Safranin amplified carbon paste electrode sensor for analysis of paracetamol and epinephrine in presence of folic acid and ascorbic acid

A Biosensor for Simultaneous Detection of Epinephrine and Ascorbic Acid Based on Fe(III)-Polyhistidine-Functionalized Multi-Wall Carbon Nanotube Composites

Epinephrine (EP) is a very important chemical transmitter in the transmission of nerve impulses in the central nervous system of mammals. Ascorbic acid (AA) is considered to be the most important extracellular fluid antioxidant and has important antioxidant properties in the cell. In this study, a series of transition metal-polyhistidine-carboxylated multi-wall carbon nanotube nanocomposites were synthesized, and their simultaneous catalytic effects on epinephrine and ascorbic acid were investigated. The results showed that nanocomposites based on iron ions had the highest catalytic activity. The prepared biosensor expressed high selectivity toward EP and AA with LOD values of 0.1 μΜ (AA) and 0.01 μΜ (EP), and sensitivity values of 4.18 μA mM-1 with a range of 0.001-5 mM (AA), 50.98 μA mM-1 with a range of 0.2-100 μM (EP), and 265.75 μA mM-1 with a range of 0.1-1.0 mM (EP). Moreover, it showed good stability, good repeatability and high selectivity in real sample detection. This work is a reference for the design of new electrochemical enzyme-free biosensors and the detection of biomarkers.

Laccase-Conjugated Nanostructured ZnFe2O4/rGO-Modified Electrode-Based Interfaces for Electrochemical Impedance Monitoring of Adrenaline: A Promising Biosensor for Management of Neurodegenerative Disorders

A propitious biosensor for adrenaline (AD) detection in bovine serum albumin (BSA) real samples, which can be used for diagnosis and treatment of neurodegenerative disorders, is reported here. The biosensor consists of a La/ZF/rGO/ITO bioelectrode, which is fabricated by electrophoretic deposition of zinc ferrite/reduced graphene oxide (ZF/rGO) nanohybrid followed by drop casting of laccase (La) enzymes. The material characterization and electrochemical studies revealed that the ZF/rGO nanohybrid enhanced the electroactive surface and facilitated direct electron transfer between the electrode and electrolyte interface, resulting in enhanced electrocatalytic performance. The cyclic voltammetry and electrochemical impedance spectroscopy results asserted that the ZF/rGO nanohybrid decreased the charge-transfer resistance (Rct) and increased the surface adsorption, leading to a high diffusion coefficient (D) of 0.192 cm2/s. The biosensor exhibited a high sensitivity of 0.71 Ω/μM cm2, a good linear range (0.1 to 140 μM with R2 = 0.98), and a low limit of detection (LOD) is 12.5 μM, demonstrating the synergic effect of ZF and rGO in the La/ZF/rGO/ITO bioelectrode with AD. The biosensor also exhibited high selectivity and stability (55 days) in the presence of interfering substances and in BSA samples, with a recovery percentage close to 100 ± 5% RSD, indicating its potential biosensing applications for real-world applications in disease diagnostics, monitoring, and treatment.

Electrochemical Kinetics and Detection of Paracetamol by Stevensite-Modified Carbon Paste Electrode in Biological Fluids and Pharmaceutical Formulations

Paracetamol (PCT), or acetaminophen, is an important drug used worldwide for various clinical purposes. However, the excessive or indiscriminate use of PCT can provoke liver and kidney dysfunction; hence, it is essential to determine the amount of this target in biological samples. In this work, we develop a quick, simple, and sensitive voltammetric method using chemically modified electrodes to determine PCT in complex matrices, including human serum and commercial solid formulations. We modify the carbon paste electrode with stevensite monoclinic clay mineral (Stv-CPE), using cyclic voltammetry, differential pulse voltammetry, and electrochemical impedance spectroscopy to characterise and detect PCT. The kinetics study provides a better electrochemical characterisation of the electrode behaviour, finding the detection and quantitation limits of 0.2 μM and 0.5 μM under favourable conditions. Further, the best linear working concentration range is 0.6-100 μM for PCT, applying the proposed method to the quantitative determination of PCT content in reference tablet formulations and biological samples for validation.

A novel, extreme low-cost poly (Erythrosine) modified pencil graphite electrode for determination of Adrenaline

A simple, novel, and less cost yellow (Erythrosine) modified pencil graphite electrode (Po-ERY/MGPE) was successfully fabricated via electropolymerization method using cyclic voltammetric techniques. The fabricated Po-ERY/MGPE opted as a sensor for the detection of Adrenaline (ADR) in 0.2 M PBS (7.4 pH). This reported senor displayed excellent electrocatalytic activity, increased sensitivity, high stability, superior electron transfer kinetics in the oxidation of ADR once relative to BGPE. The significance of pH, scan rate, and impact of concentration was assessed at the sensor. As per the pH and scan rate study, redox routes carry the same number of electrons and protons, and electro-oxidation of ADR was adsorption controlled respectively. The LOD of ADR was found to be 0.499 µM. The DPV data indicate that there is a significant peak divergence among ADR and uric acid (UA) which could make it easier to determine them alone and simultaneously on the sensor. The described method has been employed for the determination of ADR in injection sample. Good recovery values indicate the efficacy and applicability of the sensor in detecting ADR.

Novel Self-assembly Pd(II)-Schiff Base Complex Modified Glassy Carbon Electrode for Electrochemical Detection of Paracetamol

A self-assembly Pd-Schiff base complex was synthesized and used as an electrochemical sensor in phosphate buffer solution, where it enhanced the electrocatalytic activity toward the paracetamol detection. The Schiff base {(HL) = (4-(((Z)-3-(hydroxyimino) butan-2-ylidene) amino)-1,5-dimethyl-2-phenyl-1,2-dihydro-3H-pyrazol-3-one)} was selected to prepare Pd-based complexes due to its high antimicrobial activity. A linear calibration curve was constructed using GC/Pd-SB in paracetamol concentration range of 1–50 μM and its detection limit was calculated as 0.067 μM. The modified electrode, GC/Pd-SB, could successfully determine the paracetamol concentration in human blood serum and commercial drug tablets with high sensitivity. The prepared metal complex was characterized using techniques, namely, X-ray diffraction (XRD) and scanning electron microscope (SEM). In addition, electrochemical studies were performed using different electrochemical techniques like cyclic voltammetry (CV), linear sweep voltammetry (LSV), chronoamperometry (CA), and electrochemical impedance spectroscopy (EIS). DFT calculations were used to estimate the equilibrium geometry, molecular orbital, ground-state properties, and interaction energy between paracetamol and palladium.

Graphical Abstract

Analytical Performance of Clay Paste Electrode and Graphene Paste Electrode-Comparative Study

The analytical performance of the clay paste electrode and graphene paste electrode was compared using square wave voltammetry (SWV) and cyclic voltammetry (CV). The comparison was made on the basis of a paracetamol (PA) determination on both working electrodes. The influence of pH and SWV parameters was investigated. The linear concentration ranges were found to be 6.0 × 10^-7-3.0 × 10^-5 and 2.0 × 10^-6-8.0 × 10^-5 mol L^-1 for clay paste electrode (ClPE) and graphene paste electrode (GrPE), respectively. The detection and quantification limits were calculated as 1.4 × 10^-7 and 4.7 ×10^-7 mol L^-1 for ClPE and 3.7 × 10^-7 and 1.2 × 10^-6 mol L^-1 for GrPE, respectively. Developed methods were successfully applied to pharmaceutical formulations analyses. Scanning electron microscopy and energy-dispersive X-ray spectroscopy were used to characterize ClPE and GrPE surfaces. Clay composition was examined with wavelength dispersive X-ray (WDXRF).

Single-Drop Analysis of Epinephrine and Uric Acid on a Screen-Printed Carbon Electrode

This work demonstrates the analysis of epinephrine (EP) and uric acid (UA) in a single drop (the volume of the test solution was only 50 µL) using a screen-printed carbon electrode (SPCE) sensor and square-wave voltammetry (SWV). The limit of detection, limit of quantification, linearity, accuracy, precision, and robustness were validated. The normality of the experimental data was tested and confirmed for both methods. Heteroscedasticity was checked by residual analysis followed by a statistical F-test. The latter was confirmed for both analytes. The low relative standard deviations (RSD) at all calibration points and repetitive slopes justified the use of a calibration curve; therefore, the standard addition methodology was avoided (the latter is common in electroanalysis, but time-consuming). Since the conditions for using an ordinary least squares (OLS) regression were not met, weighted linear regression (WLR) was used to improve the accuracy of the analytical results at low concentrations of the analytes. In this manner, the best weighted model was determined and used for the quantification. A comparison was made between the OLS and WLR methods to show the necessity of using the WLR method for EP and UA analysis. The newly developed and validated methods were also shown to be effective in the analysis of real samples. The content of EP in an EP auto-injector and UA in human urine was tested by employing the best weighted model. For EP and UA, the accuracy in terms of the average recovery value was 101.01% and 94.35%, and precision in terms of RSD was 5.65% and 2.75%, respectively. A new analytical methodology is presented that uses a low volume (a single drop), and it offers the advantage of electroanalysis for on-site analysis, where conventional chromatographic techniques cannot be easily employed. Furthermore, the developed technique has additional advantages in terms of speed, cost, and miniaturization.