFs were studied in terms of physicochemical tools to investigate their morphological character, crystallinity, and chemical contents via scanning electron microscope (SEM), X-ray photoelectron spectroscopy (XPS), and X-ray diffraction (XRD) analyses. As a result, the studied photoanode substrate NFs were applied to fabricate dye-sensitized solar cells (DSCs), and the electrochemical impedance analysis (EIS) was studied in terms of equivalent circuit fitting and impacts of N-doping, the latter of which was approved via XPS analysis. N-doping has a considerable role in the enhancement of charge transfers, which could be due to the strong interactions between active-site N atoms and the used photosensitizer.

Synthesis and Characterization of High-Efficiency Halide Perovskite Nanomaterials for Light-Absorbing Applications

Inorganic perovskite materials are possible candidates for conversion of solar energy to electrical energy due to their high absorption coefficient. Perovskite solar cells (PSCs) introduced a new type of device structure that has attention due to better efficiencies and interest in PSCs that has been increasing in recent years. Halide perovskite materials such as CsPbIBr₂ show remarkable optical and structural performance with their better physical properties. Perovskite solar cells are a possible candidate to replace conventional silicon solar panels. In the present study, CsPbIBr₂ perovskite materials' thin films were prepared for light-absorbing application. Five thin films were deposited on the glass substrates by subsequent spin-coating of CsI and PbBr₂ solutions, subsequently annealed at different temperature values (as-deposited, 100, 150, 200 and 250 °C) to get CsPbIBr₂ thin films with a better crystal structure. Structural characterizations were made by using X-ray diffraction. CsPbIBr₂ thin films were found to be polycrystalline in nature. With increasing annealing temperature, the crystallinity was improved, and the crystalline size was increased. Optical properties were studied by using transmission data, and by increasing annealing temperature, a small variation in optical band gap energy was observed in the range of 1.70-1.83 eV. The conductivity of CsPbIBr₂ thin films was determined by a hot probe technique and was found to have little fluctuating response toward p-type conductivity, which may be due to intrinsic defects or presence of CsI phase, but a stable intrinsic nature was observed. The obtained physical properties of CsPbIBr₂ thin films suggest them as a suitable candidate as a light-harvesting layer. These thin films could be an especially good partner with Si or other lower band gap energy materials in tandem solar cells (TSC). CsPbIBr₂ material will harvest light having energy of ∼1.7 eV or higher, while a lower energy part of the solar spectrum will be absorbed in the partner part of the TSC.