Insight into organic fouling behavior in polyamide thin-film composite forward osmosis membrane: Critical flux and its impact on the economics of water reclamation

Smart utilisation of reverse solute diffusion in forward osmosis for water treatment: A mini review

Forward osmosis (FO) has been widely studied as a promising technology in wastewater treatment, but undesirable reverse solute diffusion (RSD) is inevitable in the FO process. The RSD is generally regarded as a negative factor for the FO process, resulting in the loss of draw solutes and reduced FO efficiency. Conventional strategies to address RSD focus on reducing the amount of reverse draw solutes by fabricating high selective FO membranes and/or selecting the draw solute with low diffusion. However, since RSD is inevitable, doubts have been raised about the strategies to cope with the already occurring reverse draw solutes in the feed solution, and the feasibility to positively utilise the RSD phenomenon to improve the FO process. Herein, we review the state-of-the-art applications of RSD and their benefits such as improving selectivity and maintaining the stability of the feed solution for both independent FO processes and FO integrated processes. We also provide an outlook and discuss important considerations, including membrane fouling, membrane development and draw/feed solution properties, in RSD utilisation for water and wastewater treatment.

Synergistic effects of microplastics and organic foulants on the performance of forward osmosis membranes

Microplastics (MPs) are emerging contaminants that are abundantly present in the influent and effluent of wastewater treatment plants (WWTPs). Forward osmosis (FO) is an advanced treatment technology with potential applications in WWTPs. The presence of MPs in WWTP effluents can contribute to FO fouling and performance deterioration. This study focuses on FO membrane fouling by MPs of different sizes, and the interactional impacts of MPs and Humic acid (HA) (as the most common organic foulant in WWTPs) on FO membrane performance. The synergistic effect of combined MPs and HA fouling is shown to cause higher flux decline for FO membranes than that of HA or MPs alone. Reverse salt flux increased in the presence of MPs, and decreased when HA was present. Further, full flux recovery was obtained for all fouled membranes after hydraulic cleaning. This indicates the efficiency of FO systems for treating wastewater with high fouling potential. This study highlights the necessity of considering MPs in studying fouling behaviour, and for mitigation strategies of membranes used in WWT. The fundamentals created here can be further extended to other membrane-assisted separation processes.

Microalgae production in human urine: Fundamentals, opportunities, and perspectives

The biological treatment of source-separated human urine to produce biofuel, nutraceutical, and high-value chemicals is getting increasing attention. Especially, photoautotrophic microalgae can use human urine as media to achieve environmentally and economically viable large-scale cultivation. This review presents a comprehensive overview of the up-to-date advancements in microalgae cultivation employing urine in photobioreactors (PBRs). The standard matrices describing algal growth and nutrient removal/recovery have been summarized to provide a platform for fair comparison among different studies. Specific consideration has been given to the critical operating factors to understand how the PBRs should be maintained to achieve high efficiencies. Finally, we discuss the perspectives that emphasize the impacts of co-existing bacteria, contamination by human metabolites, and genetic engineering on the practical microalgal biomass production in urine.

Impact of Graphene Oxide on Properties and Structure of Thin-Film Composite Forward Osmosis Membranes

Forward osmosis (FO) membranes have the advantages of low energy consumption, high water recovery rate, and low membrane pollution trend, and they have been widely studied in many fields. However, the internal concentration polarization (ICP) caused by the accumulation of solutes in the porous support layer will reduce permeation efficiency, which is currently unavoidable. In this paper, we doped Graphene oxide (GO) nanoparticles (50~150 nm) to a polyamide (PA) active layer and/or polysulfone (PSF) support layer, investigating the influence of GO on the morphology and properties of thin-film composite forward osmosis (TFC-FO) membranes. The results show that under the optimal doping amount, doping GO to the PA active layer and PSF support layer, respectively, is conducive to the formation of dense and uniform nano-scale water channels perpendicular to the membrane surface possessing a high salt rejection rate and low reverse solute flux without sacrificing high water flux. Moreover, the water channels formed by doping GO to the active layer possess preferable properties, which significantly improves the salt rejection and water permeability of the membrane, with a salt rejection rate higher than 99% and a water flux of 54.85 L·m⁻²·h⁻¹ while the pure PSF-PA membrane water flux is 12.94 L·m⁻²·h⁻¹. GO-doping modification is promising for improving the performance and structure of TFC-FO membranes.

Influence of hydrodynamic operating conditions on organic fouling of spiral-wound forward osmosis membranes: Fouling-induced performance deterioration in FO-RO hybrid system

The forward osmosis-reverse osmosis (FO-RO) hybrid process has been extensively researched as part of attempts to reduce the high energy consumption of conventional seawater reverse osmosis in recent years. FO operating conditions play a substantial role in the hybrid process, dictating not only the performance of the entire system but also the propensity for fouling, which deteriorates performance in long-term field operations. Therefore, determining the optimal FO operating conditions with regard to membrane fouling may promote sustainable operation through efficient fouling control. This study thus evaluated the influence of each hydrodynamic operating condition (feed flowrate, draw flowrate, and hydraulic pressure difference) and their synergistic effects on fouling propensity in a pilot-scale FO operation under seawater and municipal wastewater conditions. Fouling-induced variation in water flux, channel pressure drop, diluted concentration, and the resulting specific energy consumption (SEC) were comparatively analyzed and utilized to project performance variation in a full-scale FO-RO system. Fouling-induced performance reduction significantly varied depending on hydrodynamic operating conditions and the resultant fouling propensity during 15 days of continuous operation. A high feed flowrate demonstrated a clear ability to mitigate fouling-induced performance deterioration in all conditions. A high draw flowrate turned out to be detrimental for fouling propensity since its high reverse solute flux accelerated fouling growth. Applying additional hydraulic pressure during FO operation caused a faster reduction of water flux, and thus feed recovery and water production; however, these drawbacks could be compensated for by a 10% reduction in the required FO membrane area and an additional reduction in RO SEC.

Organic Fouling in Forward Osmosis: A Comprehensive Review

Organic fouling in the forward osmosis process is complex and influenced by different parameters in the forward osmosis such as type of feed and draw solution, operating conditions, and type of membrane. In this article, we reviewed organic fouling in the forward osmosis by focusing on wastewater treatment applications. Model organic foulants used in the forward osmosis literature were highlighted, which were followed by the characteristics of organic foulants when real wastewater was used as feed solution. The various physical and chemical cleaning protocols for the organic fouled membrane are also discussed. The study also highlighted the effective pre-treatment strategies that are effective in reducing the impact of organic fouling on the forward osmosis (FO) membrane. The efficiency of cleaning methods for the removal of organic fouling in the FO process was investigated, including recommendations on future cleaning technologies such as Ultraviolet and Ultrasound. Generally, a combination of physical and chemical cleaning is the best for restoring the water flux in the FO process.