Comparison of different surgical procedures on the stability of dental implants in posterior maxilla: A randomized clinical study

Radiographic Study of Transcrestal Sinus Floor Elevation Using Osseodensification Technique with Graft Material: A Pilot Study

This pilot study aimed to evaluate the level of implant success after transcrestal sinus floor elevation (tSFE) using the osseodensification technique (OD) combined with beta-tricalcium phosphate (β-TCP) by analyzing clinical and radiographic results. Moreover, the increase in bone height was analyzed immediately after surgery, 3 months after, and before loading by taking standardized radiographic measurements. Thirteen patients, four males and nine females, with a mean age of 54.69 ± 5.86 years, requiring the placement of one implant in the upper posterior maxilla, with a residual bone height of <8 mm and a minimum bone width of 5 mm, participated in the study. The bone gain data was obtained using cone-beam computed tomography (CBCT) immediately after surgery and twelve months after the placement. The correlation between initial and final bone height with implant stability was also assessed. The results were analyzed using SPSS 23 software (p < 0.05). The results of the study indicated a 100% implant success rate after a follow-up period of twelve months. Preoperative main bone height was 5.70 ± 0.95 mm. The osseodensification technique allowed a significant increase of 6.65 ± 1.06 mm immediately after surgery. After a twelve-month follow-up, a graft material contraction of 0.90 ± 0.49 mm was observed. No correlation was observed between the bone height at the different times of the study and the primary stability of the implant. Considering the limitations of the size sample of this study, the osseodensification technique used for transcrestal sinus lift with the additional bone graft material (β-TCP) may provide a predictable elevation of the maxillary sinus floor, allowing simultaneous implant insertion with adequate stability irrespective of bone height limitations.

Osseointegration in relation to drilling speed in the preparation of dental implants sites: A systematic review

STATEMENT OF PROBLEM

The drilling speed used for preparing dental implants may affect bone-implant contact (BIC), implant stability quotient (ISQ), and bone area fraction occupancy (BAFO). Different rotational speeds and the presence or absence of irrigation during site preparation have been investigated, but an established protocol for achieving the best osseointegration results is lacking.

PURPOSE

The purpose of this systematic review was to investigate the influence of drill rotational speed on bone drilling for dental implant placement and its relationship with osseointegration.

MATERIAL AND METHODS

This review included the preferred reporting items for systematic reviews and meta-analyses (PRISMA) and was registered in the international prospective register of systematic reviews (PROSPERO) database. Electronic searches were performed in the MEDLINE (PubMed), Scopus, Science Direct, and Embase databases. The risk of bias was analyzed by using the systematic review center for laboratory animal experimentation (SYRCLE).

RESULTS

A total of 1282 articles were found, and after removing duplicates and applying the eligibility criteria to in vivo articles on animals that addressed drilling speed and its relationship to osseointegration, 8 articles were selected for analysis. Of these, 5 articles showed no statistical differences, and 3 others showed significantly better osseointegration results by analyzing the parameters of BIC, BAFO, ISQs, and pull-out forces (PoFs). In all selected articles, high-speed drilling was performed with irrigation.

CONCLUSIONS

Although drilling speed seems to affect bone perforation, no definitive protocol was found in the literature consulted. The results vary depending on the combination of different factors, including bone type, irrigation, and drilling speed.

Primary implant stability based on alternative site preparation techniques: A systematic review and meta-analysis

AIM

To evaluate the effect of special implant site preparation methods in improving primary implant stability in low-density bone.

MATERIAL AND METHODS

This meta-analysis included studies published in English and Mandarin Chinese up to March 31, 2022 from MEDLINE/PubMed, Embase, Scopus, and Wanfang databases. The primary stability of five site preparation methods were measured using implant stability quotient. The random-effects model was chosen for data analysis. Grading of recommendations assessment, development, and evaluation assessment was adopted as a collective grading of the overall body of evidence.

RESULTS

12 of the 17 studies included in the meta-analysis were randomized control trials. Three studies investigated osseodensification drilling (OD), eight studies examined osteotome technique (OT), five studies explored piezosurgery (PS), and four studies were conducted on under-drilling (UD). Meta-analysis showed a statistically significant increase in primary stability for the OD (mean difference [MD], 10.25; 95% CI: 4.97-15.52; p < 0.001), OT (MD, 6.34; 95% CI: 2.26-10.42; p = 0.002), and UD (MD, 11.43; 95% CI: 5.17-17.68; p < 0.001) groups when compared to the conventional drilling group, while the PS group did not (MD, 1.50; 95% CI: -2.54-5.54; p = 0.47).

CONCLUSION

Significantly higher primary implant stability was shown in the OD, UD, and OT groups compared to the conventional drilling group. PS displayed the least favorable primary stability and when compared to conventional drilling, was not statistically significant.

Are Mini Dental Implants Suitable for Support of Crowns or Small Bridges in the Mandibular Incisor Region? A 5-year Longitudinal Study

PURPOSE

It has not been previously studied whether 1-piece category 1 narrow dental implants (≤2.5 mm wide) can successfully support crowns or small bridges. The purpose of this study was to evaluate the long-term benefits of the fixed-type mini dental implants (MDIs) for replacement of mandibular incisors.

MATERIALS AND METHODS

In a prospective cohort study, fixed-type 1-piece MDIs, replacing single or multiple mandibular incisors, supporting metal-ceramic single crowns (unsplinted group), or splinted crowns/small bridges (splinted group) were observed over the period of 5 years. The primary predictor was the splinting status. The primary outcome variables were peri-implant marginal bone level (MBL) change, success, and survival rates (assessed as per Pisa Consensus Conference). The secondary outcomes were dental patient-reported outcome measures (dPROMs) and oral hygiene assessment. Descriptive statistics, Chi-squared test, t-test, Mann-Whitney and Wilcoxon tests, Kaplan-Meier survival analysis, log-rank (Mantel-Cox) comparison, Cox proportional hazard analyses adjusting for number of implants, Spearman correlation, and repeated measures were used for data analysis.

RESULTS

From 44 participants (mean age 56.02 ± 5.72 years), 40 completed the 5-year study: 23 in the splinted and 17 in unsplinted group. Three subjects did not respond, while 1 MDI failed (third year) in the unsplinted group. Mean MBL change in both groups was small; however, it increased over time (-0.22 ± 0.38 mm after 1 year; -0.54 ± 0.56 mm after 5 years; P < .05). After 5 years mean MBL change was -0.59 ± 0.71 mm in the unsplinted and -0.50 ± 0.41 mm in the splinted group (P > .05). Survival analysis revealed no significant difference between the unsplinted (85.7% success, 4.8% failures, and 9.5% satisfactory survivals) and splinted group (93.4% success and 6.6% satisfactory survivals) (P > .05). The group affiliation (unsplinted vs splinted) and number of implants were not significant predictors of MDI failure or survival rates (P > .05). Significant improvement in dPROMs after rehabilitation remained unchanged over 5 years (P > .05). Modified plaque index significantly increased over time, correlating with the MBL loss.

CONCLUSION

MDIs supporting crowns and/or small bridges in the mandibular incisor region showed small rates of marginal bone loss, acceptable success, and survival rates and improved dPROMs over a 5-year observation period.

Marginal bone level change during sequential loading periods of partial edentulous rehabilitation using immediately loaded self-tapping implants: a 6.5-year retrospective study

PURPOSE

A large number of studies have suggested the practicability and predictability of immediate implant function, but few studies have reported marginal bone level changes during sequential loading periods. The purpose of this study was to evaluate the marginal bone remodeling of immediately loaded self-tapping implants both at each time point and during each loading period between two time points.

MATERIALS AND METHODS

The patients included in this retrospective study were treated with immediately loaded NobelSpeedy Replace implants between August 2008 and July 2009. Differences in the marginal bone level (MBL) at each time point and the marginal bone level change (ΔMBL) between two time points were analyzed with Bonferroni correction (P < .05).

RESULTS

Overall, 24 patients (mean age, 47.3 ± 12.8 years) with 42 immediately loaded implants and a median follow-up of 6.5 years (IQR, 67.8 months) were included. The cumulative survival rate after 10 - 12 years was 95.2%. Continuous but slow marginal bone loss was observed during long-term follow-up. MBL at both 7.5 years and 11 years was significantly lower than that at loading, 6 months, 2 years and 4 years (P < .05). No bone loss difference was found in any period before 4 years of follow up (P > .05). The loading period of 4 years to 7.5 years showed the largest ΔMBL compared to those of other time periods (P < .05).

CONCLUSION

Slight bone loss occurred continuously, and more radical changes of marginal bone can be observed during the period of 4-7.5 years. Thus, long-term effective follow-up of immediately loaded implants is needed.