Comparison of two photosensitizers Al(III) phthalocyanine chloride tetrasulfonic acid and meso-tetrakis(4-sulfonatophenyl)porphyrin in the photooxidation of n-butylparaben

Homoleptic Al(III) Photosensitizers for Durable CO2 Photoreduction

Exploiting noble-metal-free systems for high-performance photocatalytic CO₂ reduction still presents a key challenge, partially due to the long-standing difficulties in developing potent and durable earth-abundant photosensitizers. Therefore, based on the very cheap aluminum metal, we have deployed a systematic series of homoleptic Al(III) photosensitizers featuring 2-pyridylpyrrolide ligands for CO₂ photoreduction. The combined studies of steady-state and time-resolved spectroscopy as well as quantum chemical calculations demonstrate that in anerobic CH₃CN solutions at room temperature, visible-light excitation of the Al(III) photosensitizers leads to an efficient population of singlet excited states with nanosecond-scale lifetimes and notable emission quantum yields (10-40%). The results of transient absorption spectroscopy further identified the presence of emissive singlet and unexpectedly nonemissive triplet excited states. More importantly, the introduction of methyl groups at the pyrrolide rings can greatly improve the visible-light absorption, reducing power, and durability of the Al(III) photosensitizers. With triethanolamine, BIH (1,3-dimethyl-2-phenyl-2,3-dihydro-1H-benzo[d]imidazole), and an Fe(II)-quaterpyridine catalyst, the most methylated Al(III) photosensitizer achieves an apparent quantum efficiency of 2.8% at 450 nm for selective (>99%) CO₂-to-CO conversion, which is nearly 28 times that of the unmethylated one (0.1%) under identical conditions. The optimal system realizes a maximum turnover number of 10250 and higher robustness than the systems with Ru(II) and Cu(I) benchmark photosensitizers. Quenching experiments using fluorescence spectroscopy elucidate that the photoinduced electron transfer in the Al(III)-sensitized system follows a reductive quenching pathway. The remarkable tunability and cost efficiency of these Al(III) photosensitizers should allow them as promising components in noble-metal-free systems for solar fuel conversion.

TPPS4—Sensitized Photooxidation of Micropollutants—Singlet Molecular Oxygen Kinetic Study

Visible light-sensitized oxidation of micropollutants (MPs) in the presence of meso-tetrakis(4-sulfonatophenyl)porphyrin photosensitizers was studied. In order to explore the role of type I (ROS generation) or type II (singlet oxygen) photooxidation, radical scavengers were used to obtain insight into the mechanism of photodegradation. It was revealed that singlet oxygen is the main ROS taking part in TPPS₄- sensitized photooxidation of micropollutants. The interaction of MPs with ¹O₂ in deuterium oxide (D₂O) was investigated by measuring the phosphorescence lifetime of ¹O₂. The rate constant (kq) for the total (physical and chemical) quenching of ¹O₂ by MPs was determined in a D₂O buffer (pD 7, 9 and 10.8). The rate constants of singlet oxygen quenching and reaction with MPs were determined, and the rate constant of excited TPPS₄ quenching by MPs was also estimated.

Heterogeneous Oxidation of Phenolic Compounds with Photosensitizing Catalysts Incorporated into Chitosan

The increasing amount of hazardous micropollutants in the aqueous environment has recently become a concern, especially because they are not usually included in environmental monitoring programs. There is also limited knowledge regarding their behavior in the environment and their toxicity. This paper presents results regarding the heterogeneous photosensitized oxidation of 10 phenolic compounds under visible light. All of the selected compounds are classified as pollutants of emerging concern. For the first time, the application of photosensitizing catalysts incorporated into a chitosan carrier was investigated from several points of view, namely, structure characterization, singlet oxygen generation potential, photodegradation ability, biodegradability, and toxicity assessment. It was found that compounds of different origins were degraded with high effectivity. Photoactive chitosan was stable and could be reused for at least 12 cycles without losing its photocatalytic activity. The Hammett constants for all of the degraded compounds were determined. Improved biodegradability after the treatment was achieved for almost all compounds, apart from 4-hydroxybenzoic acid, and only slightly for 2-phenylphenol. The acute toxicity was assessed using bioluminescent Vibrio fischeri bacteria, indicating lower toxicity than the parent compounds.

Wastewater chemical contaminants: remediation by advanced oxidation processes

Approximately 70% of the terrestrial area is covered with water, but only a small water fraction is compatible with terrestrial life forms. Due to the increment in human consumption, the need for water resources is increasing, and it is estimated that more than 40% of the population worldwide will face water stress/scarcity within the next few decades. Water recycling and reuse may offer the opportunity to expand water resources. For that, the wastewater treatment paradigm should be changed and adequately treated wastewater should be seen as a valuable resource instead of a waste product. It is easily understandable that the exact composition and constituent concentration of wastewater vary according to its different sources (industrial, agricultural, urban usage of water). Consequently, a variety of known and emerging pollutants like heavy metals, antibiotics, pesticides, phthalates, polyaromatic hydrocarbons, halogenated compounds and endocrine disruptors have been found in natural water reservoirs, due to the limited effectiveness of conventional wastewater treatment. The conventional approach consists of a combination of physical, chemical and biological processes, aiming at the removal of large sediments such as heavier solids, scum and grease and of organic content in order to avoid the growth of microorganisms and eutrophication of the receiving water bodies. However, this approach is not sufficient to reduce the chemical pollutants and much less the emerging chemical pollutants. In this review, after some considerations concerning chemical pollutants and the problematic efficiency of their removal by conventional methods, an update is presented on the successes and challenges of novel approaches for wastewater remediation based on advanced oxidation processes. An insight into wastewater remediation involving the photodynamic approach mediated by tetrapyrrolic derivatives will be underlined.

Microscopic time-resolved imaging of singlet oxygen by delayed fluorescence in living cells

Singlet oxygen is a highly reactive species which is involved in a number of processes, including photodynamic therapy of cancer. Its very weak near-infrared emission makes imaging of singlet oxygen in biological systems a long-term challenge. We address this challenge by introducing Singlet Oxygen Feedback Delayed Fluorescence (SOFDF) as a novel modality for semi-direct microscopic time-resolved wide-field imaging of singlet oxygen in biological systems. SOFDF has been investigated in individual fibroblast cells incubated with a well-known photosensitizer aluminium phthalocyanine tetrasulfonate. The SOFDF emission from the cells is several orders of magnitude stronger and much more readily detectable than the very weak near-infrared phosphorescence of singlet oxygen. Moreover, the analysis of SOFDF kinetics enables us to estimate the lifetimes of the involved excited states. Real-time SOFDF images with micrometer spatial resolution and submicrosecond temporal-resolution have been recorded. Interestingly, a steep decrease in the SOFDF intensity after the photodynamically induced release of a photosensitizer from lysosomes has been demonstrated. This effect could be potentially employed as a valuable diagnostic tool for monitoring and dosimetry in photodynamic therapy.

Selective oxidative degradation of organic pollutants by singlet oxygen-mediated photosensitization: tin porphyrin versus C60 aminofullerene systems

This study evaluates the potential application of tin porphyrin- and C(60) aminofullerene-derivatized silica (SnP/silica and aminoC(60)/silica) as (1)O(2) generating systems for photochemical degradation of organic pollutants. Photosensitized (1)O(2) production with SnP/silica, which was faster than with aminoC(60)/silica, effectively oxidized a variety of pharmaceuticals. Significant degradation of pharmaceuticals in the presence of the 400-nm UV cutoff filter corroborated visible light activation of both photosensitizers. Whereas the efficacy of aminoC(60)/silica for (1)O(2) production drastically decreased under irradiation with λ > 550 nm, Q-band absorption caused negligible loss of the photosensitizing activity of SnP/silica in the long wavelength region. Faster destruction of phenolates by SnP/silica and aminoC(60)/silica under alkaline pH conditions further implicated (1)O(2) involvement in the oxidative degradation. Direct charge transfer mediated by SnP, which was inferred from nanosecond laser flash photolysis, induced significant degradation of neutral phenols under high power light irradiation. Self-sensitized destruction caused gradual activity loss of SnP/silica in reuse tests unlike aminoC(60)/silica. The kinetic comparison of SnP/silica and TiO(2) photocatalyst in real wastewater effluents showed that photosensitized singlet oxygenation of pharmaceuticals was still efficiently achieved in the presence of background organic matters, while significant interference was observed for photocatalyzed oxidation involving non-selective OH radical.