An advanced EPR stopped-flow apparatus based on a dielectric ring resonator

Temperature-cycle electron paramagnetic resonance

We report on a novel approach to the study of rates and short-lived intermediates of (bio)chemical reactions that involve paramagnetic species. Temperature-cycle Electron Paramagnetic Resonance (EPR) concerns the repeated heating of a reaction mixture in the cavity of an EPR spectrometer by pulsed irradiation with a near-infrared diode laser combined with intermittent characterization of the sample by 275 GHz EPR at a lower temperature at which the reaction does not proceed. The new technique is demonstrated for the reduction of TEMPOL with sodium dithionite in aqueous solution down to the sub-second time scale. We show that a single sample suffices to obtain a complete kinetic trace. Variation of the length and power of the laser pulse offers great flexibility as regards the time scale of the experiment and the temperature at which the reaction can be studied. For water/glycerol mixtures we introduce a simple way to obtain and load an unreacted sample into the spectrometer at low temperature.

Nonresonant Transmission Line Probe for Sensitive Interferometric Electron Spin Resonance Detection

Electron spin resonance (ESR) spectroscopy measures paramagnetic free radicals, or electron spins, in a variety of biological, chemical, and physical systems. Detection of diverse paramagnetic species is important in applications ranging from quantum computation to biomedical research. Countless efforts have been made to improve the sensitivity of ESR detection. However, the improvement comes at the cost of experimental accessibility. Thus, most ESR spectrometers are limited to specific sample geometries and compositions. Here, we present a nonresonant transmission line ESR probe (microstrip geometry) that effectively couples high frequency microwave magnetic field into a wide range of sample geometries and compositions. The nonresonant transmission line probe maintains detection sensitivity while increasing availability to a wider range of applications. The high frequency magnetic field homogeneity is greatly increased by positioning the sample between the microstrip signal line and the ground plane. Sample interfacing occurs via a universal sample holder which is compatible with both solid and liquid samples. The unavoidable loss in sensitivity due to the nonresonant nature of the transmission line probe (low Q) is recuperated by using a highly sensitive microwave interferometer-based detection circuit. The combination of our sensitive interferometer and nonresonant transmission line provides similar sensitivity to a commercially available ESR spectrometer equipped with a high-Q resonator. The nonresonant probe allows for transmission, reflection, or dual-mode detection (transmission and reflection), where the dual-mode results in a √2 signal enhancement.

EPR studies on the kinetics of the α-hydroxyethyl radical generated by Fenton-like chemistry

Flow systems, either stopped or continuous, have long been at the core of kinetic studies of chemical reactions. Such flow systems need to be coupled with appropriate spectroscopic or otherwise techniques for the detection of the chemical species studied. If paramagnetic species are formed or consumed during the investigated reaction, electron paramagnetic resonance (EPR) with its nanomolar sensitivity can be the spectroscopic method of choice. However, not much literature is available on the application of EPR to quantitatively study kinetics of chemical reactions in the liquid state. Herein, we report the characterisation of the commercially available mixing resonator ER 4117 MX from Bruker using the TEMPO-dithionite reaction as a standard. Furthermore, this setup was used to study the kinetics of the Fenton-like system of TiCl3/H2O2 and ethanol forming theα-hydroxyethyl radical. Potential contributions of reactions with O2, H2O2, Ti(3+/4+), and self-recombination in the decay of theα-hydroxyethyl radical were investigated and the bimolecular decay was shown to be the dominant decay pathway, with a decay rate constant of 6.6×10(8) M(-1) s(-1). This study shows the effectiveness and capabilities of EPR as a direct, sensitive and in-situ method in kinetic studies.

Exploring the radical nature of a carbon surface by electron paramagnetic resonance and a calibrated gas flow

While the first Electron Paramagnetic Resonance (EPR) studies regarding the effects of oxidation on the structure and stability of carbon radicals date back to the early 1980s the focus of these early papers primarily characterized the changes to the structures under extremely harsh conditions (pH or temperature)(1-3). It is also known that paramagnetic molecular oxygen undergoes a Heisenberg spin exchange interaction with stable radicals that extremely broadens the EPR signal(4-6). Recently, we reported interesting results where this interaction of molecular oxygen with a certain part of the existing stable radical structure can be reversibly affected simply by flowing a diamagnetic gas through the carbon samples at STP(7). As flows of He, CO2, and N2 had a similar effect these interactions occur at the surface area of the macropore system. This manuscript highlights the experimental techniques, work-up, and analysis towards affecting the existing stable radical nature in the carbon structures. It is hoped that it will help towards further development and understanding of these interactions in the community at large.

A novel microfluidic rapid freeze-quench device for trapping reactions intermediates for high field EPR analysis

Rapid freeze quench electron paramagnetic resonance (RFQ)-EPR is a method for trapping short lived intermediates in chemical reactions and subjecting them to EPR spectroscopy investigation for their characterization. Two (or more) reacting components are mixed at room temperature and after some delay the mixture is sprayed into a cold trap and transferred into the EPR tube. A major caveat in using commercial RFQ-EPR for high field EPR applications is the relatively large amount of sample needed for each time point, a major part of which is wasted as the dead volume of the instrument. The small sample volume (∼2μl) needed for high field EPR spectrometers, such as W-band (∼3.5T, 95GHz), that use cavities calls for the development of a microfluidic based RFQ-EPR apparatus. This is particularly important for biological applications because of the difficulties often encountered in producing large amounts of intrinsically paramagnetic proteins and spin labeled nucleic acid and proteins. Here we describe a dedicated microfluidic based RFQ-EPR apparatus suitable for small volume samples in the range of a few μl. The device is based on a previously published microfluidic mixer and features a new ejection mechanism and a novel cold trap that allows collection of a series of different time points in one continuous experiment. The reduction of a nitroxide radical with dithionite, employing the signal of Mn(2+) as an internal standard was used to demonstrate the performance of the microfluidic RFQ apparatus.

The importance of methylation in the binding of (ferrocenylmethyl)tempammonium guests by cucurbit[n]uril (n = 7, 8) hosts

The extent of methylation of a guest's ammonium nitrogen controls the predominant binding site with the cucurbit[8]uril host.

High Q calcium titanate cylindrical dielectric resonators for magnetic resonance microimaging

At high magnetic fields radiation losses, wavelength effects, self-resonance, and the high resistance of typical components all contribute to increased losses in conventional RF coil designs. High permittivity ceramic dielectric resonators create strong uniform magnetic fields in a compact structure at high frequencies and can potentially solve some of the challenges of high field coil design. In this study an NMR probe was constructed for operation at 600 MHz (14.1T) using an inductively fed CaTiO(3) (relative permittivity of 156) cylindrical hollow bore dielectric resonator. The design has an unmatched Q value greater than 2000, and the electric field is largely confined to the dielectric itself, with near zero values in the hollow bore which accommodates the sample. Experimental and simulation mapping of the RF field show good agreement, with the ceramic resonator giving a pulse width approximately 25% less than a loop gap resonator of similar inner dimensions. High resolution images, with voxel dimensions less than 50 microm(3), have been acquired from fixed zebrafish samples, showing excellent delineation of several fine structures.

Dielectric resonator-based resonant structure for sensitive ESR measurements at high-hydrostatic pressures

We present a newly developed microwave probe head that accommodates a gasketed sapphire anvil cell (SAC) for performing sensitive electron spin resonance (ESR) measurements under high-hydrostatic pressures. The system was designed around commercially available dielectric resonators (DRs) having the dielectric permittivity of approximately 30. The microwave resonant structure operates in a wide-stretched double-stacked geometry and resonates in the lowest cylindrical quasi TE(011) mode around 9.2 GHz. The most vital parts of the probe's microwave heart were made of plastic materials, thus making the resonant structure transparent to magnetic field modulation at 100 kHz. The overall ESR sensitivity of the probe was demonstrated for a small speck of 2,2-diphenyl-1-picrylhydrazyl radical (DPPH) positioned in the gasket of the SAC, using water as the pressure-transmitting medium. The system was also used for studying pressure-induced changes in spin-relaxation mechanisms of a quasi-1D-conducting polymer, K(1)C(60). For small samples located in the sample hole of the gasket the probe reveals sensitivity that is only approximately 3 times less than that yielded by regular ESR cavities.