Red fluorescence of Interdental plaque for screening of gingival health

A scoping review of new technologies for dental plaque quantitation: Benefits and limitations

OBJECTIVES

To determine the validity and reliability of novel digitalized tools for dental plaque detection and explore the benefits and limitations connected to their use.

DATA

Reporting followed the Preferred Reporting Items for Systematic Reviews and Meta-Analyses (PRISMA) Extension for Scoping Reviews. All human clinical studies comparing dental plaque detection using digitalized systems against a standard reference were included.

SOURCES

PubMed and Scopus were screened from 01 January 2013 to 28 September 2023. Bibliographies of primary studies and principal peer-reviewed scientific journals were manually searched.

STUDY SELECTION

The initial search identified 576 articles, with a total of 13 included in the review, published between 2015 and 2023. Most of the studies included (77 %) were cross-sectional with three being prospective. Digital devices captured 2D and 3D images via cameras and intra-oral scanners, respectively. The Turesky's modified plaque index was the most frequent clinical index. Correlation with clinical examination was moderate to strong, with good to excellent intra- and inter-system agreement.

CONCLUSIONS

Within the limitations of this scoping review, image analysis-based plaque detection systems demonstrated good correlations with clinical plaque indices, using both 2D and 3D imaging systems. Whilst digital plaque detection devices offer advantages in terms of procedural standardization and reproducibility, they also have limitations, therefore currently, their application should be underpinned by a comprehensive clinical examination.

CLINICAL SIGNIFICANCE

Digital plaque detection tools, that provide standardized measurements and store acquired images, facilitate more informed feedback to patients. This objective analysis may enhance clinician confidence in their utility for clinical trials and other applications.

A comprehensive review on LED-induced fluorescence in diagnostic pathology

Sensitivity, specificity, mobility, and affordability are important criteria to consider for developing diagnostic instruments in common use. Fluorescence spectroscopy has been demonstrating substantial potential in the clinical diagnosis of diseases and evaluating the underlying causes of pathogenesis. A higher degree of device integration with appropriate sensitivity and reasonable cost would further boost the value of the fluorescence techniques in clinical diagnosis and aid in the reduction of healthcare expenses, which is a key economic concern in emerging markets. Light-emitting diodes (LEDs), which are inexpensive and smaller are attractive alternatives to conventional excitation sources in fluorescence spectroscopy, are gaining a lot of momentum in the development of affordable, compact analytical instruments of clinical relevance. The commercial availability of a broad range of LED wavelengths (255-4600 nm) has opened up new avenues for targeting a wide range of clinically significant molecules (both endogenous and exogenous), thereby diagnosing a range of clinical illnesses. As a result, we have specifically examined the uses of LED-induced fluorescence (LED-IF) in preclinical and clinical evaluations of pathological conditions, considering the present advancements in the field.

Evaluation of wound dehiscence after vertical bone graft by using quantitative light-induced fluorescence

Wound dehiscence is a common complication following vertical bone augmentation of implant dentistry. If the implanted titanium mesh becomes exposed, the exposed titanium mesh should be removed with the contaminated grafts before a clinical graft infection develops. However, no generally accepted evaluation methods have been suggested to determine the removal timing or the extent of contaminated bone grafts to be removed. Quantitative light-induced fluorescence (QLF) technology has been used for various oral bacterial condition such as dental caries, plaque, peri-implantitis, and osteomyelitis. This paper reports two patients with wound dehiscence within the third week after vertical bone augmentation with autogenous particulate bone on the posterior maxilla. With conservative treatment, a QLF technology was applied to determine whether to remove the mesh. The exposed mesh of the first patient was removed when red-fluorescence was observed the red fluorescence by QLF. However, the other case did not show red fluorescence during the fifth week after dehiscence, and secondary healing was achieved without complications. The remaining bone grafts were well integrated into the sound cortico-cancellous complex sufficient to support the dental implant. Based on these clinical, radiological, and histological results, we discussed the rationale of QLF application on wound dehiscence after the bone graft in implant dentistry.

Quantitative light-induced fluorescence as a potential tool for detection of enamel chemical composition

BACKGROUND

Little is known about how the chemical composition of enamel affects the optical properties of teeth, but advances in technology allow this to be studied using white-light and fluorescent images. This study aimed to identify the variation in enamel chemical composition that may affect tooth optical properties, such as tooth color and autofluorescence.

METHODS

Sixty-one specimens of extracted human molars were prepared. Raman spectrometry was used to assess chemical composition of enamel, and tooth color, and autofluorescence from enamel were evaluated by quantitative light-induced fluorescence (QLF) images. Pearson correlation and multiple linear regression analyses were used.

RESULTS

Enamel fluorescence was related to enamel composition rather than tooth color. The b* value from the fluorescence image had a moderate correlation with crystallinity (full-width at half-maximum: r = -0.433, p < 0.001) and laser-induced fluorescence intensity (r = 0.450, p < 0.001) from Raman spectroscopy. In multiple linear regression analysis, the chemical composition of the tooth had a significant effect on the b* value from the fluorescent image (R² = 0.433, p < 0.001). In contrast, tooth color values (L*, a*, and b*) were not correlated with chemical composition.

CONCLUSIONS

The present study revealed that enamel autofluorescence in QLF was related to chemical composition of the enamel, particularly the inorganic‒organic interface. While enamel chemical composition can be detected only in a laboratory environment, enamel fluorescence by QLF may enable estimation in a dental clinic, which has implications for the field of tooth bleaching or esthetic restorative materials.