LC methods for acyclovir and related impurities determination

Evaluation of the stability of aciclovir in elastomeric infusion devices used for outpatient parenteral antimicrobial therapy

OBJECTIVES

To investigate the stability of aciclovir solutions in elastomeric devices used for outpatient parenteral antimicrobial therapy (OPAT).

METHODS

Triplicates of two elastomeric devices, Accufuser and Easypump II, were filled with a solution of 200 mg, 2400 mg, and 4500 mg aciclovir in 240 mL 0.9% w/v saline. Devices were stored at room temperature for 14 days, followed by 24 hours storage at 32°C. Assessment using a stability indicating assay, pH and subvisible particle analysis was undertaken at 11 time points throughout the study.

RESULTS

Aciclovir solution at 200 mg and 2400 mg in 240 mL was stable for 14 days at room temperature (<20°C) and 24 hours of 32°C 'in-use' temperature exposure, remaining above the 95% limit for NHS stability protocols. The high dose was also stable for 14 days at room temperature, but when stored at 32°C there was precipitation of aciclovir within 4 hours in both devices. The precipitate was confirmed as aciclovir and precipitation was not a sign of chemical degradation.

CONCLUSIONS

Aciclovir concentrations above 2400 mg/240 mL are liable to precipitation and cannot be recommended for OPAT services because of heightened risks of nephrotoxicity. Aciclovir solution can be given as a continuous 24-hour infusion for OPAT services at a concentration range of 200-2400 mg in 240 mL in Accufuser and Easypump II elastomeric devices following 14 days storage at room temperature, protected from light.

Stability-indicating HPLC method for acyclovir and lidocaine in topical formulations

A simple, rapid and accurate stability-indicating HPLC assay was developed for the determination of acyclovir and lidocaine in topical formulations. Chromatographic separation of acyclovir and lidocaine was achieved using a reversed-phase C₁₈ column and a gradient mobile phase (20 mm ammonium acetate pH 3.5 in water and acetonitrile). The degradation products of acyclovir and lidocaine in the samples were analyzed by ultra performance liquid chromatography-time of flight mass spectrometry. The HPLC method successfully resolved the analytes from the impurities and degradation products in the topical formulation. Furthermore, the method detected the analytes from the human skin leachables following the extraction of the analytes in the skin homogenate samples. The method showed linearity over wide ranges of 5-500 and 10-200 μg/ml for acyclovir and lidocaine in the topical product, respectively, with a correlation coefficient (r² ) >0.9995. The relative standard deviations for precision, repeatability, and robustness of the method validation assays were <2%. The skin extraction efficiency for acyclovir and lidocaine was 92.8 ± 0.7% and 91.3 ± 3.2%, respectively, with no interference from the skin leachables. Thus, simultaneous quantification of acyclovir and lidocaine in the topical formulations was achieved.

Acyclovir chemical kinetics with the discovery and identification of newly reported degradants and degradation pathways involving formaldehyde as a degradant and reactant intermediate

The purpose of this research was to determine acyclovir (ACV) acidic degradation kinetics which is relevant to gastric retentive device product design. A stability-indicating method revealed two unknown degradation products which have been identified by mass spectrometry as ACV and guanine formaldehyde adducts. In addition to the formation of these adducts, a proposed degradation scheme identifies the formation of methyl acetal ethylene glycol, formaldehyde, ethylene glycol, and guanine as additional ACV degradation products. pH-rate profiles were explained by using a rate law which assumed acid-catalyzed hydrolysis of protonated and unprotonated ACV. The predicted and observed rate constants were in good agreement. Data-driven excipient selection recommendations were based on the chemical kinetic study results, degradation scheme, and pH-rate profiles. The average activation energy for the degradation reaction was determined to be 31.3±1.6kcal/mol. The predicted ACV t_90% at 37°C and pH 1.2 was calculated to be 7.2days. As a first approximation, this suggests that ACV gastric retentive devices designed to deliver drug for 7days should have acceptable drug product stability in the stomach.

Enhanced dermal delivery of acyclovir using solid lipid nanoparticles

The present investigation was enthused by the possibility to develop solid lipid nanoparticles (SLNs) of hydrophilic drug acyclovir (ACV) and evaluate their potential as the carrier for dermal delivery. ACV-loaded SLNs (ACV-SLNs) were prepared by the optimized double emulsion process using Compritol 888 ATO as solid lipid. The prepared SLNs were smooth and spherical in shape with average diameter, polydispersity index, and entrapment efficiency of 262 ± 13 nm, 0.280 ± 0.01, and 40.08 ± 4.39% at 10% (w/w) theoretical drug loading with respect to Compritol 888 ATO content. Differential scanning calorimetry and powder X-ray diffraction pattern revealed that ACV was present in the amorphous state inside the SLNs. In vitro skin permeation studies on human cadaver and Sprague-Dawley rat skin revealed 17.65 and 15.17 times higher accumulation of ACV-SLNs in the dermal tissues in comparison to commercially available ACV cream after 24 h. Mechanism of topical permeation and dermal distribution was studied qualitatively using confocal laser scanning microscopy. While free dye (calcein) failed to penetrate skin barrier, the same encapsulated in SLNs penetrated deeply into the dermal tissue suggesting that pilosebaceous route was followed by SLNs for skin penetration. Histological examination and transdermal epidermal water loss measurement suggested that no major morphological changes occurred on rat skin surface due to the application of SLNs. Overall, it was concluded that ACV-loaded SLNs might be beneficial in improving dermal delivery of antiviral agent(s) for the treatment of topical herpes simplex infection.

Sensitive and rapid HPLC quantification of tenofovir from hyaluronic acid-based nanomedicine

The purpose of this study was to develop and validate a rapid, sensitive, and specific reversed-phase high-performance liquid chromatography method for the quantitative determination of native tenofovir (TNF) for various applications. Different analytical performance parameters such as linearity, precision, accuracy, limit of quantification (LOQ), limit of detection (LOD), and robustness were determined according to International Conference on Harmonization (ICH) guidelines. A Bridge™ C18 column (150 × 4.6 mm, 5 μm) was used as stationary phase. The retention time of TNF was 1.54 ± 0.03 min (n = 6). The assay was linear over the concentration range of 0.1-10 μg/mL. The proposed method was sensitive with LOD and LOQ values equal to 50 and 100 ng/mL, respectively. The method was accurate with percent mean recovery from 95.41% to 102.90% and precise as percent RSD (relative standard deviation) values for intra-day, and inter-day precision were less than 2%. This method was utilized for the estimation of molar absorptivity of TNF at 259 nm (ε(259) = 12,518 L/mol/cm), calculated from linear regression analysis. The method was applied for determination of percentage of encapsulation efficiency (22.93 ± 0.04%), drug loading (12.25 ± 1.03%), in vitro drug release profile in the presence of enzyme (43% release in the first 3 h) and purification analysis of hyaluronic acid-based nanomedicine.

Assay and stability-indicating micellar electrokinetic chromatography method for the simultaneous determination of valacyclovir, acyclovir and their major impurity guanine in pharmaceutical formulations

A micellar electrokinetic chromatography (MEKC) method for the simultaneous determination of the antiviral drugs acyclovir and valacyclovir and their major impurity, guanine, was developed. The influences of several factors (surfactant and buffer concentration, pH, applied voltage, capillary temperature and injection time) were studied. Using tyramine hydrochloride as internal standard, the analytes were all separated in about 4 min. The separation was carried out in reversed polarity mode at 28 degrees C, 25 kV and using hydrodynamic injection (15 s). The separation was effected in a fused-silica capillary 100 microm x 56 cm and a background electrolyte of 20 mM citric acid-1 M Tris solution (pH 2.75), containing 125 mM sodium dodecyl sulphate and detection at 254 nm. The method was validated with respect to linearity, limit of detection and quantification, accuracy, precision and selectivity. Calibration curves were linear over the range 0.1-1 microg/mL (guanine) and from 0.1 to 120 microg/mL for both valacyclovir and acyclovir. The relative standard deviations of intra- and inter-day migration times and corrected peak areas were less than 5.0%. The proposed method was successfully applied to the determination of the analytes in tablets and creams. From the previous study it is concluded that the stability-indicating method developed for acyclovir and valacyclovir can be used for analysis of the drug in various stability samples.

High-throughput HPLC assay of acyclovir and its major impurity guanine using a monolithic column and a flow gradient approach

Acyclovir and its major impurity guanine are determined rapidly by the incorporation of a monolithic column (100 mm x 4.6 mm i.d., Merck) to an automated HPLC system. A simple flow gradient protocol was adopted in order to accelerate the separation-detection cycle. Using 0.2% CH(3)COOH (pH 3.1) as the mobile phase and detection at 254 nm, guanine was effectively separated from the system peak (t(R)=1.25 min), while the retention time of acyclovir was 2.35 min. Linearity of the assay was validated in the range 0.1-1.0% guanine and 80-120% acyclovir (n=5). The accuracy and within- and day-to-day precision of the method were also validated, while the limits of detection and quantitation of both analytes were determined. The proposed method was successfully applied to the quality control of acyclovir raw material and the quality and stability control of acyclovir-containing pharmaceutical creams (Hagevir 5%, w/w, Cosmopharm Ltd., Korinthos, Greece).

Tandem column for the simultaneous determination of arginine, ibuprofen and related impurities by liquid chromatography

Ibuprofen arginate is a rapidly absorbed salt designed to promote more rapid onset of analgesia than commercially available forms of ibuprofen. Ibuprofen and arginine have very different polarities and this becomes in a chromatographic problem, further complicated with the determination of related compounds, which is necessary in stability assays of the pharmaceutical forms. The common solution is the employment of two separate methods, but this is time consuming. A LC method has been developed to determinate both compounds and related impurities in one run. Ibuprofen, arginine and three ibuprofen related impurities (B, E and J) have been baseline separated with isocratic conditions at pH 3.0 and run time under 20 min by employing a tandem combination of two different stationary phases: first a ZORBAX SB-C18 column from Agilent (250 mm x 4.6 mm and 5 microm) and downstream a SUPELCOSIL LC-NH2 column from Supelco (150 mm x 4.6 mm and 3 microm). The octadecyldiisobutylsilane column provides the separation of ibuprofen and its impurities by a hydrophobic mechanism, whereas aminopropyl column offers selective retention of arginine by dipolar interaction mechanism. Method has been successfully validated following ICH guidelines and it has been demonstrated to be reliable for arginine, ibuprofen and related impurities determination in sachets of two different dosages as pharmaceutical forms. Moreover, stress test has proved the selectivity of the method for degradation products, such as those that can emerge throughout long-term stability assays.