Physical and optical properties of Ag3PO4 decorated TiO2 based nanostructures

Fabrication of Ag3PO4/N-doped TiO2 nanotubes heterojunction photocatalysts for visible-light-driven photocatalysis

As an environmentally friendly and energy-efficient technology, photocatalysis holds considerable potential for eliminating organic pollutants. In this study, novel visible-light-driven Ag3PO4-decorated nitrogen-doped TiO2 nanotubes (Ag3PO4/N-TNTs) photocatalysts with advanced properties of heterostructures were successfully synthesized and used to degrade methylene blue (MB) dye. The fabrication of Ag3PO4/N-TNTs photocatalysts involved a two-step electrochemical anodization to obtain TiO2 nanotubes (TNTs) and the wet impregnation of the amorphous tubular structure in NH3 solution, followed by calcination in air to obtain crystallized nitrogen-doped TiO2 nanotubes (N-TNTs). Finally, the decoration of the N-TNTs with Ag3PO4 nanoparticles was conducted to enhance visible-light reactivity. Various heterojunction photocatalysts were obtained by changing the concentration of NH3 (0.5-2.5 M) and the dosage of Ag3PO4 (0.25-1.5 wt%) in the composites. Results of ultraviolet-visible (UV-Vis) absorption, photocurrent transient, and electrochemical impedance spectroscopy measurement revealed that Ag3PO4/N-TNTs possessed a significant response in the visible-light range and good photoelectronic properties. The superior photocatalytic activity of the Ag3PO4/N-TNTs catalyst was achieved under the optimal conditions of N-doping using 2-M NH3 and Ag3PO4 deposition at a dosage of 0.75 wt%. Based on the degradation efficiency (DE) of MB, the optimal Ag3PO4/N-TNTs exhibited rate constants of 4.5 and 2 times higher than those of the pristine TNTs and N-TNTs, respectively. The high stability of Ag3PO4/N-TNTs was confirmed through four cycles of reutilization, with a small decay of only 5.3% in the DE of MB dye for each run of photocatalysis. The scavenger tests of generated reactive oxygen species revealed that ·OH and ·O2- were the primary contributors to photocatalytic performance. The synthesized Ag3PO4/N-TNTs heterostructure photocatalysts were proven to possess efficient separation of photogenerated charge carriers, high reactivity, and stability in the visible-light region.

Preparation of Ag3PO4/TiO2(B) Heterojunction Nanobelt with Extended Light Response and Enhanced Photocatalytic Performance

Photocatalytic degradation, as an emerging method to control environmental pollution, is considered one of the most promising environmental purification technologies. As Tibet is a region with some of the strongest solar radiation in China and even in the world, it is extremely rich in solar energy resources, which is ideal for applying photocatalytic technology to its ecological environment protection and governance. In this study, Na₂Ti₃O₇ nanobelts were prepared via a hydrothermal method and converted to TiO₂∙xH₂O ion exchange, which was followed by high-temperature calcination to prepare TiO₂(B) nanobelts (“B” in TiO₂(B) means “Bronze phase”). A simple in situ method was used to generate Ag₃PO₄ particles on the surface of the TiO₂ nanobelts to construct a Ag₃PO₄/TiO₂(B) heterojunction composite photocatalyst. By generating Ag₃PO₄ nanoparticles on the surface of the TiO₂(B) nanobelts to construct heterojunctions, the light absorption range of the photocatalyst was successfully extended from UV (ultraviolet) to the visible region. Furthermore, the recombination of photogenerated electron–hole pairs in the catalyst was inhibited by the construction of the heterojunctions, thus greatly enhancing its light quantum efficiency. Therefore, the prepared Ag₃PO₄/TiO₂(B) heterojunction composite photocatalyst greatly outperformed the TiO₂(B) nanobelt in terms of photocatalytic degradation.