Modeling photoacoustic pressure generation in colloidal suspensions at different volume fractions based on a multi-scale approach

In Situ Photoacoustic Detection System for SO2 in High-Pressure SF6 Buffer Gas Using UV LED

Sulfur dioxide (SO₂) is a key indicator for fault diagnosis in sulfur hexafluoride (SF₆) gas-insulated equipment. In this work, an in situ photoacoustic detection system using an ultraviolet (UV) LED light as the excitation source was established to detect SO₂ in high-pressure SF₆ buffer gas. The selection of the SO₂ absorption band is discussed in detail in the UV spectral regions. Based on the result of the spectrum selection, a UV LED with a nominal wavelength of 285 nm and a bandwidth of 13 nm was selected. A photoacoustic cell, as well as a high-pressure sealed gas vessel containing it, were designed to match the output optical beam and to generate a PA signal in the high-pressure SF6 buffer gas. The performance of the proposed system was assessed in terms of linearity and detection limit. An SO₂ detection limit (1σ) of 0.17 ppm was achieved. Additionally, a correction method was supplied to solve PA signal derivation induced by pressure fluctuation. The method can reduce the derivation from about 5% to 1% in the confirmation experiment.

Influence of the temperature-dependent dielectric constant on the photoacoustic effect of gold nanospheres

Photoacoustic imaging techniques with gold nanoparticles as contrast agents have received a great deal of attention. The photoacoustic response of gold nanoparticles strongly depends on the far-field optical properties, which essentially depend on the dielectric constant of the material. The dielectric constant of gold not only varies with wavelength but is also affected by temperature. However, the effect of the temperature dependence of the dielectric constant on gold nanoparticles' photoacoustic response has not been fully investigated. In this work, the Drude-Lorentz model and Mie theory are used to calculate the dielectric constant and absorption efficiency of gold nanospheres in aqueous solution, respectively. Then, the finite element method is used to simulate the heat transfer process of gold nanospheres and surrounding water. Finally, the one-dimensional velocity-stress equation is solved by the finite-difference time-domain method to obtain the photoacoustic response of gold nanospheres. The results show that under the irradiation of a high-fluence nanosecond pulse laser, ignoring the temperature dependence of the dielectric constant will lead to large errors in the photothermal response and the nonlinear photoacoustic signals (it can even exceed 20% and 30%). The relative error of the photothermal and photoacoustic response caused by ignoring the temperature-dependent dielectric constant is determined from both the temperature dependence of absorption efficiency and the maximum temperature increase of gold nanospheres. This work provides a new perspective for the photothermal and photoacoustic effects of gold nanospheres, which is meaningful for the development of high-resolution photoacoustic detectors and nano/microscale temperature measurement techniques.