Preparation of carboxylated graphene oxide for enhanced adsorption of U(VI)

A convenient functionalization strategy of polyimide covalent organic frameworks for uranium-containing wastewater treatment and uranium recovery

The purpose of this research was to design and synthesize an adsorbent based on polyimide covalent organic frameworks (PICOFs) for uranium-containing wastewater treatment and uranium recovery. A modified solvothermal method was innovatively proposed to synthesize PICOFs with high specific surface area (1998.5 m2 g-1) and regular pore structure. Additionally, a convenient functionalization strategy of PICOFs was designed through polydopamine (PDA) and a well-dispersed polymer (MPC-co-AO) containing multiple functional groups, forming stable composite (PMCA-TPPICOFs) in which the hydrogen bonding and cation-π interactions between PDA and MPC-co-AO played a key role. The obtained PMCA-TPPICOFs as an adsorbent exhibited strong selectivity for uranyl ions (maximum adsorption capacity was 538 mg g-1). In simulated wastewater with low uranium concentrations, the removal rate reached 98.3%, and the concentration of treated simulated wastewater met discharge standards. Moreover, PMCA-TPPICOFs was suitable for fixed-bed column adsorption because of its favorable structure. According to the research about adsorption mechanism, the adsorption primarily relied on electrostatic interaction and complexation. In summary, PMCA-TPPICOFs exhibited good potential for uranium-containing wastewater treatment, expanding the application of PICOFs. And the proposed functionalization strategy and modified solvothermal method may promote research in the fields of material functionalization and COFs synthesis. ENVIRONMENTAL IMPLICATION: Uranium is a raw material for nuclear energy applications, which is toxic and radioactive. If uranium is discharged with wastewater, it would not only pose a threat to the environmental protection and life safety, but also cause the loss of precious nuclear raw materials. Although adsorption was considered to be an effective way to remove uranium, many of the developed adsorbents were difficult to apply due to the harsh wastewater environment and complex preparation processes. This study reported a novel adsorbent and a new functionalization strategy, which was expected to solve the problem of uranium recovery in wastewater.

Monovalent ion-graphene oxide interactions are controlled by carboxylic acid groups: Sum frequency generation spectroscopy studies

Graphene oxide (GO) is a two-dimensional, mechanically strong, and chemically tunable material for separations. Elucidating GO-ion-water interactions at the molecular scale is highly important for predictive understanding of separation systems. However, direct observations of the nanometer region by GO surfaces under operando conditions are not trivial. Therefore, thin films of GO at the air/water interface can be used as model systems. With this approach, we study the effects of alkali metal ions on water organization near graphene oxide films at the air/water interface using vibrational sum frequency generation (SFG) spectroscopy. We also use an arachidic acid Langmuir monolayer as a benchmark for a pure carboxylic acid surface. Theoretical modeling of the concentration-dependent sum frequency signal from graphene oxide and arachidic acid surfaces reveals that the adsorption of monovalent ions is mainly controlled by the carboxylic acid groups on graphene oxide. An in-depth analysis of sum frequency spectra reveals at least three distinct water populations with different hydrogen bonding strengths. The origin of each population can be identified from concentration dependent variations of their SFG signal. Interestingly, an interfacial water structure seemed mostly insensitive to the character of the alkali cation, in contrast to similar studies conducted at the silica/water interface. However, we observed an ion-specific effect with lithium, whose strong hydration prevented direct interactions with the graphene oxide film.

Chitosan-based hydrogel system for efficient removal of Cu[II] and sustainable utilization of spent adsorbent as a catalyst for environmental applications

The growing requirement for clean potable water requires sustainable methods of eliminating heavy metal ions and other organic contaminants. Herein, we synthesized a novel dual-purpose magnetically separable chitosan-based hydrogel system (CSGO-R@IO) that can efficiently remove toxic Cu2+ pollutants from water. FT-IR, XRD, SEM-EDX, VSM, XPS analyses were used to characterize the synthesized hydrogel. The CSGO-R@IO hydrogel showed high swelling capacity (1036.06 %), prominent adsorption capacity for Cu2+ ions (119.5 mg/g), and good recyclability up to four cycles. The adsorption data of Cu+2 ions on hydrogel fitted better to the Langmuir isotherm model (R2 = 0.9942), indicating spontaneous monolayer adsorption of Cu2+ ions on a homogenous surface. The adsorption kinetic studies fitted better with the pseudo-second-order model (R2 = 0.9992), suggesting that the adsorption process was controlled by chemisorption. We also showed a sustainable way to convert harmful Cu2+ pollutants into valuable Cu nanoparticles for catalysis, and Cu nanoparticles loaded hydrogel (CSGO-R@IO/Cu) had high catalytic activity. Hence, building attractive multipurpose hydrogel systems will give us new ideas about how to design and use new adsorbents to clean water in real life. They will also help in recycle metals (copper and maybe others) to conserve resources.

Fabrication of glucose bioelectrochemical sensor based on Au@Pd core-shell supported by carboxylated graphene oxide

The study presents a novel electrochemical glucose biosensor based on glucose oxidase (GOx) immobilized on Au@Pd core-shell nanoparticles supported on carboxylated graphene oxide (cGO). The immobilization of GOx was achieved by cross-linking the chitosan biopolymer (CS) including Au@Pd/cGO and glutaraldehyde (GA) on a glassy carbon electrode. The analytical performance of GCE/Au@Pd/cGO-CS/GA/GOx was investigated using amperometry. The biosensor had fast response time (5.2 ± 0.9 s), a satisfactory linear determination range between 2.0 × 10^-5 and 4.2 × 10^-3 M, and limit of detection of 10.4 μM. The apparent Michaelis-Menten constant (K_app) was calculated as 3.04 mM. The fabricated biosensor also exhibited good repeatability, reproducibility, and storage stability. No interfering signals from dopamine, uric acid, ascorbic acid, paracetamol, folic acid, mannose, sucrose, and fructose were observed. The large electroactive surface area of carboxylated graphene oxide is a promising candidate for sensor preparation.

Optimization of carboxylated graphene oxide (C-GO) content in polymer matrix: Synthesis, characterization, and application study

Carboxylated graphene oxide (C-GO) embedded in polysulfone (PSF) membrane composites were prepared with different wt. % (i.e., 0.2% M - 1, 0.3% M - 2, 0.4% M - 3, and 0.5% M - 4) using non-solvent induced phase separation (NIPS) method and ultrafiltration assembly was applied for the removal of dye effluents. The optimization of C-GO content into polymer matrix was found influencing factor in determining the composite membranes efficiency and application in various research fields. The membranes were characterized in terms of surface morphology (SEM), crystallinity (XRD), and functional groups identification (FTIR). The water permeability of the developed membranes was analyzed, and it is observed that increasing the content of C-GO in PSF membranes imposed a positive impact on permeation performance. M - 3 was found to be a potential candidate among all the membranes with a maximum water flux of about 183 LMH which is considerably higher as compared to the pristine PSF membrane's water flux (i.e., 27 LMH). Moreover, contact angle measurements of membranes were also checked to assess the hydrophilicity of PSF membranes. The results of contact angle also support the water permeability and efficient correlation was observed as contact angle decreases with increasing the content of C-GO. The minimum contact angle with excellent hydrophilicity was shown by the M - 3 membrane and it was found of about ±58.19° and this value is close to the M - 4 membrane having maximum C-GO content. The photocatalytic performance of the M - 3 membrane was checked under UV-254 nm using methylene blue dye and 97% dye removal was achieved within 220 min of reaction time under neutral pH conditions. The M - 3 membrane having C-GO content of 0.4% was found to be the best membrane with high pure water flux (183 LMH) and efficient dye rejection (82%) capability.

Synthesis of Functionalized Carboxylated Graphene Oxide for the Remediation of Pb and Cr Contaminated Water

With the growing scarcity of water, the remediation of water polluted with heavy metals is the need of hour. The present research work is aimed to address this problem by adsorbing heavy metals ions (Pb (II) and Cr (VI)) on modified graphene oxide having an excess of carboxylic acid groups. For this, graphene oxide (GO) was modified with chloroacetic acid to produce carboxylated graphene oxide (GO-COOH). The successful synthesis of graphene oxide and its modification has been confirmed using Fourier transform infrared spectroscopy (FT-IR), Raman spectroscopy, X-ray Diffraction (XRD), Scanning electron microscopy (SEM), Energy Dispersive X-ray Analysis (EDX) and Transmission electron microscopy (TEM). The increase in surface area of graphene oxide after treatment with chloroacetic acid characterized by BET indicated its successful modification. A batch experiment was conducted to optimize the different factors affecting adsorption of both heavy metals on GO-COOH. After functionalization, we achieved maximum adsorption capacities of 588.23 mg g^-1 and 370.37 mg g^-1 for Pb and Cr, respectively, by GO-COOH which were high compared to the previously reported adsorbents of this kind. The Langmuir model (R² = 0.998) and Pseudo-second-order kinetic model (R² = 0.999) confirmed the monolayer adsorption of Pb and Cr on GO-COOH and the chemisorption as the dominant process governing adsorption mechanism. The present work shows that the carboxylation of GO can enhance its adsorption capacity efficiently and may be applicable for the treatment of wastewater.

Synthesis of selective biodegradable amidoxime chitosan for absorption of Th(IV) and U(VI) ions in solution

Radionuclide extraction from wastewater is a long-term process, in which the study on the reuse and decomposition of adsorbents provides the ability to complete the post-treatment after adsorption. Herein, A novel biodegradable amidoxime chitosan has been synthesized through one-step without crosslinking agent and characterized by FT-IR, SEM, XPS, TGA and element analysis. The batch adsorption experiments of U(VI) and Th(IV) on AO-CTS adsorbent were studied and maximum adsorption of U(VI) and Th(IV) were 97 and 56 mg/g, respectively. The U(VI) and Th(Ⅳ) can be effectively desorbed from the AO-CTS materials at low acidity, The AO-CTS can be reused 6 times without reducing absorbency for U(VI) and Th(Ⅳ). When finish the adsorption process, the AO-CTS can be degraded by lysozyme at room temperature, there were no toxic or harmful substances are produced.

Graphene oxide functionalized with nano hydroxyapatite for the efficient removal of U(VI) from aqueous solution

Water contamination caused by radionuclides is a major environmental issue. Uranium (U) belongs to the actinide group of elements. Hexavalent uranium (U(VI)) is radioactively and chemically harmful and highly mobile in the environment and wastewater stream. Therefore, developing highly efficient materials for minimizing the environmental impact of U(VI) is essential. To achieve this goal, we successfully synthesized a novel material, namely graphene oxide (GO)/hydroxyapatite (HAP), by directly assembling GO and HAP through a facile hydrothermal method, which exhibits effective U(VI) removal and immobilization. The GO/HAP composite has an outstanding sorption capacity for U(VI) (i.e., 373.00 mg/g) within 5 min at a pH of 3.0. The parameters from thermodynamic analysis indicated that the GO/HAP composite absorbed U(VI) through a process of spontaneous and exothermic adsorption. XPS, XRD, and FT-IR results revealed that the composite's phosphate group was mainly responsible for U(VI) retention and incorporation. The GO/HAP composite's enhanced U(VI) sorption capacity is most likely ascribed to the synergistic effect after functionalizing with nano HAP. The current findings may greatly facilitate the creation of rational design strategies to develop highly efficient materials that can treat radioactive wastewater.

The effects of carbon disulfide driven functionalization on graphene oxide for enhanced Pb(II) adsorption: Investigation of adsorption mechanism

The surface properties of graphene oxide (GO) have been identified as the key effects on the adsorption of Pb(II) from aqueous solutions in this study. This study reveals the effect of the surface reactivity of GO via Carbon Disulfide (CS₂) functionalization for Pb(II) adsorption. After successfully preparing CS₂ functionalized GO (GOCS), the specific techniques were applied to investigate Pb(II) adsorption onto GOCS. Results indicated that the new sulfur-containing functional groups incorporated onto GOCS significantly enhanced Pb(II) adsorption capacity on GOCS than that of GO, achieving an improvement of 31% in maximum adsorption capacity increasing from 292.8 to 383.4 mg g^-1. The equilibrium adsorption capacity for GOCS was 280.2 mg g^-1 having an improvement of 83.2% over that of 152.97 mg g^-1 for GO at the same initial concentration of 150 mg L^-1 under the optimal pH of 5.7. Moreover, the results of adsorption experiments showed an excellent fit to the Langmuir and Pseudo-Second-Order models indicating the monolayer and chemical adsorption, respectively. The mechanism for Pb(II) adsorption on GOCS was proposed as the coordination, electrostatic interactions, cation-pi interactions, and Lewis acid-base interactions. The regeneration study showed that GOCS had an appreciable reusability for Pb(II) adsorption with the adsorption capacity of 208.92 mg g^-1 after five regeneration cycles. In summary, GOCS has been proved to be a novel, useful, and potentially economic adsorbent for the high-efficiency removal of Pb(II) from aqueous solutions.

Mechanically tough and highly stretchable poly(acrylic acid) hydrogel cross-linked by 2D graphene oxide

Incorporation of a novel GO based cross-linker into the conventional poly(acrylic acid) hydrogel remarkably enhances the toughness and stretchability.