CO2 cycloaddition to epoxides promoted by bis-thioether-phenolate Fe(II) and Fe(III) complexes

Ring-Opening Polymerization of Cyclohexene Oxide and Cycloaddition with CO2 Catalyzed by Amine Triphenolate Iron(III) Complexes

A series of novel amine triphenolate iron complexes were synthesized and characterized using UV, IR, elemental analysis, and high-resolution mass spectrometry. These complexes were applied to the ring-opening polymerization (ROP) of cyclohexene oxide (CHO), demonstrating excellent activity (TOF > 11050 h-1) in the absence of a co-catalyst. In addition, complex C1 maintained the dimer in the presence of the reaction substrate CHO, catalyzing the ring-opening polymerization of CHO to PCHO through bimetallic synergy. Furthermore, a two-component system consisting of iron complexes and TBAB displayed the ability to catalyze the reaction of CHO with CO2, resulting in the formation of cis-cyclic carbonate with high selectivity. Complex C4 exhibited the highest catalytic activity, achieving 80% conversion of CHO at a CHO/C4/TBAB molar ratio of 2000/1/8 and a CO2 pressure of 3 MPa for 16 h at 100 °C, while maintaining >99% selectivity of cis-cyclic carbonates, which demonstrated good conversion and selectivity.

Perfluoroaryl Zinc Catalysts Active in Cyclohexene Oxide Homopolymerization and Alternating Copolymerization with Carbon Dioxide

The zinc complex Zn(C6F5)2(toluene) (1) behaves as a very active and selective catalyst in cyclohexene oxide (CHO) polymerization to produce poly(cyclohexene oxide) (PCHO) by the trans-ring-opening of CHO with remarkable TOF values at room temperature. The ring-opening copolymerization (ROCOP) of CO2 with CHO catalysed by 1 yields poly(cyclohexene carbonate) (PCHC) when using benzyl alcohol (BnOH) as an initiator at 120°C. The 1H NMR monitoring of the in situ reaction of 1 with BnOH highlighted the formation of the dinuclear species [(C6F5)2Zn2(BnO)2 (2) that was isolated and found an active catalyst in the ROCOP of CO2 with CHO in the absence of initiators. Interestingly, PCHCs by 2 in solventless conditions show polydispersity index (Mw/Mn) values close to 2, corresponding to those expected for a single-site catalyst; on the contrary, a broader polydispersity index of the polymer products was found in toluene solution, suggesting the formation of new zinc catalysts during the polymerization reaction.

[OSSO]-Type Chromium(III) Complexes for the Reaction of CO2 with Epoxides

In this work, four new mononuclear Cr(III) complexes (2-5) bearing bis-thioether-diphenolate, [OSSO]-type ligands, were synthesized and characterized. These complexes in combination with bis(triphenylphosphine)iminium chloride (PPNCl) promoted the coupling of CO2 with epoxides. Depending on the type of substrate and the conditions, the reaction results in the selective formation of either polycarbonate or cyclic carbonate. For example, the reactions in the presence of complex 2 led to the exclusive formation of poly(cyclohexene carbonate, PCHC) from cyclohexene oxide (CHO) (TOF up to 39 h-1 , at T=45-100 °C, time=24 h, pCO2 =20 bar, epoxide/2 (mol/mol)=1000, and PPNCl/2=0.5-2.0 mol %). Under the same conditions and PPNCl/2=0.5-5.0 mol %, the reactions of CO2 with styrene oxide (SO), epichlorohydrin (ECH), 1,2 epoxydodecane (EDD), and allyl glycidyl ether (AGE) have shown selective conversion to the corresponding cyclic carbonates (TOF up to 41 h-1 ).

Experimental and theoretical investigation for the cycloaddition of carbon dioxide to epoxides catalyzed by potassium and boron co-doped carbon nitride

Much endeavor has been devoted to efficient heterogeneous catalysts for carbon dioxide (CO₂) conversion to high-value chemicals. Meanwhile, the cycloaddition of CO₂ to epoxides is considered as a green and atom-economy reaction to produce cyclic carbonates. Herein, a series of K, B co-doped CN with various doping contents (K, B-CN-X) were developed by simple one-step calcination of melamine and KBH₄. B was confirmed to replace the C site and KN bond was formed, which was verified by XPS (X-ray photoelectron spectroscopy) and DFT (density functional theory) calculation. Particularly, K, B-CN-4 displayed the optimal catalytic performance in the presence of Bu₄NBr (tetrabutylammonium bromide) cocatalyst for the CO₂ cycloaddition with propylene oxide. Besides, K, B-CN-4/Bu₄NBr catalyst exhibited good substrate versatility to various epoxides and excellent recycling performance. According to the DFT calculation on CO₂ adsorption and experimental results, K, B-CN-4 presented satisfactory catalytic activity due to the enhanced CO₂ adsorption after K and B dopings then the possible reaction mechanism was proposed. The promising K, B-CN-X catalyst presented an attractive application due to the simple, eco-friendly synthesis route for the efficient fixation of CO₂.

Study on Selected Metal-Organic Framework-Based Catalysts for Cycloaddition Reaction of CO2 with Epoxides: A Highly Economic Solution for Carbon Capture and Utilization

The level of carbon dioxide in the atmosphere is growing rapidly due to fossil fuel combustion processes, heavy oil, coal, oil shelter, and exhausts from automobiles for energy generation, which lead to depletion of the ozone layer and consequently result in global warming. The realization of a carbon-neutral environment is the main focus of science and academic researchers of today. Several processes were employed to minimize carbon dioxide in the air, some of which include the utilization of non-fossil sources of energy like solar, nuclear, and biomass-based fuels. Consequently, these sources were reported to have a relatively high cost of production and maintenance. The applications of both homogeneous and heterogeneous processes in carbon capture and storage were investigated in recent years and the focus now is on the conversion of CO2 into useful chemicals and compounds. It was established that CO2 can undergo cycloaddition reaction with epoxides under the influence of special catalysts to give cyclic carbonates, which can be used as value-added chemicals at a different level of pharmaceutical and industrial applications. Among the various catalysts studied for this reaction, metal-organic frameworks are now on the frontline as a potential catalyst due to their special features and easy synthesis. Several metal-organic framework (MOF)-based catalysts were studied for their application in transforming CO2 to organic carbonates using epoxides. Here, we report some recent studies of porous MOF materials and an in-depth discussion of two repeatedly used metal-organic frameworks as a catalyst in the conversion of CO2 to organic carbonates.

Dinuclear [OSSO]-Fe complexes for the reaction of CO2 with epoxides

Synthesis and characterization of new dinuclear iron complexes for the coupling of CO₂ with epoxides. A bimetallic cooperative reaction mechanism is proposed on the basis of kinetic analyses.

Metal Complexes Bearing Sulfur-Containing Ligands as Catalysts in the Reaction of CO2 with Epoxides

Coupling of CO2 with epoxides is a green emerging alternative for the synthesis of cyclic organic carbonates (COC) and aliphatic polycarbonates (APC). The scope of this work is to provide a comprehensive overview of metal complexes having sulfur-containing ligands as homogeneous catalytic systems able to efficiently promote this transformation with a concise discussion of the most significant results. The crucial role of sulfur as the hemilabile ligand and its influence on the catalytic activity are highlighted as well.

A Novel [OSSO]-Type Chromium(III) Complex as a Versatile Catalyst for Copolymerization of Carbon Dioxide with Epoxides

A new chromium(III) complex, bearing a bis-thioether-diphenolate [OSSO]-type ligand, was found to be an efficient catalyst in the copolymerization of CO₂ and epoxides to achieve poly(propylene carbonate), poly(cyclohexene carbonate), poly(hexene carbonate) and poly(styrene carbonate), as well as poly(propylene carbonate)(cyclohexene carbonate) and poly(propylene carbonate)(hexene carbonate) terpolymers.

Mechanistic guidelines in nonreductive conversion of CO2: the case of cyclic carbonates

This perspective provides general mechanistic guidelines for the catalytic formation of cyclic organic carbonates from CO₂ and cyclic ethers.

Salalen vs. thiolen: in the ring(-opening of epoxide and cyclic carbonate formation)

A range of Fe(iii)-salalen and -thiolen–chloride complexes have been prepared and are shown to be active catalysts for the selective coupling of CO₂ and cyclohexene oxide (CHO).