Behavior of mammalian cells on magnesium substituted bare and hydroxyapatite deposited (Ti,Mg)N coatings

Surface analysis of (Ti,Mg)N coated bone fixation devices following the rabbit femur surgery

BACKGROUND

Magnesium (Mg) enhances the bone regeneration, mineralization and attachment at the tissue/biomaterial interface.

OBJECTIVE

In this study, the effect of Mg on mineralization/osseointegration was determined using (Ti,Mg)N thin film coated Ti6Al4V based plates and screws in vivo.

METHODS

TiN and (Ti,Mg)N coated Ti6Al4V plates and screws were prepared using arc-PVD technique and used to fix rabbit femur fractures for 6 weeks. Then, mineralization/osseointegration was assessed by surface analysis including cell attachment, mineralization, and hydroxyapatite deposition on concave and convex sides of the plates along with the attachment between the screw and the bone.

RESULTS

According to Scanning Electron Microscopy (SEM) and Energy Dispersive Spectroscopy (EDS) analyses; cell attachment and mineralization were higher on the concave sides of the plates from both groups in comparison to the convex sides. However, mineralization was significantly higher on Mg-containing ones. The mean gray value indicating mineralized area after von Kossa staining was found as 0.48 ± 0.01 and 0.41 ± 0.04 on Mg containing and free ones respectively. Similarly, Fourier Transform Infrared Spectroscopy (FTIR) and X-ray diffraction (XRD) analyses showed that hydroxyapatite growth was abundant on the Mg-containing and concave sides of the plates. Enhanced mineralization and strong attachment to bone were also detected in EDS and SEM analyses of Mg-containing screws.

CONCLUSION

These findings indicated that (Ti,Mg)N coatings can be used to increase attachment at the implant tissue interface due to accelerated mineralization, cell attachment, and hydroxyapatite growth.

Biocompatibility and Immune Response of a Newly Developed Volume-Stable Magnesium-Based Barrier Membrane in Combination with a PVD Coating for Guided Bone Regeneration (GBR)

To date, there are no bioresorbable alternatives to non-resorbable and volume-stable membranes in the field of dentistry for guided bone or tissue regeneration (GBR/GTR). Even magnesium (Mg) has been shown to constitute a favorable biomaterial for the development of stabilizing structures. However, it has been described that it is necessary to prevent premature degradation to ensure both the functionality and the biocompatibility of such Mg implants. Different coating strategies have already been developed, but most of them did not provide the desired functionality. The present study analyses a new approach based on ion implantation (II) with PVD coating for the passivation of a newly developed Mg membrane for GBR/GTR procedures. To demonstrate comprehensive biocompatibility and successful passivation of the Mg membranes, untreated Mg (MG) and coated Mg (MG-Co) were investigated in vitro and in vivo. Thereby a collagen membrane with an already shown biocompatibility was used as control material. All investigations were performed according to EN ISO 10993 regulations. The in vitro results showed that both the untreated and PVD-coated membranes were not cytocompatible. However, both membrane types fulfilled the requirements for in vivo biocompatibility. Interestingly, the PVD coating did not have an influence on the gas cavity formation compared to the uncoated membrane, but it induced lower numbers of anti-inflammatory macrophages in comparison to the pure Mg membrane and the collagen membrane. In contrast, the pure Mg membrane provoked an immune response that was fully comparable to the collagen membrane. Altogether, this study shows that pure magnesium membranes represent a promising alternative compared to the nonresorbable volume-stable materials for GBR/GTR therapy.

A functional coating to enhance antibacterial and bioactivity properties of titanium implants and its performance in vitro

Bacterial infections and lack of osseointegration may negatively affect the success of titanium (Ti) implants. In the present study, a functional coating composed of chitosan (CS) microspheres and nano hydroxyapatite (nHA) was prepared to obtain antimicrobial Ti implants with enhanced bioactivity. First, the chitosan microspheres were fixed to Ti surfaces activated by alkali and heat treatment, then nHA coatings were precipitated onto these surfaces. Ciprofloxacin was loaded into the microspheres using two different procedures; encapsulation and diffusion. Scanning electron microscopy micrographs of the modified Ti surfaces showed that the coating was successfully deposited onto the Ti surfaces and stable for 30 days in PBS. The drug was completely released from free microspheres loaded by encapsulation in 21 days whereas only 89% release was observed after immobilization. The burst release also decreased from ca. 55% to ca. 35%. The release was further reduced following the nHA precipitation. The modified Ti surfaces showed antimicrobial activity based on the bacterial time-kill assay using S. aureus, but the efficiency was affected by both nHA precipitation and drug loading strategy. Highest antimicrobial activity was seen in the samples without nHA layer, and when the drug was loaded by diffusion. Fourier transform infrared spectroscopy and X-ray diffraction analyses revealed that nHA on the surface enhanced HA growth in simulated body fluid for 3 weeks, showing increased osseointegration potential. Therefore, the proposed coating may be used to prevent Ti implant failure originated from bacterial infection and/or low bioactivity.

Assessment of bone healing using (Ti,Mg)N thin film coated plates and screws: Rabbit femur model

Magnesium (Mg) based implants such as plates and screws are often preferred to treat bone defects because of the positive effects of magnesium in bone growth and healing. Their low corrosion resistance, however, leads to fast degradation and consequently failure before healing was completed. Previously, we developed Mg doped titanium nitrate (TiN) thin film coatings to address these limitations and demonstrated that <10 at% Mg doping led to enhanced mineralization in vitro. In the present study, in vivo performance of (Ti,Mg)N coated Ti6Al4V based plates and screws were studied in the rabbit model. Bone fractures were formed on femurs of 16 rabbits and then fixed with either (Ti,Mg)N coated (n = 8) or standard TiN coated (n = 8) plates and screws. X-ray imaging and μCT analyses showed enhanced bone regeneration on fracture sites fixed with (Ti,Mg)N coated plates in comparison with the Mg free ones. Bone mineral density, bone volume, and callus volume were also found to be 11.4, 23.4, and 42.8% higher, respectively, in accordance with μCT results. Furthermore, while TiN coatings promoted only primary bone regeneration, (Ti,Mg)N led to secondary bone regeneration in 6 weeks. These results indicated that Mg presence in the coatings accelerated bone regeneration in the fracture site. (Ti,Mg)N coating can be used as a practical method to increase the efficiency of existing bone fixation devices of varying geometry.

Magnesium doping on TiN coatings affects mesenchymal stem cell differentiation and proliferation positively in a dose-dependent manner

BACKGROUND

In vitro evaluation of cell-surface interactions for hard tissue implants have mostly been done using osteoblasts. However, when an implant is placed in the body, mesenchymal stem cells (MSCs) play a major role in new bone formation. Therefore, using MSCs in cell-surface investigations may provide more reliable information on the prediction of in vivo behavior of implants.

OBJECTIVE

In this study, Mg doped TiN coatings ((Ti,Mg)N) were prepared and tested for their effect on MSC differentiation and mineralization.

METHODS

MSCs were isolated from rat bone marrow (rBMSCs) and seeded onto bare Ti, TiN and Mg containing (Ti,Mg)N surfaces. Cell proliferation, osteogenic differentiation (collagen type 1, alkaline phosphatase activity), calcium phosphate deposition (von Kossa staining, Scanning Electron Microscopy) analysis were conducted.

RESULTS

Differentiation towards osteoblast lineage was significantly improved with the increment in Mg presence. Collagen type I deposition, mineralization, and the ALP activity were higher on high Mg containing (>10 at% Mg) surfaces but differentiation of rBMSCs were found to be delayed.

CONCLUSIONS

Mg presence affected rBMSCs proliferation and differentiation positively in a dose-dependent manner. However, high Mg amounts delayed both proliferation and differentiation.