Investigation of smart water imbibition assisted with microwave radiation as a novel hybrid method of enhanced oil recovery

New molecular and macroscopic understandings of novel green chemicals based on Xanthan Gum and bio-surfactants for enhanced oil recovery

This research investigates the interactions between a novel environmentally friendly chemical fluid consisting of Xanthan gum and bio-based surfactants, and crude oil. The surfactants, derived from various leaves using the spray drying technique, were characterized using Fourier-transform infrared (FTIR) spectroscopy, zeta potential analysis, Dynamic light scattering, and evaluation of critical micelle concentration. Static emulsion tests were conducted to explore the emulsification between crude oil and the polymer-surfactant solution. Analysis of the bulk oil FTIR spectra revealed that saturated hydrocarbons and light aromatic hydrocarbons exhibited a higher tendency to adsorb onto the emulsion phase. Furthermore, the increased presence of polar hydrocarbons in emulsion phases generated by polar surfactants confirmed the activation of electrostatic forces in fluid-fluid interactions. Nuclear magnetic resonance spectroscopy showed that the xanthan solution without surfactants had a greater potential to adsorb asphaltenes with highly fused aromatic rings, while the presence of bio-based surfactants reduced the solution's ability to adsorb asphaltenes with larger cores. Microfluidic tests demonstrated that incorporating surfactants derived from Morus nigra and Aloevera leaves into the xanthan solution enhanced oil recovery. While injection of the xanthan solution resulted in a 49.8% recovery rate, the addition of Morus nigra and Aloevera leaf-derived surfactants to the xanthan solution increased oil recovery to 58.1% and 55.8%, respectively.

Utilization of synthesized silane-based silica Janus nanoparticles to improve foam stability applicable in oil production: static study

This study investigated the effect of silane-based silica (SiO2) Janus nanoparticles (JNPs) on stabilizing the foam generated by different types of gases. Two types of SiO2 JNPs were synthesized through surface modification using HMDS and APTS silane compounds. Static analyses were conducted to examine the impact of different concentrations of the synthesized nanoparticles in various atmospheres (air, CO2, and CH4) on surface tension, foamability, and foam stability. The results indicated that the synthesized SiO2 JNPs and bare SiO2 nanoparticles exhibited nearly the same ability to reduce surface tension at ambient temperature and pressure. Both of these nanoparticles reduced the surface tension from 71 to 58-59 mN m-1 at 15,000 ppm and 25 °C. While bare SiO2 nanoparticles exhibited no foamability, the synthesis of SiO2 JNPs significantly enhanced their ability to generate and stabilize gas foam. The foamability of HMDS-SiO2 JNPs started at a higher concentration than APTS-SiO2 JNPs (6000 ppm compared to 4000 ppm, respectively). The type of gas atmosphere played a crucial role in the efficiency of the synthesized JNPs. In a CH4 medium, the foamability of synthesized JNPs was superior to that in air and CO2. At a concentration of 1500 ppm in a CH4 medium, HMDS-SiO2 and APTS-SiO2 JNPs could stabilize the generated foam for 36 and 12 min, respectively. Due to the very low dissolution of CO2 gas in water at ambient pressure, the potential of synthesized JNPs decreased in this medium. Finally, it was found that HMDS-SiO2 JNPs exhibited better foamability and foam stability in all gas mediums compared to APTS-SiO2 JNPs for use in oil reservoirs. Also, the optimal performance of these JNPs was observed at a concentration of 15,000 ppm in a methane gas medium.