RP-HPLC method for simultaneous estimation of bisoprolol fumarate and hydrochlorothiazide in tablet formulation

The improvement of routine drug quality control analysis of some antihypertensive drugs using high-performance thin-layer chromatography densitometry method with greenness profile evaluation

The common antihypertensive drugs are B-blockers and diuretics. For the determination of beta-blocker medicines (bisoprolol fumarate and carvedilol) and diuretic drug (Furosemide), new and accurate chromatographic method has been developed. The separation was achieved using a developing system that includes chloroform:methanol:ethyl acetate:ammonia (6:2:2:0.2 by volume) as a mobile phase and the bands were detected at 240 nm. The concentration ranges were 5-25, 1-7, and 1-3.5 μg/band for bisoprolol fumarate, carvedilol, and furosemide, respectively. This chromatographic approach is the first methodology for simultaneously determining bisoprolol fumarate, carvedilol, and furosemide in their pure forms and in their pharmaceutical dosage forms. The advantages of using known analytical procedures are their simplicity, speed, cost effectiveness, lack of laboriousness, and ability to save time as the three tablets are determined in one step and can be used for routine analysis of the investigated combinations in quality control laboratories. According to International Conference of Harmonization guidelines, the established procedures have been validated, and the results were statistically compared to those obtained by the reported reversed-phase-high-performance liquid chromatography methods using Student's t-test and F-test, with no significant difference between them, indicating that the proposed methods can be used for routine drug quality control analysis.

First derivative synchronous spectrofluorimetric analysis of bisoprolol fumarate and ivabradine in pharmaceutical and biological matrices. Investigation of the method greenness

A novel, facile, rapid, and precise synchronous spectrofluorimetric method was evolved for the simultaneous estimation of bisoprolol fumarate and ivabradine in dosage forms and biological fluids. The estimation is based on measuring the first derivative of the synchronous fluorescence spectra of ivabradine and bisoprolol fumarate in ethanol at Δλ = 80nm. The peak amplitudes are measured at 234.4 nm (zero-crossing point of ivabradine) and 244.0 nm (zero-crossing point of bisoprolol fumarate) to simultaneously analyse bisoprolol fumarate and ivabradine, respectively. The spectrofluorimetric method was optimized by investigating different solvent systems, pH values, and surfactants. The proposed method was linear over concentration ranges of 30.0-200.0 ng/mL and 30.0-180.0 ng/mL for ivabradine and bisoprolol fumarate, respectively with detection limits of 4.88 and 5.28 ng/ml. The developed method was employed for individual assay of the studied compounds in their pharmaceutical dosage forms with high %recoveries. Moreover, the method was applied to analyse ivabradine and bisoprolol fumarate in spiked human urine with %recoveries of 99.98±1.16 and 99.95±1.96 for ivabradine and bisoprolol fumarate, respectively. The method greenness was also investigated by Analytical GREEnness (AGREE), Analytical Eco-Scale, and Green Analytical Procedure Index (GAPI) metrics, which ensured the eco-friendship of the proposed method.

A Versatile Stability-indicating Liquid Chromatographic Method for the Simultaneous Determination of Atenolol, Hydrochlorothiazide and Chlorthalidone

Background:

Atenolol is a selective beta 1 blocker that can be used alone or in combination with hydrochlorothiazide or with chlorthalidone for the treatment of hypertension and prevention from a heart attack.

Objective:

The main target of this work was to improve modern, easy, accurate and selective liquid chromatographic method (RP-HPLC) for the determination of these drugs in the presence of their degradation products. These methods can be used as analytical gadgets in quality control laboratories for a routine examination.

Methods:

In this method, the separation was accomplished through an Inertsil® ODS-3V C18 column (250 mm x 4.6 mm, 5 μm), the mobile phase used was 25 mM aqueous potassium dihydrogen orthophosphate solution adjusted to pH 6.8 by using 0.1M sodium hydroxide and acetonitrile (77 : 23, v/v), the flow rate used was 1 ml/min and detection was achieved at 235 nm using UV.

Results:

All peaks were sharp and well separated, the retention times were atenolol degradation (ATN Deg.) 2.311 min, atenolol (ATN) 2.580 min, hydrochlorothiazide degradation (HCT Deg.) 5.890 min, hydrochlorothiazide (HCT) 7.016 min, chlorthalidone degradation CTD Deg 8.018 min and chlorthalidone (CTD) 14.972 min. Linearity was obtained and the range of concentrations was 20- 160 μg/ml for atenolol, 10-80 μg/ml for hydrochlorothiazide and 10-80 μg/ml for chlorthalidone. According to ICH guidelines, method validation was accomplished, these methods include linearity, accuracy, selectivity, precision and robustness.

Conclusion:

The optimized method demonstrated to be specific, robust and accurate for the quality control of the cited drugs in pharmaceutical dosage forms.

Bisoprolol: A comprehensive profile

The present study describes a comprehensive profile of Bisoprolol including detailed nomenclature; formulae, elemental analysis, appearance, its uses, applications, and methods for the preparation are outlined. The profile contains physicochemical properties of Bisoprolol including pKa value, solubility, X-ray powder diffraction, and methods of analysis (including compendial, electrochemical, spectroscopic, chromatographic and capillary electrophoresis). The study also covers thermal analysis such as differential scanning calorimetry and thermogravimetry of Bisoprolol. Which gives a brief idea of melting point, glass transition as well as differentiation between anhydrous and hydrated forms. In addition to these functional groups and structural confirmation of bisoprolol also presented with the help of Fourier transform infrared spectrometry and nuclear magnetic resonance spectroscopy, respectively. The mass fragmentation pattern of bisoprolol fumarate was reported using the electrospray ionization technique. Some recently reported methods for pharmacokinetic analysis of bisoprolol using high-performance liquid chromatography as well as liquid chromatography-mass spectrometry were also included in the study.

Stability-Indicating RP-HPLC and CE Methods for Simultaneous Determination of Bisoprolol and Perindopril in Pharmaceutical Formulation: A Comparative Study

Two fast, accurate and selective stability-indicating methods were developed and validated for the simultaneous determination of bisoprolol, perindopril and three of their possible degradation products. The first proposed method was a gradient reversed phase-high-performance liquid chromatography (HPLC) method, whereas the second was a capillary electrophoresis method. The structures of the obtained degradation products were elucidated using infrared and mass spectrometry. They were also confirmed to be either a drug impurity in the British Pharmacopoeia or a precursor to such impurity. The linearity for bisoprolol and perindopril was achieved in the range of 1-20 μg mL-1 and 5-30 μg mL-1 for HPLC and capillary electrophoresis methods, respectively. The proposed methods were validated according to the International Conference on Harmonisation guidelines. The HPLC method proved to be more sensitive and succeeded in the quantitative determination of the obtained degradation products. Also, it was able to quantify perindopril impurity up to three times lower than the desired limit set by the British Pharmacopoeia. They were successfully employed in the determination of bisoprolol and perindopril in their combined pharmaceutical formulation.

Continuous Wavelet Transform, a powerful alternative to Derivative Spectrophotometry in analysis of binary and ternary mixtures: A comparative study

A comparative study was established between two signal processing techniques showing the theoretical algorithm for each method and making a comparison between them to indicate the advantages and limitations. The methods under study are Numerical Differentiation (ND) and Continuous Wavelet Transform (CWT). These methods were studied as spectrophotometric resolution tools for simultaneous analysis of binary and ternary mixtures. To present the comparison, the two methods were applied for the resolution of Bisoprolol (BIS) and Hydrochlorothiazide (HCT) in their binary mixture and for the analysis of Amlodipine (AML), Aliskiren (ALI) and Hydrochlorothiazide (HCT) as an example for ternary mixtures. By comparing the results in laboratory prepared mixtures, it was proven that CWT technique is more efficient and advantageous in analysis of mixtures with severe overlapped spectra than ND. The CWT was applied for quantitative determination of the drugs in their pharmaceutical formulations and validated according to the ICH guidelines where accuracy, precision, repeatability and robustness were found to be within the acceptable limit.

Chemometric-assisted spectrophotometric methods and high performance liquid chromatography for simultaneous determination of seven β-blockers in their pharmaceutical products: a comparative study

Chemometric-assisted spectrophotometric methods and high performance liquid chromatography (HPLC) were developed for the simultaneous determination of the seven most commonly prescribed β-blockers (atenolol, sotalol, metoprolol, bisoprolol, propranolol, carvedilol and nebivolol). Principal component regression PCR, partial least square PLS and PLS with previous wavelength selection by genetic algorithm (GA-PLS) were used for chemometric analysis of spectral data of these drugs. The compositions of the mixtures used in the calibration set were varied to cover the linearity ranges 0.7-10 μg ml(-1) for AT, 1-15 μg ml(-1) for ST, 1-15 μg ml(-1) for MT, 0.3-5 μg ml(-1) for BS, 0.1-3 μg ml(-1) for PR, 0.1-3 μg ml(-1) for CV and 0.7-5 μg ml(-1) for NB. The analytical performances of these chemometric methods were characterized by relative prediction errors and were compared with each other. GA-PLS showed superiority over the other applied multivariate methods due to the wavelength selection. A new gradient HPLC method had been developed using statistical experimental design. Optimum conditions of separation were determined with the aid of central composite design. The developed HPLC method was found to be linear in the range of 0.2-20 μg ml(-1) for AT, 0.2-20 μg ml(-1) for ST, 0.1-15 μg ml(-1) for MT, 0.1-15 μg ml(-1) for BS, 0.1-13 μg ml(-1) for PR, 0.1-13 μg ml(-1) for CV and 0.4-20 μg ml(-1) for NB. No significant difference between the results of the proposed GA-PLS and HPLC methods with respect to accuracy and precision. The proposed analytical methods did not show any interference of the excipients when applied to pharmaceutical products.

Different signal processing techniques of ratio spectra for spectrophotometric resolution of binary mixture of bisoprolol and hydrochlorothiazide; a comparative study

Five signal processing techniques were applied to ratio spectra for quantitative determination of bisoprolol (BIS) and hydrochlorothiazide (HCT) in their binary mixture. The proposed techniques are Numerical Differentiation of Ratio Spectra (ND-RS), Savitsky-Golay of Ratio Spectra (SG-RS), Continuous Wavelet Transform of Ratio Spectra (CWT-RS), Mean Centering of Ratio Spectra (MC-RS) and Discrete Fourier Transform of Ratio Spectra (DFT-RS). The linearity of the proposed methods was investigated in the range of 2-40 and 1-22 μg/mL for BIS and HCT, respectively. The proposed methods were applied successfully for the determination of the drugs in laboratory prepared mixtures and in commercial pharmaceutical preparations and standard deviation was less than 1.5. The five signal processing techniques were compared to each other and validated according to the ICH guidelines and accuracy, precision, repeatability and robustness were found to be within the acceptable limit.

Simultaneous determination of related substances of telmisartan and hydrochlorothiazide in tablet dosage form by using reversed phase high performance liquid chromatographic method

Objective:

Telmisartan is a potent, long-lasting, nonpeptide antagonist of the angiotensin II type-1 (AT₁) receptor that is indicated for the treatment of essential hypertension. Hydrochlorothiazide is a widely prescribed diuretic and it is indicated for the treatment of edema, control of essential hypertension and management of diabetes insipidus. In the current article a new, accurate, sensitive, precise, rapid, reversed phase high performance liquid chromatography (RP-HPLC) method was developed for determination of related substances of Telmisartan and Hydrochlorthiazide in tablet dosage form.

Materials and Methods:

Simultaneous determination of related substances was performed on Kromasil C₁₈ analytical column (250 × 4.6 mm; 5μm pertical size) column at 40°C employing a gradient elution. Mobile phase consisting of solvent A (solution containing 2.0 g of potassium dihydrogen phosphate anhydrous and 1.04 g of Sodium 1- Hexane sulphonic acid monohydrate per liter of water, adjusted to pH 3.0 with orthophosphoric acid) and solvent B (mixture of Acetonitrile: Methanol in the ratio 80:20 v/v) was used at a flow rate of 1.0 ml min^–1. UV detection was performed at 270 nm.

Results:

During method validation parameter such as precision, linearity, accuracy, specificity, limit of detection and quantification were evaluated, which remained within acceptable limits.

Conclusions:

HPLC analytical method is linear, accurate, precise, robust and specific, being able to separate the main drug from its degradation products. It may find application for the routine analysis of the related substances of both Telmisartan and Hydrochlorthiazide in this combination tablets.