Investigation of kinetics and mechanism for the degradation of antibiotic norfloxacin in wastewater by UV/H2O2

Hydrolysis of norfloxacin in the hyporheic zone: kinetics and pathways

Understanding the hydrolysis behavior and pathway of norfloxacin (NOR) in the hyporheic zone (HZ) is important for predicting its environmental persistence. Therefore, the effects of different environmental factors on NOR hydrolysis were investigated, and the hydrolysis pathway of NOR in the HZ was determined by DFT calculations and UPLC/TOF-MS. The hydrolysis process of NOR was consistent with the first-order kinetic. The experiment of environmental factors showed that DO was an important factor to affect NOR hydrolysis, and its hydrolysis rate was positively correlated with DO concentration. The superoxide radical (·O2-) was the main active species for NOR hydrolysis. The hydrolysis rates of NOR under neutral and alkaline conditions were higher than that under acidic conditions in both aerobic and anoxic environments. The ions of Ca2+, Mg2+, HCO3-, CO32-, and NO3- in simulated water samples inhibited the hydrolysis of NOR, while Cl- promoted its hydrolysis. In addition, the electronegativity of NOR was determined by DFT calculations, and it was speculated that the active sites of NOR hydrolysis were mainly located in the piperazine ring and quinolone ring. The main hydrolysis pathway of NOR in aerobic environment was piperazine ring cracking and quinolone ring decomposition, and that in anoxic environment was piperazine ring cracking. The results are of great significance to evaluate the environmental fate of NOR in the HZ and provide a theoretical basis for further understanding the degradation and governance of fluoroquinolones in water environment.

Bisphenol S degradation via persulfate activation under UV-LED using mixed catalysts: Synergistic effect of Cu-TiO2 and Zn-TiO2 for catalysis

A photocatalyst composed of Zn-TiO₂ and Cu-TiO₂ through simple physical mixing was used to activate persulfate(PS) for Bisphenol S (BPS) degradation. Zn-TiO₂ and Cu-TiO₂ were prepared with a sol gel method and were characterized by X-ray diffraction (XRD), Raman, Transmission electron microscope (TEM), Fourier-transform infrared spectroscopy (FTIR) and X-ray photoelectron spectroscopy (XPS). The two catalysts have shown an obvious synergistic effect in the photocatalytic degradation process. When 5 mM persulfate and 0.3 g/L catalyst were used, the removal rate of mixed catalyst (0.2 g/L Zn-TiO₂ and 0.1 g/L Cu-TiO₂) is 100 % in 18 min, which is significantly better than that of 0.3 g/L Zn-TiO₂(58 %) and 0.3 g/L Cu-TiO₂(90 %). Typically, the effects of various operation parameters, including the ratio of Cu-TiO₂/Zn-TiO₂, catalyst dosage, persulfate dosage, initial concentration of BPS, and initial solution pH, were examined. Reactive oxygen species (ROS) in the UV/mixed catalyst/PS process was identified by scavenger and electron paramagnetic resonance (EPR) tests. The superoxide radicals generated by both Zn-TiO₂ and the hydrolysis of persulfate in the system could accelerate the Cu (II)/Cu(I) redox cycles and results in the synergistic effect. This study proposed a new and effective way to improve the reaction by simply combining two catalysts, and unraveled the mechanism behind the synergistic effect, which could provide new ideas to use the catalyst more effectively for wastewater treatment or other areas.

Highly efficient UV/H2O2 technology for the removal of nifedipine antibiotics: Kinetics, co-existing anions and degradation pathways

This study investigates the degradation of nifedipine (NIF) by using a novel and highly efficient ultraviolet light combined with hydrogen peroxide (UV/H2O2). The degradation rate and degradation kinetics of NIF first increased and then remained constant as the H2O2 dose increased, and the quasi-percolation threshold was an H2O2 dose of 0.378 mmol/L. An increase in the initial pH and divalent anions (SO42- and CO32-) resulted in a linear decrease of NIF (the R2 of the initial pH, SO42- and CO32- was 0.6884, 0.9939 and 0.8589, respectively). The effect of monovalent anions was complex; Cl- and NO3- had opposite effects: low Cl- or high NO3- promoted degradation, and high Cl- or low NO3- inhibited the degradation of NIF. The degradation rate and kinetics constant of NIF via UV/H2O2 were 99.94% and 1.45569 min-1, respectively, and the NIF concentration = 5 mg/L, pH = 7, the H2O2 dose = 0.52 mmol/L, T = 20 ℃ and the reaction time = 5 min. The ·OH was the primary key reactive oxygen species (ROS) and ·O2- was the secondary key ROS. There were 11 intermediate products (P345, P329, P329-2, P315, P301, P274, P271, P241, P200, P181 and P158) and 2 degradation pathways (dehydrogenation of NIF → P345 → P274 and dehydration of NIF → P329 → P315).

Preparation and Characterization of Phosphoric Acid-Modified Biochar Nanomaterials with Highly Efficient Adsorption and Photodegradation Ability

Phosphoric acid-modified biochar (PMBC) was prepared using biochar (BC) as the carbon source and phosphoric acid as the activating agent. The PMBC exhibited an ordered vessel structure after deashing treatment, but the sidewalls became much rougher, the polarity (O/C atomic ratio of BC = 0.2320 and O/C atomic ratio of PMBC = 0.1604) decreased, and the isoelectric points (PI of BC = 5.22 and PI of PMBC = 5.51) and specific surface area (SSA of BC = 55.322 m²/g and SSA of PMBC = 62.285 m²/g) increased. The adsorption characterization of the removal of sulfadiazine (SDZ) from PMBC was studied. The adsorption of SDZ by PMBC was in accordance with the Langmuir isotherm model and the pseudo-second-order kinetics model, and the adsorption thermodynamics were shown as Gibbs free energy < 0, an enthalpy change of 19.157 kJ/mol, and an entropy change of 0.0718 kJ/(K·mol). The adsorption of SDZ by PMBC was a complicated monolayer adsorption that was spontaneous, irreversible, and endothermic, and physical adsorption and chemical adsorption occurred simultaneously. The adsorption process was controlled by microporous capture, electrostatic interactions, hydrogen-bond interactions, and π-π interactions. PMBC@TiO₂ photocatalysts with different mass ratios between TiO₂ and PMBC were prepared via the in situ sol-gel method. PMBC@TiO₂ exhibited both an ordered vessel structure (PMBC) and irregular particles (TiO₂), and it was linked via Ti-O-C bonds. The optimal mass ratio between TiO₂ and PMBC was 3:1. The removal of SDZ via PMBC@TiO₂ was dependent on the coupling of adsorption and photocatalysis. The PMBC-enhanced photocatalytic performance of PMBC@TiO₂ resulted in a higher absorption of UV and visible light, greater generation of reactive oxygen species, high levels of adsorption of SDZ on PMBC, and the conjugated structure and oxygen-containing functional groups that promoted the separation efficiency of the hole-electron pairs.