Comparison of two polythiophene nanocomposites-based dispersive micro solid-phase extraction procedures coupled with salt-induced/magnetic separations for efficient preconcentration of toxic metal ions from food samples

A fungal functionalized magnetized solid phase extractor for preconcentrations of Pb(II), Mn(II), and Co(II) from real samples

Due to increasing industrialization and overpopulation, the amount of toxic metals is increasing in the environment, including air, soil, water, and food. Solid phase extraction is an efficient and ideal technique to preconcentrate the toxic metals before their measurements by analytical instruments. Russula brevipes was immobilized on γ-Fe₂O₃ magnetic nanoparticles and employed as a SPE sorbent to preconcentrate the trace level of Pb(II), Mn(II), and Co(II). To investigate the extraction conditions, significant experimental parameters were examined in details. LODs were calculated as 0.022, 0.015, and 0.024 ng mL^-1 for Pb(II), Mn(II), and Co(II), respectively. The biosorption capacities of R. brevipes immobilized γ-Fe₂O₃ were calculated as 43.1 mg g^-1 for Pb(II), 54.9 mg g^-1 for Mn(II), and 49.7 mg g^-1 for Co(II). Pb(II), Mn(II), and Co(II) in food samples at trace levels were preconcentrated by applying the developed method.

Ultrasonic-assisted dispersive liquid-liquid microextraction based on hydrophilic deep eutectic solvents: Application to lead and cadmium monitoring in water and food samples

A green and innovative ultrasonic-assisted dispersive liquid-liquid microextraction using hydrophilic deep eutectic solvents (UA-HDES-DLLME) was developed for the selective and simultaneous extraction and enrichment of Pb (II) and Cd (II) in water and food samples for flame atomic absorption spectrometry. Several natural deep eutectic solvents (NADES) were used for the preparation of six different HDES and methyl violet was used as chelating reagent. Effective parameters such as pH, sonication time, methyl violet amount, DES type, dispersive solvent types, etc were optimized. Relative standard deviation (RSD) and preconcentration factor (PF) were 4.0% and 80. Low limits of detection (LOD, 1.3 ng mL^-1 for Pb (II) and 0.33 ng mL^-1 for Cd (II)) and quantification (LOQ, 4.0 ng mL^-1 for Pb (II) and 1.0 ng mL^-1 for Cd (II)) were found. The method accuracy was confirmed with analyses of certified reference materials.

Application of microcrystalline cellulose as an efficient and cheap sorbent for the extraction of metoprolol from plasma and wastewater before HPLC-MS/MS determination

A dispersive solid phase extraction method based on a new sorbent has been performed on plasma and wastewater samples to determine metoprolol by high performance liquid chromatography-tandem mass spectrometry. In this study, the analyte was adsorbed from the samples onto microcrystalline cellulose as a green and efficient sorbent and then eluted to use in the determination step. In the mass spectrometer, the analyte was detected in the positive mode and selectivity of the analysis was increased by sequential mass analysis through multiple reaction monitoring. All of the effective parameters in the extraction of metoprolol from plasma and wastewater were optimized. Under optimal conditions the method was linear in the ranges of 1-1000 and 0.1-1000 ng/mL in plasma and wastewater samples, respectively. The detection limit of the method was 0.30 and 0.03 ng/mL in plasma and wastewater samples, respectively. The data showed that the method provides low detection limit, wide linear range, good precision, and high extraction recovery. Finally several plasma and wastewater samples were successfully analyzed using the method. The use of small amount of a green and inexpensive sorbent and low volume of plasma without the need for further pretreatment steps are the main advantages of the method.