Simultaneous estimation and validation of some binary mixtures of antihypertensive drugs by RP-LC methods using two new generation silica columns

Application of supercritical fluid chromatography for separation and quantitation of 15 co-formulated binary anti-hypertensive medications using a single elution protocol

A facile supercritical fluid chromatography method is proposed to analyse 15 co-formulated binary anti-hypertensive drug combinations using a customized elution procedure. The effect of mobile phase composition, column back pressure and temperature was suitably optimized for adequate retention, analyte response and resolution. The chromatographic separation of the different drug combinations was performed on a DCPak poly(4-vinylpyridine) column (250 × 4.6 mm, 5 μm) at 125-bar pressure and 40°C using a photodiode array detector. A linear gradient of CO₂ and 0.1% formic acid in methanol provided the best elution conditions for all drug combinations. Baseline separation of the drugs was possible with resolution factor R_s ranging from 1.42 to 12.58. The method was validated for specificity, sensitivity, accuracy and precision, recovery and robustness. The limit of detection and limit of quantitation for aliskiren, amlodipine, atenolol, candesartan, hydrochlorothiazide, lisinopril, losartan, metoprolol, olmesartan, telmisartan and valsartan were in the range of 0.26-2.56 and 0.77-7.75 μg/mL, respectively. The thermodynamic study revealed that interactions of the drugs with the stationary phase were spontaneous as evident from the negative free energy values, and the separation process was enthalpy driven. The developed method was successfully employed to analyse these drugs in their co-formulated tablet formulations.

Novel feature extraction approach for achieving potential spectral resolution: Green analytical application on zofenopril calcium and hydrochlorothiazide in their spectrally overlapping binary mixture

A novel and green spectrophotometric method, namely constant extraction, based on extracting a spectral feature value (constant ratio) has been developed and validated for simultaneous estimation of a binary mixture of zofenopril calcium (ZOF) and hydrochlorothiazide (HCT) in their bulk and marketable formulation. A comparative study between this newly developed method and four long-established ones; ratio difference, ratio subtraction coupled with constant multiplication, advanced amplitude modulation and absorbance subtraction has been carried out giving very promising results. Various analytical performance parameters like linearity, accuracy, precision, and robustness were investigated in accordance with ICH (Q2B). Satisfying optimized instrumental parameters; absorbance of ZOF and HCT were linearly increased for the previously mentioned methods in a concentration range 5.0-35.0 and 3.0-20.0 μg/mL, respectively showing correlation coefficients ≥0.9990. Moreover, specificity has been checked through analyzing synthetic mixtures of the studied analytes. Feasibility has been successfully assessed by simultaneous quantification of both analytes in the commercially available formulation. As well, validity was examined and no interference from common excipients was noticed. Observed data has been statistically compared with those of the published one concluding that no significant variations between both results have been indicated. Furthermore, greenness profile of these methods was assessed by analytical Eco-Scale and found superior to that of the reported HPLC method as an even greener approach for the simultaneous analysis of ZOF and HCT.

Different spectrophotometric and TLC-densitometric methods for determination of olmesartan medoxomil and hydrochlorothiazide and their degradation products

In this work, multivariate calibration models and TLC-densitometric methods have been developed and validated for quantitative determination of olmesartan medoxomil (OLM) and hydrochlorothiazide (HCZ) in presence of their degradation products, olmesartan (OL) and salamide (SAL), respectively. In the first method, multivariate calibration models including principal component regression (PCR) and partial least square (PLS) were applied. The wavelength range 210-343 nm was used and data was auto-scaled and mean centered as pre-processing steps for PCR and PLS models, respectively. These models were tested by application to external validation set with mean percentage recoveries 99.78, 100.01, 100.41 and 100.46% for OLM, HCZ, OL and SAL, respectively, for PLS model and also, 100.22, 100.40, 102.25 and 100.13% for them, respectively, for PCR model. The second method is TLC-densitometry at which the chromatographic separation was carried out using silica gel 60F254 TLC plates and the developing system consisted of a mixture of ethyl acetate:chloroform:methanol: formic acid:tri-ethylamine (60:40:4:4:1, by volume) with UV-scanning at 254 nm. The developed methods were successfully applied for determination of OLM and HCZ in their pharmaceutical dosage form. Also, statistical comparison was made between the developed methods and the reported method using student’s-t test and F-test and results showed that there was no significant difference between them concerning both accuracy and precision.