Size-controllable synthesis of dendritic Pd nanocrystals as improved electrocatalysts for formic acid fuel cells’ application

Bimetallic Pd-Co Nanoparticles Supported on Nitrogen-Doped Reduced Graphene Oxide as Efficient Electrocatalysts for Formic Acid Electrooxidation

In this work, bimetallic PdxCoy nanoparticles supported on nitrogen-doped reduced graphene oxide catalysts were synthesized and tested for formic acid oxidation as potentially efficient and durable electrocatalysts. Graphene oxide was nitrogen doped through hydrothermal chemical reduction with urea as a nitrogen source. The PdxCoy nanoparticles were deposited on the nitrogen-doped graphene oxide support using the impregnation-reduction method with sodium borohydride as a reducing agent and sodium citrate dihydrate as a stabilizing agent. The structural features, such as phases, composition, oxidation states, and particle sizes, of the nanoparticles were characterized using X-ray diffraction, transmission electron microscopy, scanning electron microscopy–energy-dispersive X-ray spectroscopy, and X-ray photoelectron spectroscopy. The Pd nanoparticle sizes in Pd1Co1/N-rGO, Pd/N-rGO, and Pd1Co1/CNT were 3.5, 12.51, and 4.62 nm, respectively. The electrochemical performance of the catalysts was determined by CO stripping, cyclic voltammetry, and chronoamperometry. Pd1Co1/N-rGO showed the highest mass activity of 4833.12 mA–1 mg Pd, which was twice that of Pd1Co1/CNT. Moreover, Pd1Co1/N-rGO showed a steady-state current density of 700 mA–1 mg Pd after 5000 s in chronoamperometry carried out at +0.35 V. Apart from the well-known bifunctional effect of Co, nitrogen-doped graphene contributed to the performance enhancement of the Pd1Co1/N-rGO catalyst.

Composition dependent activity of PdAgNi alloy catalysts for formic acid electrooxidation

In the present study, the carbon supported Pd, PdAg and PdAgNi (Pd/C, PdAg/C and PdAgNi/C) electrocatalysts are prepared via NaBH₄ reduction method at varying molar atomic ratio for formic acid electrooxidation. These as-prepared electrocatalysts are characterized by X-ray diffraction (XRD), transmission electron microscopy (TEM), inductively coupled plasma mass spectrometry (ICP-MS), N₂ adsorption-desorption, and X-ray electron spectroscopy (XPS), cyclic voltammetry (CV) and electrochemical impedance spectroscopy (EIS), chronoamperometry (CA), and lineer sweep voltammetry (LSV). While Pd₅₀Ag₅₀/C exhibits the highest catalytic activity among the bimetallic electrocatalyst, it is observed that Pd₇₀Ag₂₀Ni₁₀/C electrocatalysts have the best performance among the all electrocatalysts. Its maximum current density is about 1.92 times higher than that of Pd/C (0.675 mA cm^-2). Also, electrochemical impedance spectroscopy (EIS), chronoamperometry (CA) and lineer sweep voltammetry (LSV) results are in a good agreement with CV results in terms of stability and electrocatalytic activity of Pd₅₀Ag₅₀/C and Pd₇₀Ag₂₀Ni₁₀/C. The Pd₇₀Ag₂₀Ni₁₀/C catalyst is believed to be a promising anode catalyst for the direct formic acid fuel cell.