Novel and selective potentiometric membrane sensor for amiloride determination in pharmaceutical compounds and urine

A Novel Potentiometric PVC-membrane Cysteamine-Selective Electrode Based on Cysteamine-Phosphomolybdate Ion-Pair

Background:

Cysteamine is used as an orphan drug in the treatment of cystinosis to prevent long-term cystine accumulation in lysosomes. Dosing in cysteamine treatment is extremely important and overdose may cause some side effects. Up to now, various analytical methods have been used for cysteamine determination. Many of these methods require sophisticated instruments, expert operators, time-consuming measurement procedures and manipulation steps, expensive supplies and long analysis time.

Aims and Objective:

The present study deals with the development of a potentiometric PVC-membrane cysteamine-selective electrode based on an ion-pair of cysteamine and its application in a pharmaceutical formulation.

Methods:

Cysteamine (Cys)-Phosphomolybdate (PM) ion-pair was synthesized by mixing the equal volumes of 10-2 M Cysteamine HCl and sodium phosphomolybdate aqueous solutions. The obtained precipitate was used as ionophore in the structure of PVC-membrane.

Results and Discussion:

The electrode exhibited a linear response in the concentration range of 1.0×10- 1-1.0×10-5 M cysteamine with a slope of 51,7 mV per decade and detection limit of 1.0×10-5 M. The potentiometric response of the electrode was very rapid (5 s), adequately repeatable, stable and selective. pH working range and life-time of the electrode were also determined as 3.0-7.0 and 25 days, respectively.

Conclusion:

A PVC-membrane cysteamine selective electrode was easily prepared. Cysteamine determination in a pharmaceutical formulation was performed. Analysis results indicated that it can be successfully used in drug quality control laboratories for routine analysis of cysteamine in pharmaceutical preparations alternative to more sophisticated, expensive and time-consuming analytical methods.

Liquid three-phase microextraction based on hollow fiber for highly selective and sensitive determination of using an ion selective electrode

In this paper, for the first time, a combination of hollow fiber based liquid 3-phase microextraction with a potentiometric method was applied as a highly selective and sensitive method of analysis. Desipramine, as a model compound, was extracted from a small volume in the presence of 0.10 mol L-1 NaOH (donor solution) through a thin phase of propyl benzoate inside the pores of a polypropylene hollow fiber and finally into a 10 μL acidic acceptor solution inside the hollow fiber. Two microelectrodes were designed and inserted into the two ends of a hollow fiber inside the acceptor solution. Potentiometric analysis was performed in situ within an extraction time of 15 min; the final stable signal was used for analytical application. Under the optimized conditions, an enrichment factor of 296 was achieved and the relative standard deviation (RSD%) of the method was 4.5%. The calibration curve was obtained in the range of 3.0 × 10-5 to 3.4 × 10-8 mol L-1 with a reasonable linearity (R2 > 0.9849) and a limit of detection (LOD) of 3.1 × 10-8 mol L-1. Finally, the applicability of the proposed method was evaluated by extraction and determination of desipramine in plasma and urine samples without any special pretreatment.

Development of membrane selective electrode for determination of the antipsychotic sulpiride in pharmaceuticals and urine

The construction and electrochemical response characteristics of a poly(vinyl chloride) (PVC) membrane selective electrode for the determination of sulpiride (SPD) are described. The sensing membrane comprised an ion-exchanger formed between the protonated drug and tetraphenylborate (TPB(-)) in a plasticized PVC matrix. The influence of membrane composition on the electrode response was studied. The electrode showed a fast, stable and Nernstian response over a sulpiride concentration range (1 × 10(-4) - 1 × 10(-2) M) with a mean slope of 58.4 ± 0.9 mV dec(-1) of concentration, a mean detection limit of 4.2 × 10(-5) ± 1.2 × 10(-5) M, a wide working pH range (2 - 8) and a fast response time (< 15 s). The electrode showed good selectivity towards sulpiride with respect to some inorganic and organic compounds. When the electrode was applied to the determination of sulpiride in pharmaceuticals and human urine, a high percentage of recovery was attained with no need for sample pretreatment procedures because of the lack of interfering matrix effects.

Application of a trazodone-selective electrode to pharmaceutical quality control and urine analyses

A trazodone-selective electrode for application in pharmaceutical quality control and urine analysis was developed. The electrode is based on incorporation of a trazodone-tetraphenylborate ion exchanger in a poly(vinyl chloride) membrane. The electrode showed a fast, stable and Nernstian response over a wide trazodone concentration range (5 x 10(-5)-1 x 10(-2) M) with a mean slope of 59.3 +/- 0.9 mV/dec of concentration, a mean detection limit of 1.8 x 10(-5) +/- 2.2 x 10(-6) M, a wide working pH range (5-7.5) and a fast response time (less than 20 s). The electrode also showed good accuracy, repeatability, reproducibility and selectivity with respect to some inorganic and organic compounds, including the main trazodone metabolite. The electrode provided good analytical results in the determination of trazodone in pharmaceuticals and spiked urine samples; no extraction steps were necessary. Dissolution testing of trazodone tablets, in different conditions of pH and particle size, based on a direct potentiometric determination with the new selective electrode is presented as well.