Ultrasound-assisted solvent extraction of porous membrane packed solid samples: A new approach for extraction of target analytes from solid samples

Extraction of Organochlorine Pesticides from Porous Membrane Packed Dried Fish Samples: Method Development and Greenness Evaluation

In this work, ultrasound-assisted solvent extraction was utilized for extraction of organochlorine pesticides from membrane-protected dried fish samples. The dried fish samples were packed inside a porous membrane bag which was immersed in a solvent and subjected to ultrasonication. After the extraction process, the sample-containing bag was separated from the extract. Since samples were packed inside the membrane, their separation did not require centrifugation or filtration. Moreover, the complex components of the biota matrix may also retain inside the porous membrane bag, alleviating the requirement of extract cleanup before analysis. The parameters that can affect the ultrasound-assisted solvent extraction of membrane-protected dried fish samples were suitably optimized. These parameters include the extraction solvent and its volume, the sample amount, ultrasound intensity and extraction time. Under the optimum extraction conditions, good linearity was achieved for all the tested organochlorine pesticides, with the coefficients of determination (R2) higher than 0.9922 for the linear ranges from 5–1000, 10–1000 and 20–1000 ng/g. The values of intra-day and inter-day relative standard deviations were ≤13.8%. The limit of detection ranged from 1.5 to 6.8 ng/g. The spiked relative recoveries were in the range of 87.3–104.2%. This method demonstrated excellent figures of merit and could find potential applications in routine analytical laboratories. Finally, the greenness of this method was evaluated using the green analytical procedure index and analytical greenness calculator metrics.

Trends in Innovations and Recent Advances in Membrane Protected Extraction Techniques for Organics in Complex Samples

Membrane protected extraction is an ongoing innovation for isolation and pre-concentration of analytes from complex samples. The extraction process, clean-up and pre-concentration of analytes occur in a single step. The inclusion of solid sorbents such as molecularly imprinted polymers (MIPs) after membrane extraction ensures that selective double extraction occurs in a single step. The first step involves selective extraction using the membrane and diffused analytes are trapped on the solid sorbent enclosed in the membrane. No further clean-up is required even for very dirty samples like plant extracts and wastewaters samples. Sample clean-up occurs during extraction in the first process and not as additional step since matrix components are prevented from trapping on the sorbent. This can be referred to as prevention is better than cure approach. In this work, the analytical methods that employed membrane protected extraction for various organics such as pesticides, polycyclic aromatic hydrocarbons, and pharmaceuticals are reviewed. The designs of these analytical methods, their applications, advantages and drawbacks are discussed in this review. Literature suggests that the introduction of solid sorbents in membrane creates the much-needed synergy in selectivity. Previous reviews focused on membrane combinations with MIPs while discussing micro-solid-phase extraction. The scope of this review was broadened to include other sample preparation aspects such as membrane protected stir bar solvent extraction and membrane protected solid-phase microextraction. In addition, novel sample preparation methods for solid samples which include Soxhlet membrane protected molecular imprinted solid phase extraction and membrane protected ultra sound assisted extracted are discussed.

Development of Membrane-Based Inverted Liquid-Liquid Extraction for the Simultaneous Extraction of Eight Metals in Seawater before ICP-OES Analysis

In this work, we developed an extraction technique that can handle simple as well as complex matrixed liquid (aqueous) samples. In the standard liquid-liquid extraction, it is quite challenging to deal with complex liquid samples as they may complicate the process of phase separation and may lead to the formation of multiple layers. To resolve this issue, we have proposed a simple but unique idea that suggests the packing of the liquid samples inside a porous membrane bag. The edges of the membrane bag can be sealed using an electrical heat-sealer. The porous membrane bag filled with the liquid sample was immersed in an extraction solvent, and the extraction process was assisted by mechanical shaking. In order to demonstrate the proof of concept, a method was developed for the extraction of metals from seawater samples. The pH-adjusted sample, along with the complexing reagent, was packed inside the porous membrane bag, and the chelated complex was then extracted by immersing and shaking the bag inside the organic solvent. The solvent was then evaporated, and the chelated complex was dissolved/digested in acid with the aid of the heat. The final extract was subjected to Inductively Coupled Plasma-Optical Emission Spectroscopy (ICP-OES) analysis. The proposed method was used for extraction of eight metals (Cd, Co, Cu, Mo, Ni, Pb, V and Zn) from seawater samples and good extraction recoveries (75-94%) were obtained.

Direct immersion single-drop microextraction of semi-volatile organic compounds in environmental samples: A review

Single-drop microextraction (SDME) techniques are efficient approaches to pretreatment of aqueous samples. The main advantage of SDME lies in the miniaturization of the solvent extraction process, minimizing the hazards associated with the use of toxic organic solvents. Thus, SDME techniques are cost-effective, and represent less harm to the environment, subscribing to green analytical chemistry principles. In practice, two main approaches can be used to perform SDME - direct immersion (DI)-SDME and headspace (HS)-SDME. Even though the DI-SDME has been shown to be quite effective for extraction and enrichment of various organic compounds, applications of DI-SDME are normally more suitable for moderately polar and non-polar semi-volatile organic compounds (SVOCs) using organic solvents which are immiscible with water. In this review, we present a historical overview and current advances in DI-SDME, including the common analytical tools which are usually coupled with DI-SDME. The review also focuses on applications concerning SVOCs in environmental samples. Currents trends in DI-SDME and possible future direction of the procedure are discussed.

Ultrasound-Assisted Solvent Extraction of a Porous Membrane Packed Sample for the Determination of Tobacco-Specific Nitrosamines in the Replacement Liquids for E-Cigarettes

The content of tobacco-specific nitrosamines (TSNAs) possessing carcinogenic properties has been an important area of research since replacement liquids were introduced for e-cigarettes. A method for determining N'-nitrosonornicotine (NNN), 4-(methylnitrosamino)-1-(3-pyridyl)-1-butanone (NNK), N'-nitrosoanatabine (NAT), and N'-nitrosoanabasine (NAB) in replacement liquids for electronic cigarettes was developed using liquid chromatography-tandem mass spectrometry with electrospray ionisation (HPLC-ESI-MS/MS) in the multiple reaction monitoring mode. The sample preparation of replacement liquids was accomplished via the ultrasound-assisted solvent extraction of a porous membrane packed sample. The sample preparation proved to be successful in extracting the analytes, with recoveries from 87% to 105%, with coefficients of variation < 4.9%. Moreover, the linearity and limits of detection and quantitation (LOD, LOQ), together with repeatability and accuracy, were determined for the developed method. The proposed sample preparation and developed chromatographic method were successfully applied to the determination of TSNAs in 9 replacement liquid samples. The NNK and NNN were found to be most frequently detected (89 and 67%, respectively), with concentration ranges from 1.2-54.3 ng/mL and 4.1-30.2 ng/mL, respectively, while NAT was detected with frequency of 22% with range 1.7-2.5 ng/mL and NAB were found to be below the LOD in all samples.

Applications of Hollow-Fiber and Related Microextraction Techniques for the Determination of Pesticides in Environmental and Food Samples—A Mini Review

Pesticides represent one of the most important groups of analytes in environmental analysis. Moreover, their levels are very frequently determined in food and beverages due to the concern over their possible adverse health effects. Their concentration in samples is usually very low; thus, they have to be preconcentrated. Conventional solvent and solid-phase extractions are mainly used for this purpose, but miniaturized approaches are also being applied more and more often. The present review covers solvent microextractions that use a semi-permeable membrane barrier between the sample and the solvent. The main representatives of this approach are hollow-fiber microextraction (HFME), solvent bar microextraction (SBME), electromembrane extraction (EME), and different variations of those, such as combinations with other sorbent or solvent microextractions, electromigration, etc. The relevant research from the last decade, dealing with the application of these microextractions to the isolation of pesticides from various environmental and food samples, is critically discussed with emphasis on their strengths and weak points.

Organic Acids and Polyphenols Determination in Polish Wines by Ultrasound-Assisted Solvent Extraction of Porous Membrane-Packed Liquid Samples

In the near future, Poland is going to have more and more favorable conditions for viticulture. Organic acids and polyphenols are among the most commonly analyzed compounds due to their beneficial properties for human health and their importance in the winemaking process. In this work, a new technique involving ultrasound-assisted solvent extraction of porous membrane-packed liquid samples (UASE-PMLS) was for the first time described and applied for real samples. The methodology based on UASE-PMLS for organic acids and polyphenols in wine samples was optimized and validated. Using the new technique coupled to GC–MS, organic acids and polyphenols were evaluated in Polish wine samples. Extraction solvent, extraction temperature, derivatization time and sample pH were optimized. Chemometric tools were used for data treatment. Good linearity was obtained for the concentration ranges evaluated with r values between 0.9852 and 0.9993. All parameters of method validation (intra- and inter-day precision and matrix effect) were over 80% with coefficient of variation (CV) up to 17%. Recovery was between (92.0 ± 8.5)% and (113 ± 16)%. Finally, green assessment was evaluated using Analytical Eco-Scale and Green Analytical Procedure Index (GAPI). The UASE-PMLS is characterized by many advantages, e.g., the extraction process is fast and easy coupled to GC–MS. Regarding other extraction techniques, the amount of used solvent is minimum, and no waste is generated. Therefore, it is an environmentally friendly technique.