Influence of silica precursors on octahedron shaped nano NaY zeolite crystal synthesis

Extraction of silica from sugarcane bagasse ash and its utilization in zeolite 4A synthesis for CO2 adsorption

Sugarcane bagasse ash (SCBA) is a solid waste containing a high amount of silica (SiO2) and is suitable to utilize as a silica source for synthesizing zeolite NaA. SCBA is typically calcined at high temperatures before silica extraction. The method is not environmentally friendly because it consumes energy and produces CO2. This work demonstrates an alternative extraction method of SiO2 from SCBA by treating it with hydrochloric (HCl) and sodium hydroxide (NaOH) solution. The obtained mixture was separated by paper filter No. 1 (P) and a combination of paper filter and syringe filter (PS). The solution was neutralized by HCl solution, producing silica (SiO2-P and SiO2-PS) with a purity of 98 wt%. Both SiO2 samples and SCBA were utilized to synthesize zeolite NaA for CO2 adsorption. The CO2 adsorption capacities of NaA-P and NaA-PS were 4.30 and 4.10 mmol gadsorbent -1, in the same range as commercial NaA. The capacity is influenced by the total basicity of zeolite. The CO2 adsorption behavior of all samples correlates well with the Toth model. The CO2 adsorption kinetics agrees well with the pseudo-second-order kinetic model. Overall, this work shows the successful extraction of silica via using a direct NaOH solution, yielding high-purity silica sufficient for synthesizing zeolite NaA, a promising adsorbent of CO2.

Magnesium Impregnated on NaX Zeolite Synthesized from Cogon Grass Silica for Fast Production of Fructose via Microwave-Assisted Catalytic Glucose Isomerization

Fructose is a crucial intermediate in the production of several chemical platforms. Fructose is mainly produced from glucose isomerization either through immobilized enzymes or heterogeneous catalysts using a conventional heating source, and this is time-consuming. Thus, this work discloses a fast production of fructose via microwave-assisted catalytic glucose isomerization using Mg catalysts supported on NaX zeolite from cogon grass silica. The catalysts were prepared by the impregnation of magnesium nitrate solution and subsequently transformed into MgO on NaX by calcination. The effect of 3, 6 and 9 wt.% Mg content on NaX on the performance of glucose isomerized to fructose was tested at 90 °C for 15 min. The best catalyst was selected for studying the effect of reaction times of 5, 15, 30 and 60 min. Results from X-ray diffraction (XRD), N2 sorption and CO2 temperature-programmed desorption (CO2-TPD) suggested that crystallinity, surface area and micropore volume decrease but basicity increases with Mg content. The X-ray photoelectron spectroscopy (XPS) result confirmed the presence of mixed phases of MgO and Mg2CO3 in all catalysts. The glucose conversion enhanced with the Mg loading but the fructose yield gave the highest value with Mg of 6 wt.%, probably due to the tuning of high active sites and surface area. The greatest fructose selectivity and yield (71.9% and 25.8%) were obtained within 15 min by microwave-assisted catalytic reaction, shorter than the reported value in the literature, indicating a suitable reaction time. Mg (6 wt.%)/NaX catalyst preserves the original catalytic performance up to three cycles, indicating that it is a promising catalyst for fructose production.