A comparative run for visible-light-driven photocatalytic activity of anionic and cationic S-doped TiO2 photocatalysts: A case study of possible sulfur doping through chemical protocol

Research progress of TiO2-based photocatalytic degradation of wastewater: bibliometric analysis

The pollution caused by modernization and industrialization has caused serious harm to the biodiversity of the earth. TiO2-based photocatalyst has been widely studied as an effective and sustainable water environment remediation material. In this study, we analyzed the status and research trends of TiO2-based photocatalytic degradation of wastewater in depression from 2003 to 2023 to provide a reference for further research. "Doping", "Modification" and "Heterojunction" were used as keywords, and 817 related academic literatures were screened out by using Web of Science database. Through the visualization software VOSviewer and CiteSpace, the authors, institutions and literature keywords were clustered. The results show that since 2008, the annual number of published papers on TiO2-based photocatalytic degradation of wastewater has increased from 9 to 114. Among them, China has published 432 articles and made great contributions, and there are many representative research teams. Chinese universities are the main body to study TiO2-based photocatalytic degradation of wastewater, but the cooperation between universities is not as close as that abroad. This paper comprehensively analyzes the research hotspots of TiO2-based photocatalytic degradation of wastewater, such as the doping of TiO2 and the construction of different types of heterojunctions of TiO2. It is expected that these analysis results will provide new research ideas for researchers to carry out future research on related topics and let researchers know in-depth research institutions and possible collaborators to conduct academic exchanges and discussions with active institutions.

Synthesis and Application of Innovative and Environmentally Friendly Photocatalysts: A Review

Modern society faces two major challenges: removing pollutants from water and producing energy from renewable sources. To do this, science proposes innovative, low-cost, and environmentally friendly methods. The heterogeneous photocatalysis process fits perfectly in this scenario. In fact, with photocatalysis, it is possible both to mineralize contaminants that are not easily biodegradable and to produce hydrogen from the water splitting reaction or from the conversion of organic substances present in water. However, the main challenge in the field of heterogeneous photocatalysis is to produce low-cost and efficient photocatalysts active under visible light or sunlight. The objective of this review is to compare the new proposals for the synthesis of innovative photocatalysts that reflect the requirements of green chemistry, applied both in the removal of organic contaminants and in hydrogen production. From this comparison, we want to bring out the strengths and weaknesses of the proposals in the literature, but above all, new ideas to improve the efficiency of heterogeneous photocatalysis guaranteeing the principles of environmental and economic sustainability.

Effect of Calcination Conditions on the Properties and Photoactivity of TiO2 Modified with Biuret

A simple wet impregnation-calcination method was used to obtain a series of novel non-metal doped TiO2 photocatalysts. Biuret was applied as C and N source, while raw titanium dioxide derived from sulfate technology process was used as TiO2 and S source. The influence of the modification with biuret and the effect of the atmosphere (air or argon) and temperature (500–800 °C) of calcination on the physicochemical properties and photocatalytic activity of the photocatalysts towards ketoprofen decomposition under simulated solar light was investigated. Moreover, selected photocatalysts were applied for ketoprofen photodecomposition under visible and UV irradiation. Crucial features affecting the photocatalytic activity were the anatase to rutile phase ratio, anatase crystallites size and non-metals content. The obtained photocatalysts revealed improved activity in the photocatalytic ketoprofen decomposition compared to the crude TiO2. The best photoactivity under all irradiation types exhibited the photocatalyst calcined in the air atmosphere at 600 °C, composed of 96.4% of anatase with 23 nm crystallites, and containing 0.11 wt% of C, 0.05 wt% of N and 0.77 wt% of S.

Visible-Light Active Sulfur-Doped Titania Nanoparticles Immobilized on a Silica Matrix: Synthesis, Characterization and Photocatalytic Degradation of Pollutants

The photocatalytic oxidation (PCO) of pollutants using TiO2-based materials can significantly improve indoor air quality (IAQ), which in turn, has a significant impact on human health and life expectancy. TiO2-based nanoparticles (NPs) are widely used as part of building materials to function as photocatalysts in PCO. In this work, a series of sulfur-doped TiO2 NPs immobilized on a silica matrix were synthesized by combining a sol-gel process with ball milling. The samples were structurally characterized by X-ray diffraction (XRD), UV-Vis diffuse reflectance spectroscopy (DRS), Fourier-transform infrared spectroscopy (FT-IR) and N2 adsorption-desorption isotherms. Furthermore, the morphological characteristics were determined by dynamic light scattering (DLS), scanning electron microscopy (SEM) and transmission electron microscopy (TEM). The photocatalytic activity of the as prepared S-doped TiO2/SiO2 NPs in the degradation of liquid and air pollutants under visible-light irradiation was investigated. Our results show that sulfur is an effective dopant for activating TiO2/SiO2 photocatalysts under visible-light irradiation. Silica constitutes a "safe-by-design" approach and inhibits the aggregation of NPs during synthesis. The most efficient photocatalyst afforded 79% removal of methyl orange (5 h), 26% removal of acetaldehyde (1 h) and 12% oxidation of NO (1 h).

C-,N- and S-Doped TiO2 Photocatalysts: A Review

This article presents an overview of the reports on the doping of TiO2 with carbon, nitrogen, and sulfur, including single, co-, and tri-doping. A comparison of the properties of the photocatalysts synthesized from various precursors of TiO2 and C, N, or S dopants is summarized. Selected methods of synthesis of the non-metal doped TiO2 are also described. Furthermore, the influence of the preparation conditions on the doping mode (interstitial or substitutional) with reference to various types of the modified TiO2 is summarized. The mechanisms of photocatalysis for the different modes of the non-metal doping are also discussed. Moreover, selected applications of the non-metal doped TiO2 photocatalysts are shown, including the removal of organic compounds from water/wastewater, air purification, production of hydrogen, lithium storage, inactivation of bacteria, or carbon dioxide reduction.

Evolution of large area TiS2-TiO2 heterostructures and S-doped TiO2 nano-sheets on titanium foils

We report a novel and facile method to synthesize sulfur-doped titanium oxide sheets and realize TiS2-TiO2 heterostructures by means of a sequential sulfurization and oxidation step in a dual-zone chemical vapor deposition furnace. The inclusion of chlorine and argon gases during the growth of such titanium-based compounds plays a critical role in the formation of desired geometries and crystalline structures. These heterostructures possess nano-whisker and nanosheet configurations, controlled by adjusting the growth parameters such as temperature, carrier gas and the sequencing between different steps of the growth. The evolution of these complex heterostructures has been investigated using Raman spectroscopy and EDS characterization. The presence of chlorine gas during the growth results in local TiS2 formation as well as faceted growth of TiO2 nanosheets through anatase to rutile phase change prohibition. The electron microscopy (TEM) images and diffraction pattern (SAED) characterization reveal the crystallinity and layered nature of grown structures, further demonstrating the 2D characteristics of S-doped nanosheets. The evolution of TiO2 on TiS2 heterostructures has also has been verified using XPS analysis. These highly featured nanostructures are suitable candidates to enhance the photocatalytic behavior of TiO2 nanostructures.

Growth of W18O49/WOx/W dendritic nanostructures by one-step thermal evaporation and their high-performance photocatalytic activities in methyl orange degradation

A W₁₈O₄₉/WO_x/W dendritic nanostructure was fabricated via self-assembly and acted as an integrated system in the photocatalytic process of MO degradation.

Plasma-Induced Amorphous Shell and Deep Cation-Site S Doping Endow TiO2 with Extraordinary Sodium Storage Performance

Structural design and modification are effective approaches to regulate the physicochemical properties of TiO₂ , which play an important role in achieving advanced materials. Herein, a plasma-assisted method is reported to synthesize a surface-defect-rich and deep-cation-site-rich S doped rutile TiO₂ (R-TiO_2-x -S) as an advanced anode for the Na ion battery. An amorphous shell (≈3 nm) is induced by the Ar/H₂ plasma, which brings about the subsequent high S doping concentration (≈4.68 at%) and deep doping depth. Experimental results and density functional theory calculations demonstrate greatly facilitated ion diffusion, improved electronic conductivity, and an increased mobility rate of holes for R-TiO_2-x -S, which result in superior rate capability (264.8 and 128.5 mAh g^-1 at 50 and 10 000 mA g^-1 , respectively) and excellent cycling stability (almost 100% retention over 6500 cycles). Such improvements signify that plasma treatment offers an innovative and general approach toward designing advanced battery materials.

Development of Plasmonic Cu2O/Cu Composite Arrays as Visible- and Near-Infrared-Light-Driven Plasmonic Photocatalysts

We describe efficient visible- and near-infrared (vis/NIR) light-driven photocatalytic properties of hybrids of Cu₂O and plasmonic Cu arrays. The Cu₂O/Cu arrays were prepared simply by allowing a Cu half-shell array to stand in an oxygen atmosphere for 3 h, which was prepared by depositing Cu on two-dimensional colloidal crystals with a diameter of 543 or 224 nm. The localized surface plasmon resonances (LSPRs) of the arrays were strongly excited at 866 and 626 nm, respectively, at which the imaginary part of the dielectric function of Cu is small. The rate of photodegradation of methyl orange was 27 and 84 times faster, respectively, than that with a Cu₂O/nonplasmonic Cu plate. The photocatalytic activity was demonstrated to be dominated by Cu LSPR excitation. These results showed that the inexpensive Cu₂O/Cu arrays can be excellent vis/NIR-light-driven photocatalysts based on the efficient excitation of Cu LSPR.

Sulfur-doped CoFe2O4 nanopowders for enhanced visible-light photocatalytic activity and magnetic properties

Magnetic recovery S-CoFe₂O₄ nanopowders showed excellent visible photocatalytic degradation of oxytetracycline and recycling performances in aqueous solution.

Prospective aspects of preferential {001} facets of N,S-co-doped TiO2 photocatalysts for visible-light-responsive photocatalytic activity

In this report, we describe the synthesis of nitrogen and sulfur co-doped TiO₂ photocatalysts (NST) with preferential {001} facets by surfactant- and template-free OPM routes and crystallized through hydrothermal treatment.