Evaluation of a proficiency test on cadmium and lead in herbal material using assigned reference values

Determination of cadmium in sediments by diluted HCI extraction and isotope dilution ICP-MS

Isotope dilution ICP-MS is proposed to measure the mass fraction of Cd extracted by diluted HCl in marine sediments, using a fast and simple extraction procedure based on ultrasonic probe agitation. The ¹¹¹Cd isotope was added before the extraction to achieve isotope equilibration with native Cd solubilized from the sample. The parameters affecting trueness and precision of isotope ratio measurements were evaluated carefully and subsequently corrected in order to minimize errors; they were: detector dead time, spectral interferences, mass discrimination factor and optimum sample/spike ratio. The mass fraction of Cd extracted was compared with the sum of the certified contents of the three steps of the sequential extraction procedure of the Standards, Measurements and Testing Programme (SM&T) analysing the BCR 701 sediment to validate the method. The certified and measured values agreed, giving a measured / certified mass fraction ratio of 1.05. Further, the extraction procedure itself was studied by adding the enriched isotope after the extraction step, which allowed verifying that analyte losses occurred during this process. Two additional reference sediments with certified total cadmium contents were also analysed. The method provided very good precision (0.9%, RSD) and a low detection limit, 1.8 ng g^-1. The procedural uncertainty budget was estimated following the EURACHEM Guide by means of the 'GUM Workbench' software, obtaining a relative expanded uncertainty of 1.5%. The procedure was applied to determine the bioaccessible mass fraction of Cd in sediments from two environmentally and economically important areas of Galicia (rias of Arousa and Vigo, NW of Spain).

Identification of possible technical problems in determination of the major inorganic constituents of brown-rice flour by evaluating proficiency test results

To support skill upgrading in analysis of inorganic constituents of environmental and food samples, the National Metrology Institute of Japan (NMIJ) and the National Food Research Institute (NFRI) have organized a proficiency test (PT) of determination of Mn, Fe, Cu, Zn, As, and Cd in brown-rice flour based on the international standard (ISO/IEC 17043:2010). One hundred and thirty-three sets of reports were assessed by use of the E(n)-number and z-score approaches in accordance with ISO/IEC 17043 and the international harmonized protocol for PT. The PT results and analytical procedures, reported in detail, were reviewed, and possible technical reasons for questionable or unsatisfactory results are discussed.