Enhanced properties of low crystalline α-Fe2O3 nanoparticles synthesized via mechanical-ultrasonic activated precipitation as a green alternative to the conventional route: A comparative study

Porous α-Fe2O3 nanocarriers: Biosynthesis and in vitro gene delivery applications

Non-viral gene delivery is a new therapeutic in the treating genetic disorders. The most important challenge in nonviral gene transformation is the immunogenicity of carriers. Nowadays, The immunogenicity of nanocarriers as a deliverer of nucleic acid molecules has received significant attention. In this research, hematite green nanocarriers were prepared in one step with rosemary extract. Synthetic nanocarriers were investigated by using XRD (X-ray diffraction analysis), FESEM-EDX (field emission scanning electron microscopy with energy dispersive X-Ray spectroscopy), HR-TEM (high-resolution transmission electron microscopy), VSM (value stream mapping), TGA- DTG (thermal gravimetric analysis-differential thermal analysis), FT-IR (fourier-transform infrared spectroscopy), BET (brunauer-emmett-teller) and BJH (barrett-joyner-halenda) analyses. The cytotoxicity of synthetic nanocarriers was evaluated on HEK-293Tcell lines at concentration of 1-500 μg/ml using MTT method. Finally, targeted transfection of GFP plasmid using green porous particles was performed using an external magnetic field. Biogenic hematite nanoparticles with hexagonal crystal structures have a 3D pile flower-like morphology. The existence of rosemary phytochemicals in the construction of nanoparticles has caused minimal toxicity and high biocompatibility of nanocarriers. Also, TGA studies confirmed the stability of bionic nanoparticles. Superparamagnetic green nanocarriers at concentrations above 500 μg/ml is not toxic to HEK293T cells. The delivery efficiency of the plasmid was optimal at an N/P ratio of 3. Therefore, the porous α-Fe2O3 green nanocarriers are non-viral and safe carriers with potential applications in gene therapy.

Facile, Efficient, and Cheap Electrode based on SnO2/Activated Carbon Waste for Supercapacitor and Capacitive Deionization Applications

Activated carbon granules present in our household filters used in water purification are significant waste. Activated carbon waste (ACW) was ground to a fine powder, then impregnation of SnO2 on ACW was performed under mild conditions followed by calcination of SnO2-ACW at 700 °C for 2 h, producing a SnO2-ACW hybrid composite. This hybrid composite material was used in the preparation of electrodes for supercapacitor and capacitive deionization applications. The electrochemical performance of the electrodes was investigated by using cyclic voltammetry, galvanostatic charge-discharge, and electrochemical impedance spectroscopy. Calcination and addition of SnO2 contributed to an obtained electrode with a high specific capacitance of 30.46 F g-1 in a solution of 1 M Na2SO4 compared to the original ACW (0.122 F g-1) and calcined-ACW (1.42 F g-1) at an actual current of 1 mA. This electrode was also investigated for water desalination through the capacitive deionization technique and exhibited an electrosorption capacity of 6.44 mg/g compared to the commercial AC (8.9 mg/g) so it is a highly promising and economic electrode.