Ion transport dependence on the ion pairing/solvation competition in cation-exchange membranes

An Opportunity for Synergizing Desalination by Membrane Distillation Assisted Reverse-Electrodialysis for Water/Energy Recovery

Industry, agriculture, and a growing population all have a major impact on the scarcity of clean-water. Desalinating or purifying contaminated water for human use is crucial. The combination of thermal membrane systems can outperform conventional desalination with the help of synergistic management of the water-energy nexus. High energy requirement for desalination is a key challenge for desalination cost and its commercial feasibility. The solution to these problems requires the intermarriage of multidisciplinary approaches such as electrochemistry, chemical, environmental, polymer, and materials science and engineering. The most feasible method for producing high-quality freshwater with a reduced carbon footprint is demanding incorporation of industrial low-grade heat with membrane distillation (MD). More precisely, by using a reverse electrodialysis (RED) setup that is integrated with MD, salinity gradient energy (SGE) may be extracted from highly salinized MD retentate. Integrating MD-RED can significantly increase energy productivity without raising costs. This review provides a comprehensive summary of the prospects, unresolved issues, and developments in this cutting-edge field. In addition, we summarize the distinct physicochemical characteristics of the membranes employed in MD and RED, together with the approaches for integrating them to facilitate effective water recovery and energy conversion from salt gradients and freshwater.

Concepts and Misconceptions Concerning the Influence of Divalent Ions on the Performance of Reverse Electrodialysis Using Natural Waters

Divalent ions have a negative effect on the obtained power and efficiency of the reverse electrodialysis (RED) process when using natural waters. These effects can largely be attributed to the interaction between the various ions and the membranes, resulting in a decreased membrane voltage, an increased membrane resistance, and uphill transport of divalent ions. The aim of this study was to investigate the causes of these differences and, if possible, to find underlying causes. The approach mainly followed that in literature articles that specifically focused on the effect of divalent ions on RED. It transpired that seven publications were useful because the methodology was well described and sufficient data was published. I found two widely shared misconceptions. The first concerns the role of the stack voltage in uphill transport of divalent ions; itis often thought that the open circuit voltage (OCV) must be taken into account, but it is plausible that the voltage under working conditions is the critical factor. The second debatable point concerns the methodology used to make a series of solutions to study the effect of divalent ions. Typically, solutions with a constant number of moles of salt are used; however, it is better to make a series with a constant ratio of equivalents of those salts. Moreover, it is plausible that the decreased voltage can be explained by the inherently lower Donnan potential of multi-charged ions and that increased resistance is caused by the fact that divalent ions-with a lower mobility there than the monovalent ions-occupy relatively much of the available space in the gel phase of the membrane. While both resistance and voltage play a decisive role in RED and probably also in other membrane processes like electrodialysis (ED), it is remarkable that there are so few publications that focus on measurements on individual membranes. The implications of these results is that research on the effect of divalent ions in RED, ED and similar processes needs to be more structured in the future. Relatively simple procedures can be developed for the determination of membrane resistance in solutions of mixtures of mono- and divalent salts. The same applies to determining the membrane potential. The challenge is to arrive at a standard method for equipment, methodology, and the composition of the test solutions.