Iron catalyzed degradation of an aromatic polyamide reverse osmosis membrane by free chlorine

Comparative Degradation Kinetics Study of Polyamide Thin Films in Aqueous Solutions of Chlorine and Peracetic Acid Using Quartz Crystal Microbalance

Polyamide thin film composite membranes are widely used in water reclamation. Peracetic acid (PAA) is an emerging wastewater disinfectant with a potential for membrane cleaning and disinfection; however, its interaction with polyamide remains poorly understood. This study employs quartz crystal microbalance with dissipation (QCM-D) to determine the PAA-induced degradation kinetics of polyamide thin films, in comparison with the conventional disinfectant-free chlorine (HOCl). Polyamide films showed a sorption phase followed by a degradation phase when exposed to PAA (1000 mg L^-1) and HOCl (100 mg L^-1) solutions. While the sorption phase in HOCl experiments was short (1.4-3.5 min) and followed a Boltzmann-sigmoidal model, it spanned over 3-33 h in PAA experiments and displayed a two-stage behavior. The latter kinetics are attributed to sequential processes of the physical sorption of PAA in polyamide films followed by PAA-induced polyamide oxidation. In the degradation phase, the HOCl-exposed films followed a rapid, two-step exponential decay reaching an equilibrium mass of ∼50% of the initial (wet) mass after ∼5 h of exposure. In contrast, the PAA-exposed films followed a Boltzmann-sigmoidal decay, with ∼80% of the initial (wet) mass remaining intact after >10 h of exposure. Fast force maps generated using atomic force microscopy showed a progressive increase in the morphological heterogeneity of the polyamide films in HOCl solution due to pitting, cracking, bulging, and eventual delamination under both flow and no-flow conditions. In contrast, PAA only formed small pits on the polyamide film under flow; in a stagnant PAA solution, the film had no visible changes even after ∼148 h of exposure. This is the first comparative study on the chemical and morphological changes in polyamide films induced by PAA and HOCl. The much higher compatibility of polyamide with PAA than with chlorine supports the potential of PAA being used as a halogen-free membrane cleaning/disinfecting agent.

Hypochlorite and visible-light irradiation affect the transformation and toxicity of graphene oxide

Graphene oxide (GO) that has many advanced properties, has been applied in various fields, such as water treatments and removal of contaminations. Hypochlorite is widely used in water treatments. However, the effects of hypochlorite on the transformations and risks of GO, and the toxicological responses remain largely unknown, especially under visible-light irradiation. The present work found that visible-light irradiation promoted the breakdown of sp² structures of GO by hypochlorite, producing alkanes and arenes with short carbon skeletons. Compared to oxygen-containing radicals, chlorine-related radicals contributed to the breakdown of carbon atomic rings of GO. Compared to pristine GO, the transformed GO inhibited algal reproduction, reduced photosynthesis, and promoted oxidative stress and membrane permeability. Substantial plasmolysis and increased numbers of starch grains were observed in the exposure groups. Metabolomics analysis found that oxidative stress and increased membrane permeability linked to downregulated proline. The downregulated pathways of alanine, aspartate and glutamate metabolism were associated with the inhibition of algal reproduction. The downregulated pathways related to protein synthesis and the secondary metabolism explained the strong toxicity induced by GO with hypochlorite and visible-light irradiation. The above results provide insight into the safety assessment of GO.

Pd/Fe nanoparticle integrated PMAA-PVDF membranes for chloro-organic remediation from synthetic and site groundwater

The poly(methacrylic acid) (PMAA) was synthesized in the pores of commercial microfiltration PVDF membranes to allow incorporation of catalytic palladium/iron (Pd/Fe) nanoparticles for groundwater remediation. Particles of 17.1 ± 4.9 nm size were observed throughout the pores of membranes using a focused ion beam. To understand the role of Pd fractions and particle compositions, 2-chlorobiphenyl was used as a model compound in solution phase studies. Results show H2 production (Fe0 corrosion in water) is a function of Pd coverage on the Fe. Insufficient H2 production caused by higher coverage (> 10.4% for 5.5 wt%) hindered dechlorination rate. With 0.5 wt% Pd, palladized-Fe reaction rate (surface area normalized reaction rate, ksa = 0.12 L/(m2-h) was considerably higher than isolated Pd and Fe particles. For groundwater, in a single pass of Pd/Fe-PMAA-PVDF membranes (0.5 wt% Pd), chlorinated organics, such as trichloroethylene (177 ppb) and carbon tetrachloride (35 ppb), were degraded to 16 and 0.3 ppb, respectively, at 2.2 seconds of residence time. The degradation rate (observed ksa) followed the order of carbon tetrachloride > trichloroethylene > tetrachloroethylene > chloroform. A 36 h continuous flow study with organic mixture and the regeneration process show the potential for on-site remediation.