In vivo assessment of material properties of muscles and connective tissues around the knee joint based on shear wave elastography

Mechanical properties change of immobilized skeletal muscle in short position measured by shear wave elastography and pure shearing test

The purpose of this study was to evaluate the effects of immobilization on mechanical properties of skeletal muscle over the time. An in vivo rat model was used to investigate the shear modulus change of the flexor carpi ulnaris (FCU) in a short position. Measurements were performed by shear wave elastography (SWE) to compare contralateral and immobilized cases. The results showed a significant increase of 18.1% (p = 3.86. 10-7) in the shear modulus of immobilized skeletal muscle after two weeks (D14) when compared with the contralateral case. For the purposes of comparison, in vitro mechanical pure shearing tests were performed on samples collected from the skeletal muscles of the same rats. Although the difference between contralateral and immobilized cases was 17.6% (p = 0.32) at D14, the shear modulus difference was 35.7% (p = 0.0126 and p = 1.57.10-5 for immobilization and contralateral respectively) between in vivo and in vitro approaches. The mechanical properties changes were then correlated with the density of collagen from histological analysis, and it was shown that the contralateral collagen surface density was 25.4% higher than the immobilized density at D14 (p = 0.001). Thus, the results showed the feasibility of the comparison between the two approaches, which can surely be improved by optimizing the experimental protocols.

Reliability of shear-wave elastography in assessing the stiffness of the nuchal fascia and the thickness of upper cervical muscles

OBJECTIVE

To determine the reliability of shear-wave elastography (SWE)in assessing the stiffness of the nuchal fascia and the thickness of upper cervical muscles in neutral head posture (NHP) or forward head posture (FHP).

METHODS

Sixteen healthy adults (mean age: 21.69 ± 1.01years, 9 females) were included. SWE mode was chosen to measure the nuchal fascia shear modulus and muscle thickness was measured in B-mode. Measurements were collected by two independent investigators on two different days. The intraclass correlation coefficient (ICC) was used to measure the relative reliability, and the standard error of measurement (SEM) were used to measure the absolute reliability.

RESULTS

Intra‑rater (ICC = 0.63-0.89) and inter-rater (ICC = 00.54-0.82) reliability for the nuchal fascia shear modulus were moderate to excellent. Intra‑rater (ICC = 00.64-0.96) and inter-rater (ICC = 00.48-0.86) reliability for upper cervical muscles thickness were moderate to excellent. The SEM percentage oscillated from 3.27% to 13.55%. There were significant differences(P < 0.05) between NHP and FHP on nuchal fascia shear modulus, right side splenius capitis muscle thickness and left side semispinalis capitis muscle thickness, but no significant differences(P > 0.05) were observed between the right and left sides. The upper cervical muscles thickness of males was significantly thicker(P < 0.01) than females while no significant differences were observed (P > 0.05) on the nuchal fascia shear modulus.

CONCLUSIONS

Ultrasound-based SWE may be a reliable tool for assessing the stiffness of the nuchal fascia and the thickness of upper cervical muscles in clinical practice.

REGISTRATION NUMBER

ChiCTR2200055736.

Acute Effects of Running on Shear Wave Elastography Measures of the Achilles Tendon and Calf Muscles in Professional Female Handball and Volleyball Players

Shear Wave Elastography (SWE) is currently used to detect tissue pathologies, i.e., tendinopathy. For preventive medicine, it is important to examine the sensitivity of SWE and to investigate how stiffness measures are affected by methodological variables. The aim of this study is to examine shear wave elastography (SWE) measures in order to compare the pre- and post-running values and to determine the correlation between the shear wave speed values (m/s). SWE examinations of the Achilles tendon (AT), soleus muscle (MS) and gastrocnemius muscle (MG)) were performed in 24 healthy professional female athletes. Measurements of the shear wave speed (m/s) were taken before and after incremental treadmill running until exhaustion. Correlations were investigated using the Pearson correlation coefficient and were examined for significance using the Student's t-test. The pre- and post-exercise shear wave speed did not differ. The pre-exercise and post-exercise stiffness for MS (r = 0.613), MG (r = 0.609) and AT (r = 0.583) correlated strongly. The pre-exercise values and changes in stiffness showed a significant correlation (p < 0.001). In professional athletes, acute exercise induces different tissue stiffness changes in AT, MS and MG for each individual. Thus, exercise activity immediately prior to the SWE measurement needs to be factored in when evaluating tissue stiffness.

Knee instability caused by altered graft mechanical properties after anterior cruciate ligament reconstruction: the early onset of osteoarthritis?

Anterior cruciate ligament (ACL) rupture is a very common knee joint injury. Torn ACLs are currently reconstructed using tendon autografts. However, half of the patients develop osteoarthritis (OA) within 10 to 14 years postoperatively. Proposedly, this is caused by altered knee kine(ma)tics originating from changes in graft mechanical properties during the in vivo remodeling response. Therefore, the main aim was to use subject-specific finite element knee models and investigate the influence of decreasing graft stiffness and/or increasing graft laxity on knee kine(ma)tics and cartilage loading. In this research, 4 subject-specific knee geometries were used, and the material properties of the ACL were altered to either match currently used grafts or mimic in vivo graft remodeling, i.e., decreasing graft stiffness and/or increasing graft laxity. The results confirm that the in vivo graft remodeling process increases the knee range of motion, up to >300 percent, and relocates the cartilage contact pressures, up to 4.3 mm. The effect of remodeling-induced graft mechanical properties on knee stability exceeded that of graft mechanical properties at the time of surgery. This indicates that altered mechanical properties of ACL grafts, caused by in vivo remodeling, can initiate the early onset of osteoarthritis, as observed in many patients clinically.

Quantification of the in vivo stiffness and natural length of the human plantar aponeurosis during quiet standing using ultrasound elastography

This study aimed to identify the stiffness and natural length of the human plantar aponeurosis (PA) during quiet standing using ultrasound shear wave elastography. The shear wave velocity (SWV) of the PA in young healthy males and females (10 participants each) was measured by placing a probe in a hole in the floor plate. The change in the SWV with the passive dorsiflexion of the metatarsophalangeal (MP) joint was measured. The Young's modulus of the PA was estimated to be 64.7 ± 9.4 kPa, which exponentially increased with MP joint dorsiflexion. The PA was estimated to have the natural length when the MP joint was plantarflexed by 13.8°, indicating that the PA is stretched by arch compression during standing. However, the present study demonstrated that the estimated stiffness for the natural length in quiet standing was significantly larger than that in the unloaded condition, revealing that the PA during standing is stiffened by elongation and through the possible activation of intrinsic muscles. Such quantitative information possibly contributes to the detailed biomechanical modeling of the human foot, facilitating an improved understanding of the mechanical functions and pathogenetic mechanisms of the PA during movements.

Effect of hip and knee joint angles on resting hamstring muscles rigidity in men and women

PURPOSE

Hamstring muscle strains are one of the most common injuries in sports practice, for both men and women. However, sex disparities in the rate of muscle injuries have been observed. As these muscular injuries usually occur at long muscle length, this study aimed to determine the effect of sex on hamstring muscles' resting rigidity under different stretching conditions.

METHODS

The shear wave speed (SWS) of resting hamstring muscles was measured in 12 men and 12 women in different hip and knee positions (hip extended with knee flexed, hip flexed with knee extended, both joints extended and both joints flexed).

RESULTS

Combining all the positions, the SWS of the semitendinosus was higher in men than in women (2.96 vs. 2.71 m.s^-1). Regardless of sex, a significant rise in SWS was systematically observed when the semimembranosus was stretched (1.86, 2.37, 2.76 and 4.39 m.s^-1) but it was neither the case for the semitendinosus (p = 0.82) nor for the biceps femoris (p = 0.50). Finally, differences in SWS among the hamstring muscles were only observed at the longest muscle length, with greater SWS values for the semimembranosus and semitendinosus in comparison with the biceps femoris (4.39 and 4.12 vs. 3.38 m.s^-1 respectively).

CONCLUSION

In conclusion, a sex difference was only observed in the resting semitendinosus rigidity. Independently of sex, the increase in resting hamstring muscles SWS with stretch was muscle specific.

Sensitivity of the shear wave speed-stress relationship to soft tissue material properties and fiber alignment

The use of shear wave propagation to noninvasively measure material properties and loading in tendons and ligaments is a growing area of interest in biomechanics. Prior models and experiments suggest that shear wave speed primarily depends on the apparent shear modulus (i.e., shear modulus accounting for contributions from all constituents) at low loads, and then increases with axial stress when axially loaded. However, differences in the magnitudes of shear wave speeds between ligaments and tendons, which have different substructures, suggest that the tissue's composition and fiber alignment may also affect shear wave propagation. Accordingly, the objectives of this study were to (1) characterize changes in the apparent shear modulus induced by variations in constitutive properties and fiber alignment, and (2) determine the sensitivity of the shear wave speed-stress relationship to variations in constitutive properties and fiber alignment. To enable systematic variations of both constitutive properties and fiber alignment, we developed a finite element model that represented an isotropic ground matrix with an embedded fiber distribution. Using this model, we performed dynamic simulations of shear wave propagation at axial strains from 0% to 10%. We characterized the shear wave speed-stress relationship using a simple linear regression between shear wave speed squared and axial stress, which is based on an analytical relationship derived from a tensioned beam model. We found that predicted shear wave speeds were both in-range with shear wave speeds in previous in vivo and ex vivo studies, and strongly correlated with the axial stress (R² = 0.99). The slope of the squared shear wave speed-axial stress relationship was highly sensitive to changes in tissue density. Both the intercept of this relationship and the apparent shear modulus were sensitive to both the shear modulus of the ground matrix and the stiffness of the fibers' toe-region when the fibers were less well-aligned to the loading direction. We also determined that the tensioned beam model overpredicted the axial tissue stress with increasing load when the model had less well-aligned fibers. This indicates that the shear wave speed increases likely in response to a load-dependent increase in the apparent shear modulus. Our findings suggest that researchers may need to consider both the material and structural properties (i.e., fiber alignment) of tendon and ligament when measuring shear wave speeds in pathological tissues or tissues with less well-aligned fibers.