Energy flow analysis of amputee walking shows a proximally-directed transfer of energy in intact limbs, compared to a distally-directed transfer in prosthetic limbs at push-off

Absent loading response knee flexion: The impact on gait kinetics and centre of mass motion in individuals with unilateral transfemoral amputation, and the effect of microprocessor controlled knee provision

BACKGROUND

Individuals with unilateral transfemoral amputation walk with increased levels of asymmetry, and this is associated with reduced gait efficiency, back pain and overuse of the intact limb. This study investigated the effect of walking with a unilateral absence of loading response knee flexion on the symmetry of anterior-posterior kinetics and centre of mass accelerations.

METHODS

A retrospective cohort study design was used, assessing three-dimensional gait data from individuals with unilateral transfemoral amputation (n = 56). The anterior-posterior gait variables analysed included; peak ground reaction forces, impulse, centre of mass acceleration, as well as rate of vertical ground reaction force increase in early stance. With respect to these variables, this study assessed the symmetry between intact and prosthetic limbs, compared intact limbs against a healthy unimpaired control group, and evaluated effect on symmetry of microprocessor controlled knee provision.

FINDINGS

Significant between-limb asymmetries were found between intact and prosthetic limbs across all variables (p < 0.0001). Intact limbs showed excessive loading when compared with control group limbs after speed normalisation across all variables (p < 0.0001). No improvement in kinetic symmetry following microprocessor controlled knee provision was found.

INTERPRETATION

The gait asymmetries for individuals with transfemoral amputation identified in this study suggest that more should be done by developers to address the resultant overloading of the intact limb, as this is thought to have negative long-term effects. The provision of microprocessor controlled knees did not appear to improve the asymmetries faced by individuals with transfemoral amputation, and clinicians should be aware of this when managing patient expectations.

Task and Skill Level Constraints on the Generality of the Proximal–Distal Principle for Within-Limb Movement Coordination

This paper examines the influence of task and skill level constraints on the generality of proximal–distal control for within-limb movement coordination. Analysis and synthesis of the experimental findings leads to the proposition that proximal–distal is one of several within-limb patterns of coordination, including: the reverse distal–proximal sequence, simultaneous activation of segments, and other sequence variations of this. The probability of particular patterns occurring is induced by task constraints and skill level of the individual, together with their evolving biomechanical consequences, including: open/closed chain, absorption/propulsion of force, magnitude of momentum, and accuracy/timing. We develop the theoretical perspective that classes of task constraints induce particular types of neuromechanical organization to within-arm or within-leg segment coordination. In this task constraint framework, proximal–distal within-limb organization is a particular rather than a general case for within-limb coordination. The limitations of anatomically-based accounts of directional change for within-limb organization are discussed with reference to a general functional degrees of freedom task constraint framework for movement coordination and control.

Prosthetic push-off power in trans-tibial amputee level ground walking: A systematic review

OBJECTIVE

Unilateral trans-tibial amputation signifies a challenge to locomotion. Prosthetic ankle-foot units are developed to mimic the missing biological system which adapts push-off power to walking speed in some new prosthetic ankle-foot designs. The first systematic review including the two factors aims to investigate push-off power differences among Solid Ankle Cushion Heel (SACH), Energy Storage And Return (ESAR) and Powered ankle-foot units (PWR) and their relation to walking speed.

DATA SOURCES

A literature search was undertaken in the Web of Science, PubMed, IEEE xplore, and Google Scholar databases. The search term included: ampu* AND prosth* AND ankle-power AND push-off AND walking.

STUDY APPRAISAL AND SYNTHESIS METHODS

Studies were included if they met the following criteria: unilateral trans-tibial amputees, lower limb prosthesis, reported analysis of ankle power during walking. Data extracted from the included studies were clinical population, type of the prosthetic ankle-foot units (SACH, ESAR, PWR), walking speed, and peak ankle power. Linear regression was used to determine whether the push-off power of different prosthetic ankle-foot units varied regarding walking speed. Push-off power of the different prosthetic ankle-foot units were compared using one-way between subjects' ANOVAs with post hoc analysis, separately for slower and faster walking speeds.

RESULTS

474 publications were retrieved, 28 of which were eligible for inclusion. Correlations between walking speed and peak push-off power were found for ESAR (r = 0.568, p = 0.006) and PWR (r = 0.820, p = 0.000) but not for SACH (r = 0.267, p = 0.522). ESAR and PWR demonstrated significant differences in push-off power for slower and faster walking speeds (ESAR (p = 0.01) and PWR (p = 0.02)).

CONCLUSION

Push-off power can be used as a selection criterion to differentiate ankle-foot units for prosthetic users and their bandwidth of walking speeds.

The influence of a microprocessor-controlled hydraulic ankle on the kinetic symmetry of trans-tibial amputees during ramp walking: A case series

Introduction

Asymmetrical limb loading is believed to cause health problems for lower limb amputees and is exacerbated when walking on slopes. Hydraulically damped ankle-feet improve ground compliance on slopes compared to conventional prosthetic feet. Microprocessor-controlled hydraulic ankle-feet provide further adaptation by dynamically adjusting viscoelastic damping properties.

Method

Using a case series design, gait analysis was performed with four trans-tibial amputees. There were two walking conditions (ramp ascent and descent) and two prosthetic foot conditions (microprocessor-control on and off – MPF-on and MPF-off). Total support moment integral (MIsup) and degree-of-asymmetry were compared across foot conditions.

Results

During ramp descent, the transition of prosthetic ankle moment from dorsiflexion to plantarflexion occurred earlier in stance phase with MPF-on, slowing the angular velocity of the shank. During ramp ascent, the MPF-on dorsiflexion/plantarflexion moment transition occurred later, meaning less resistance to shank rotation in early stance and increasing walking speed by up to 6%. For both slope conditions, sound limb MIsup was universally decreased with MPF-on (4–13% descent, 3–11% ascent).

Discussion

Microprocessor-control of hydraulic ankle-feet reduced the total loading of the sound limb joints, for both walking conditions, for all participants. This may have beneficial consequences for long-term joint health and walking efficiency.

Performance of Optimized Prosthetic Ankle Designs That Are Based on a Hydraulic Variable Displacement Actuator (VDA)

Current energy storage and return prosthetic feet only marginally reduce the cost of amputee locomotion compared with basic solid ankle cushioned heel feet, possibly due to their lack of push-off at the end of stance. To the best of our knowledge, a prosthetic ankle that utilizes a hydraulic variable displacement actuator (VDA) to improve push-off performance has not previously been proposed. Therefore, here we report a design optimization and simulation feasibility study for a VDA-based prosthetic ankle. The proposed device stores the eccentric ankle work done from heel strike to maximum dorsiflexion in a hydraulic accumulator and then returns the stored energy to power push-off. Optimization was used to establish the best spring characteristic and gear ratio between ankle and VDA. The corresponding simulations show that, in level walking, normal push-off is achieved and, per gait cycle, the energy stored in the accumulator increases by 22% of the requirements for normal push-off. Although the results are promising, there are many unanswered questions and, for this approach to be a success, a new miniature, low-losses, and lightweight VDA would be required that is half the size of the smallest commercially available device.

Prosthetic energy return during walking increases after 3 weeks of adaptation to a new device

Background

There are many studies that have investigated biomechanical differences among prosthetic feet, but not changes due to adaptation over time. There is a need for objective measures to quantify the process of adaptation for individuals with a transtibial amputation. Mechanical power and work profiles are a primary focus for modern energy-storage-and-return type prostheses, which strive to increase energy return from the prosthesis. The amount of energy a prosthesis stores and returns (i.e., negative and positive work) during stance is directly influenced by the user’s loading strategy, which may be sensitive to alterations during the course of an adaptation period. The purpose of this study was to examine changes in lower limb mechanical work profiles during walking following a three-week adaptation to a new prosthesis.

Methods

A retrospective analysis was performed on 22 individuals with a unilateral transtibial amputation. Individuals were given a new prosthesis at their current mobility level (K3 or above) and wore it for three weeks. Kinematic and kinetic measures were recorded from overground walking at 0, 1.5, and 3 weeks into the adaptation period at a self-selected pace. Positive and negative work done by the prosthesis and sound ankle-foot were calculated using a unified deformable segment model and a six-degrees-of-freedom model for the knee and hip.

Results

Positive work from the prosthesis ankle-foot increased by 6.1% and sound ankle-foot by 5.7% after 3 weeks (p = 0.041, 0.036). No significant changes were seen in negative work from prosthesis or sound ankle-foot (p = 0.115, 0.192). There was also a 4.1% increase in self-selected walking speed after 3 weeks (p = 0.038). Our data exhibited large inter-subject variations, in which some individuals followed group trends in work profiles while others had opposite trends in outcome variables.

Conclusions

After a 3-week adaptation, 14 out of 22 individuals with a transtibial amputation increased energy return from the prosthesis. Such findings could indicate that individuals may better utilize the spring-like function of the prosthesis after an adaptation period.

Electronic supplementary material

The online version of this article (10.1186/s12984-018-0347-1) contains supplementary material, which is available to authorized users.