A Schiff-based fluorescence sensor for the detection of Cu2+ and its application in living cells

Novel selective "on-off" fluorescence sensor based on julolidine hydrazone-Al3+ complex for Cu2+ ion: DFT study

A hydrazone (T1) was synthesized by reacting 8-hydroxyjulolidine-9-carboxaldehyde with 2-furoic hydrazide and then modified with Al³⁺ ion to form a novel hydrazone Al³⁺ complex (T1-Al³⁺) in an aqueous solution (8% propylene glycol in 10 mM HEPES pH 5.5). The T1-Al³⁺ complex was studied as a Cu²⁺ selective sensor due to its highly efficient capacibility of paramagnetic quenching. The results showed that the T1-Al³⁺ complexed sensor possesses remarkable sensitivity and selectivity for Cu²⁺ ion in 8% propylene glycol in 10 mM HEPES pH 5.5 as compared with other tested analytes. Notably, this sensor has a broad linear detection range of 10-110 µM for Cu²⁺ ion and a detection limit level of 0.62 µM, which is lower than the Cu²⁺ concentration threshold in drinking water designated by the United States Environmental Protection Agency (EPA). Additionally, it was detectable for the presence of Cu²⁺ ion in mineral water and tap water samples. The selectivity of T1-Al³⁺ complexed sensor with Cu²⁺ ion could be explained by the basis of computation with Gaussian software complied with the basis sets of B3LYP/6-31 G(d,p)/LANL2DZ. Furthermore, only T1 exhibited anticancer efficacy against HeLa and U251 cells with MTT assay.

An effective long-wavelength fluorescent sensor for Cu2+ based on dibenzylidenehydrazine-bridged biphenylacrylonitrile

Although numerous fluorescence sensors for Cu²⁺ have been presented, a long-wavelength sensor in aqueous media has rarely been reported as expected due to practical application requirements. In this work, a novel AIE molecule (DHBB) containing two biphenylacrylonitrile units bridged by dibenzylidenehydrazine was prepared. It possessed the merits of long-wavelength emission, good emission in aqueous media, and multiple functional groups for binding Cu²⁺. It exhibited good sensing selectivity for Cu²⁺ among all kinds of tested metal ions. The detection limit was as low as 1.08 × 10^-7 M. The sensing mechanism was clarified as 1:1 stoichiometric ratio based on the binding cooperation of O and N functional groups of DHBB. The selective sensing ability for Cu²⁺ remained stable at pH = 5-9 and was influenced little by other metal ions. The Cu²⁺ sensing ability of DHBB was applied in real samples with 96% recovery rate. The bio-imaging experiment of living cells suggested that DHBB possessed not only good bio-imaging performance but also sensing ability for Cu²⁺ in living environments. This work suggested the good application prospect of DHBB to sense Cu²⁺ in real samples and living environment.

N-alkylation briefly constructs tunable multifunctional sensor materials: Multianalyte detection and reversible adsorption

A series of N-alkyl-substituted polybenzimidazoles (SPBIs), synthesized by simple condensation and N-alkylation, act as functional materials with tunable microstructures and sensing performance. For their controllable morphologies, the formation of nano-/microspheres is observed at the n(RBr)/n(PBI) feed ratio of 5:1. Products with different degrees of alkylation can recognize metal ions and nitroaromatic compounds (NACs). For example, SPBI-c, obtained at the feed ratio of 1:1, can selectively detect Cu2+, Fe3+, and NACs. By contrast, SPBI-a, obtained at the feed ratio of 0.1:1, can exclusively detect Cu2+ with high sensitivity. Their sensing mechanisms have been studied by FT-IR spectroscopy, SEM, XPS, and DFT calculations. Interestingly, the SPBIs can adsorb Cu2+ in solution and show good recyclability. These results demonstrate that polymeric materials with both sensing and adsorption applications can be realized by regulating the alkylation extent of the main chain, thus providing a new approach for the facile synthesis of multifunctional materials.