Determination of trace inorganic antimony in PET-bottled soy sauce by ion chromatography-inductively coupled plasma mass spectrometry

Simple and Fast Two-Step Fully Automated Methodology for the Online Speciation of Inorganic Antimony Coupled to ICP-MS

A very simple, fast and non-chromatographic methodology for inorganic antimony speciation based on Multisyringe Flow Injection Analysis (MSFIA) employing online hydride generation (HG) ICP-MS was developed. The fully automated analysis is performed in two steps: firstly, Sb(III) is quantified by ICP-MS after chemical vapor generation; then, total antimony is determined in the presence of potassium iodide as a pre-reducer of Sb(V) to Sb(III). The Sb(V) concentration is quantified by the difference between the total antimony and Sb(III) concentrations, reaching an analysis frequency of 30 h−1. The optimization was performed using a Box Behnken design. The MSFIA-HG-ICP-MS system allows the antimony speciation analysis with a detection limit of 0.016 µg L−1 for Sb(III), working in a linear range of 0.053 to 5.0 µg L−1. This method was applied for the determination of Sb(III) and Sb(V) in water samples from Maiorca Island, Spain, and the concentrations found varied from 0.10 to 0.14 µg L−1 for Sb(III) and from 0.12 to 0.28 µg L−1 for Sb(V). The results were validated by addition/recovery tests, obtaining recoveries between 90 and 111% in both cases. Furthermore, a good precision was achieved, 1.4% RSD, and sample and reagent consumption were reduced to a few mL, with the consequent decrease in waste generation. Thus, the proposed method is a good tool for the speciation of inorganic antimony at ultra-trace levels in waters, allowing its risk assessment.

Highly sensitive determination of trace antimony in water samples by cobalt ion enhanced photochemical vapor generation coupled with atomic fluorescence spectrometry or ICP-MS

A method for highly sensitive determination of trace antimony was proposed by using cobalt ion enhanced photochemical vapor generation (PCVG) for sample introduction into atomic fluorescence spectrometry (AFS) or inductively coupled plasma-mass spectrometry (ICP-MS) for elemental detection. During the PCVG process, the sample introduction efficiency of Sb could be significantly improved by addition of 5 mg L^-1 Co²⁺ in the mixed acid medium of 10% (v/v) formic acid and 20% (v/v) acetic acid, with a final 12-fold and 133-fold enhancement of AFS and ICP-MS intensity, respectively. The experimental conditions including enhancement ions, acid medium, UV irradiation, working gas as well as potential interference were investigated in detail. Under the optimal experimental conditions, the limit of detection (LOD) for Sb was 0.05 and 0.001 μg L^-1 by using AFS and ICP-MS determination, respectively. The method was successfully used for analysis of real water samples, with satisfactory recoveries of 92-94%.

On-line electrochemical preconcentration and electrochemical hydride generation for determination of antimony by high-resolution continuum source atomic absorption spectrometry

Trace concentrations of antimony in aquatic samples were determined by high resolution continuum-source atomic absorption spectrometry (HR-CS AAS) after electrochemical pre-concentration and electrochemical hydride generation. Antimony was electrochemically deposited in a microporous glassy carbon electrode as elemental antimony then was electrochemically converted at the same electrode surface to antimony hydride which was transported by argon gas to the quartz cuvette of the spectrometer. The detection limit and precision of the method are below 0.1 μg L^-1 and 3-5%, respectively. The method was employed for the determination of antimony in a CRM and water samples including surface, underground and waste water.